Search NASA⌕ Search

Engineering topics

Giacomoni, Clothilde

Publications and source records attributed to Giacomoni, Clothilde.

8 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2016

Impact of Drift on the Vehicle Liftoff Acoustic Environments

As a launch vehicle lifts off the pad, depending on the flyaway maneuver, it will drift away from the exhaust hole causing the plume(s) to impinge on the launch deck. This impingement on the deck creates acoustic sources and causes the noise levels on the vehicle to increase. The percentage of the plume which impinges on the deck can be calculated and related to sound pressure levels. Using this information, a delta dB can be calculated if the drift or flyaway maneuver for a specific vehicle changes during a program

Kenny, Jeremy↗
NASA NTRS2016

Impact of Drift on the Vehicle Liftoff Acoustic Environments

During liftoff a vehicle can drift due to wind, nozzle gimbaling, fly away maneuver, etc... This drift can cause the exhaust plumes to impinge on the deck and cause the noise levels experienced by the vehicle to increase. A small increase in the plume impingement can have a dramatic effect on the noise levels when the vehicle is only a few nozzle diameters from the deck. As the vehicle lifts off the deck the increase in noise levels lessens as the plume impingement increases. Several scale model acoustic tests have been undertaken at Marshall Space Flight Center which had test cases that were used to define the relationship between drift and the noise levels experienced by the vehicle.

Kenny, Jeremy↗
NASA NTRS2016

Comparison of Spatial Correlation Parameters between Full and Model Scale Launch Vehicles

The current vibro-acoustic analysis tools require specific spatial correlation parameters as input to define the liftoff acoustic environment experienced by the launch vehicle. Until recently these parameters have not been very well defined. A comprehensive set of spatial correlation data were obtained during a scale model acoustic test conducted in 2014. From these spatial correlation data, several parameters were calculated: the decay coefficient, the diffuse to propagating ratio, and the angle of incidence. Spatial correlation data were also collected on the EFT-1 flight of the Delta IV vehicle which launched on December 5th, 2014. A comparison of the spatial correlation parameters from full scale and model scale data will be presented.

Kenny, Jeremy↗
NASA NTRS2015

SLS Scale Model Acoustic Test Liftoff Results and Comparisons

The liftoff phase induces acoustic loading over a broad frequency range for a launch vehicle. These external acoustic environments are then used in the prediction of internal vibration responses of the vehicle and components which result in the qualification levels. Thus, predicting these liftoff acoustic (LOA) environments is critical to the design requirements of any launch vehicle. If there is a significant amount of uncertainty in the predictions or if acoustic mitigation options must be implemented, a subscale acoustic test is a feasible design phase test option to verify the LOA environments. The NASA Space Launch System (SLS) program initiated the Scale Model Acoustic Test (SMAT) to verify the predicted SLS LOA environments.

Houston, Janice↗
NASA NTRS2014

Prediction of Acoustic Environments from Horizontal Rocket Firings

In recent years, advances in research and engineering have led to more powerful launch vehicles which yield acoustic environments potentially destructive to the vehicle or surrounding structures. Therefore, it has become increasingly important to be able to predict the acoustic environments created by these vehicles in order to avoid structural and/or component failure. The current industry standard technique for predicting launch-induced acoustic environments was developed by Eldred in the early 1970's. Recent work has shown Eldred's technique to be inaccurate for current state-of-the-art launch vehicles. Due to the high cost of full-scale and even sub-scale rocket experiments, very little rocket noise data is available. Much of the work thought to be applicable to rocket noise has been done with heated jets. A model to predict the acoustic environment due to a launch vehicle in the far-field was created. This was done using five sets of horizontally fired rocket data, obtained between 2008 and 2012. Through scaling analysis, it is shown that liquid and solid rocket motors exhibit similar spectra at similar amplitudes. This model is accurate for these five data sets within 5 dB of the measured data.

Kenny, R. Jeremy↗
NASA NTRS2014

Prediction of Acoustic Environments from Horizontal Rocket Firings

In recent years, advances in research and engineering have led to more powerful launch vehicles which can reach areas of space not yet explored. These more powerful vehicles yield acoustic environments potentially destructive to the vehicle or surrounding structures. Therefore, it has become increasingly important to be able to predict the acoustic environments created by these vehicles in order to avoid structural and/or competent failure. The current industry standard technique for predicting launch-induced acoustic environments was developed by Eldred in the early 1970's and is published in NASA SP-80721. Recent work2 has shown Eldred's technique to be inaccurate for current state-of-the-art launch vehicles. Due to the high cost of full-scale and even sub-scale rocket experiments, very little rocket noise data is available. Furthermore, much of the work thought to be applicable to rocket noise has been done with heated jets. Tam3,4 has done an extensive amount of research on jets of different nozzle exit shape, diameter, velocity, and temperature. Though the values of these parameters, especially exit velocity and temperature, are often very low compared to these values in rockets, a lot can be learned about rocket noise from jet noise literature. The turbulent nature of jet and rocket exhausts is quite similar. Both exhausts contain turbulent structures of varying scale-termed the fine and large scale turbulence by Tam. The finescale turbulence is due to small eddies from the jet plume interacting with the ambient atmosphere. According to Tam et al., the noise radiated by this envelope of small-scale turbulence is statistically isotropic. Hence, one would expect the noise from the small scale turbulence of the jet to be nearly omni-directional. The coherent nature of the large-scale turbulence results in interference of the noise radiated from different spatial locations within the jet. This interference-whether it is constructive or destructive-results in highly directional noise radiation. Tam3 has proposed a model to predict the acoustic environment due to jets and while it works extremely well for jets, it was found to be inappropriate for rockets8. A model to predict the acoustic environment due to a launch vehicle in the far-field which incorporates concepts from both Eldred and Tam was created. This was done using five sets of horizontally fired rocket data, obtained between 2008 and 2012. Three of these rockets use solid propellant and two use liquid propellant. Through scaling analysis, it is shown that liquid and solid rocket motors exhibit similar spectra at similar amplitudes. This model is accurate for these five data sets within 5 dB of the measured data for receiver angles of 30deg to 160deg (with respect to the downstream exhaust centerline). The model uses the following vehicle parameters: nozzle exit diameter and velocity, radial distance from source to receiver, receiver angle, mass flow rate, and acoustic efficiency.

Giacomoni, Clothilde↗