Multipassage three-dimensional Navier-Stokes simulation of turbine rotor-stator interaction
Explore the source record for details and available documents.
Madavan, N. K.↗
Engineering topics
Gavali, S.
Publications and source records attributed to Gavali, S..
Navier-Stokes Simulation Of Wind-Tunnel Flow
Report describes three-dimensional Navier-Stokes simulation of transonic flow past model wing in wind tunnel and in free air. Numerical integration performed by LU-ADI factorization algorithm. Simulation shows effects of walls of tunnel.
Obayashi, S.↗
A multi-passage three-dimensional Navier-Stokes simulation of turbine rotor-stator interaction
This paper deals with the development and validation of a 3D multipassage Navier-Stokes code for predicting the unsteady effects due to rotor-stator interaction in turbomachines. Prior work in two dimensions has demonstrated the necessity of including multiple rotor and stator passages in order to closely approximate the stator-to-rotor airfoil count ratio and thus accurately predict the unsteady flowfield resulting from rotor-stator interaction. In the present paper, this multipassage capability is extended to three dimensions. Numerical results obtained from a multipassage (three stator and four rotor passage) calculation of an axial turbine stage are presented. The stator-to-rotor airfoil count ratio (3:4) used in the present calculations is a close approximation to that in the actual turbine configuration (22:28). The present multipassage calculation results in a more accurate prediction of the unsteady flowfield than that possible from a single-passage calculation.
Madavan, N. K.↗
Grid refinement studies of turbine rotor-stator interaction
Results from a three-dimensional, time-accurate Navier-Stokes simulation of rotor-stator interaction in an axial turbine stage are presented. The present study uses a fine grid in the spanwise direction to better resolve endwall and tip cllearance effects and complements coarse-grid calculations that were reported earlier. A realistic turbine stage with 22 stator vanes and 28 rotor blades is simulated as a single-stator, single-rotor airfoil combination with the stator geometry modified to properly account for blockage effects. This is in contrast to the earlier coarse-grid calculations where the rotor geometry was modified. The improved grid resolution and the unmodified rotor geometry result in a more accurate simulation of the flow field, particularly in the rotor channel where the interaction effects are more severe. The numerical results are compared to experimental data wherever possible and to earlier calculations.
Madavan, N. K.↗
Evaluation of Navier-Stokes and Euler solutions for leading-edge separation vortices
Extensive study on the numerical simulation of the vortical flow over a double delta wing is carried out using the thin layer Navier-Stokes and Euler equations. Two important flow characteristics, vortex interaction and vortex breakdown, are successfully simulated. Grid resolution is one of the most important factors associated with the vortex problem. Computations were performed on a series of grids with various levels of refinement, coarse, medium, and fine. Computations using either the coarse or medium grids fail to capture the proper physical phenomena. The computed result using a fine grid shows flow unsteadiness once the vortex breakdown takes place. The C sub L - alpha characteristics are well predicted up to the breakdown angle of attack for all the grid distributions. The Euler solutions show fairly good agreement with the experiment on the C sub L - alpha characteristics. However, other aspects of the solution at each angle of attack, such as the locus of the leading edge separation vortex, are not consistent with the experiment. Even for the fine grid Navier-Stokes computations, further grid resolution is required to obtain good quantitative agreement with the experiment.
Fujii, K.↗
Evaluation of Navier-Stokes and Euler solutions for leading-edge separation vortices
Extensive study on the numerical simulation of the vortical flow over a double delta wing is carried out using the thin layer Navier-Stokes and Euler equations. Two important flow characteristics, vortex interaction and vortex breakdown, are successfully simulated. Grid resolution is one of the most important factors associated with the vortex problem. Computations were performed on a series of grids with various levels of refinement, coarse, medium, and fine. Computations using either the coarse or medium grids fail to capture the proper physical phenomena. The computed result using a fine grid shows flow unsteadiness once the vortex breakdown takes place. The C sub L - alpha characteristics are well predicted up to the breakdown angle of attack for all the grid distributions. The Euler solutions show fairly good agreement with the experiment on the C sub L - alpha characteristics. However, other aspects of the solution at each angle of attack, such as the locus of the leading edge separation vortex, are not consistent with the experiment. Even for the fine grid Navier-Stokes computations, further grid resolution is required to obtain good quantitative agreement with the experiment.
Fujii, K.↗