Search NASA⌕ Search

Engineering topics

George F Switzer

Publications and source records attributed to George F Switzer.

High Ice Water Content Associated with a Darwin, Austrailia, Mesoscale Convective System

A mesoscale convective complex that occurred during the 2014 Darwin, Australia, flight campaign is examined via a three-dimensional, numerical simulation. The focus of the study is to better understand the presence and development of High Ice Water Content (HIWC) that was observed in the actual storm. Although peak values of ice water content may occur early in the storm lifetime, large areas of high concentrations expand with time and persist even when the storm tops begin to warm. The storm canopy which contains HIWC, has low radar reflectivity factor and is fed by an ensemble of regenerating thermal plumes. Detection via weather radar of the aviation hazard associated HIWC is challenging due the low values of radar reflectivity factor.

Aviation hazards↗

High Ice Water Content in Tropical Cyclones during NASA/FAA Radar Flight Campaigns with Comparison to Numerical Simulations

Results from two recent flight campaigns into High Ice Water Content (HIWC) are summarized. HIWC was detected with airborne radar and measured via microphysical probes mounted on NASA’s DC-8. Results from the campaign demonstrate detectability of HIWC using airborne radar. In the cases examined, tropical storms are more proficient at producing large areas of HIWC than hurricanes. Three-dimensional, numerical simulations of tropical cyclones encountered during the campaign are also presented and are compared to measurements in order to understand conditions associated with HIWC. Within Hurricane Lane (2018), the highest ice water contents were found in regenerating thermal plumes located in the eye wall and in feeder bands. Within Tropical Storm Danny (2015), large areas of ice water content greater than 1 g m-3 were fed by broad-areas of convection occurring downwind from the center of circulation.

Aviation hazards↗

A Method for Correlating Forward-Looking Remote Sensor Measurements with In-Situ Measurements on Flying Platforms

A method is described for correlating measurements from a forward looking remote sensor with measurements made by in-situ instruments installed on the same flying platform. This method assumes that remote measurements are made within a volume of space in advance of the aircraft and that in-situ measurements provide representative values for discrete segments along the flight path. This correlation method can be applied to multiple sensors and makes no assumptions about the type of remote sensor or in-situ instrument, nor what either measures. It may be applied to recorded data during post-flight analysis based on known 4-D location (geospacial position and time) measurements.

Justin K. Strickland↗