Search NASA⌕ Search

Engineering topics

Ghosh, A.

Publications and source records attributed to Ghosh, A..

At least 73 records · Page 4

Influence of Ni substitution on structural and magnetic properties of Zn{sub 0.85−x}Ni{sub x}Mg{sub 0.05}Cu{sub 0.1}Fe{sub 2}O{sub 4} ferrite

Nano-crystalline Zn{sub 0.85−x}Ni{sub x}Mg{sub 0.05}Cu{sub 0.1}Fe{sub 2}O{sub 4}, (x = 0.0, 0.17, 0.34, 0.51, 0.68 and, 0.85), were synthesized by sol gel auto combustion method and, effect of Ni content on structural and magnetic properties is studied by x-ray diffraction (XRD) and, magnetic measurements. XRD confirms the formation of single phase spinel ferrite, with Scherrer's grain diameter ranging between 18.95 nm to 33.85 nm. Experimental and theoretical lattice parameter values suggest that the estimated cation distribution is close to the real distribution. Change in Ni-content leads to variation in cation distribution at site A, B and, migration of Cu{sup 2+} ion from B to A site. Ni{sup 2+} ion remains at both A and B site, but when Zn is fully replaced by Ni, it totally goes to A site. Coercivity and anisotropy constant values respectively ranges' between 251.2 to 372.4 Oe and 0.06 × 10{sup 5} to 0.80 × 10{sup 5} erg/cc. Best magnetization value of 43.7 emu/g was obtained for × = 0.68. Variation of magnetic properties can be understood in terms of observed changes in cation distribution.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Plasma density accumulation on a conical surface for diffusion along a diverging magnetic field

Two-dimensional (2-D) density and potential measurements have been carried out for plasma diffusing through an aperture in a diverging magnetic field. The radial density profile near the source is peaked on the axis but gradually evolves into a hollow profile away from the source. We observe a slow increase of the peak density along a hollow conical surface and correlate with the 2-D potential measurement reported earlier. It is also shown that the formation of 2-D structures with similar features are observed whenever plasma is allowed to diffuse through a physical aperture in such diverging magnetic field configuration, with or without the presence of electric double layer, i.e., the phenomenon is generic in nature.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Ancient Aqueous Environments at Endeavour Crater, Mars

Opportunity has investigated in detail rocks on the rim of the Noachian age Endeavour crater, where orbital spectral reflectance signatures indicate the presence of Fe(+3)-rich smectites. The signatures are associated with fine-grained, layered rocks containing spherules of diagenetic or impact origin. The layered rocks are overlain by breccias, and both units are cut by calcium sulfate veins precipitated from fluids that circulated after the Endeavour impact. Compositional data for fractures in the layered rocks suggest formation of Al-rich smectites by aqueous leaching. Evidence is thus preserved for water-rock interactions before and after the impact, with aqueous environments of slightly acidic to circum-neutral pH that would have been more favorable for prebiotic chemistry and microorganisms than those recorded by younger sulfate-rich rocks at Meridiani Planum.

Research Support, U.S. Gov't, Non-P.H.S.↗

Penetration depth and absorption mechanisms of spin currents in Ir{sub 20}Mn{sub 80} and Fe{sub 50}Mn{sub 50} polycrystalline films by ferromagnetic resonance and spin pumping

Spintronics relies on the spin dependent transport properties of ferromagnets (Fs). Although antiferromagnets (AFs) are used for their magnetic properties only, some fundamental F-spintronics phenomena like spin transfer torque, domain wall motion, and tunnel anisotropic magnetoresistance also occur with AFs, thus making AF-spintronics attractive. Here, room temperature critical depths and absorption mechanisms of spin currents in Ir{sub 20}Mn{sub 80} and Fe{sub 50}Mn{sub 50} are determined by F-resonance and spin pumping. In particular, we find room temperature critical depths originating from different absorption mechanisms: dephasing for Ir{sub 20}Mn{sub 80} and spin flipping for Fe{sub 50}Mn{sub 50}.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Test of Optimized 120-mm LARP Nb 3 Sn Quadrupole Coil Using Magnetic Mirror Structure

The U.S. Large Hadron Collider accelerator research program is developing a new generation of large-aperture high-field quadrupoles based on Nb 3 Sn conductor for the high-luminosity upgrade of the Large Hadron Collider. Tests of the first series of 120-mm-aperture high-gradient quadrupole (HQ) coils revealed the necessity for further optimization of the coil design and fabrication process. Modifications in coil design were gradually implemented in two HQ coils previously tested at Fermi National Accelerator Laboratory using a magnetic mirror structure (HQM01 and HQM02). This paper describes the construction and test of an HQ mirror model with a coil of optimized design and with an interlayer resistive core in the conductor. The cable for this coil was made of a smaller diameter strand, providing more room for coil expansion during reaction. The 0.8-mm strand, used in all previous HQ coils, was replaced with a 0.778-mm Nb 3 Sn strand of RRP 108/127 subelement design. The coil was instrumented with voltage taps, heaters, and strain gauges to monitor mechanical and thermal properties and quench performance of the coil

43 PARTICLE ACCELERATORS↗

Summary of HQ01e magnetic measurements

The magnetic measurements of HQ01e, a 1 m long LHC Accelerator Research Program (LARP) high-gradient quadrupole model, were performed at 4.4 K and above 40 K at the magnet test facility of LBNL in July 2011. The 120 mm aperture cos2 θ Nb 3 Sn magnet was designed with accelerator magnet features including alignment and field quality. Conductor-limited gradient was 195 T/m at 4.4 K. During the measurement, a ramp rate of 10 A/s was used and measurements at the nominal current of 14.2 kA (82% of short-sample limit with a gradient of 160 T/m) were performed using the 250 mm long printed-circuit board rotating probe developed by FNAL. At 14.2 kA, 2.7 units of b 6 and 0.7 units of b 10 were measured. Large persistent current contribution and strong dynamic effects were observed.

43 PARTICLE ACCELERATORS↗

Progress in the Long ${\rm Nb}_{3}{\rm Sn}$ Quadrupole R&D by LARP

After the successful test of the first long Nb 3 Sn quadrupole (LQS01) the US LHC Accelerator Research Program (LARP, a collaboration of BNL, FNAL, LBNL and SLAC) is assessing training memory, reproducibility, and other accelerator quality features of long Nb 3 Sn quadrupole magnets. LQS01b (a reassembly of LQS01 with more uniform and higher pre-stress) was subjected to a full thermal cycle and reached the previous plateau of 222 T/m at 4.5 K in two quenches. A new set of four coils, made of the same type of conductor used in LQS01 (RRP 54/61 by Oxford Superconducting Technology), was assembled in the LQS01 structure and tested at 4.5 K and lower temperatures. The new magnet (LQS02) reached the target gradient (200 T/m) only at 2.6 K and lower temperatures, at intermediate ramp rates. The preliminary test analysis, here reported, showed a higher instability in the limiting coil than in the other coils of LQS01 and LQS02.

43 PARTICLE ACCELERATORS↗