Search NASA⌕ Search

Engineering topics

Giovannozzi, E

Publications and source records attributed to Giovannozzi, E.

Detection of dust on JET with the high resolution Thomson scattering system

Dust particles have been observed with Thomson scattering systems on several tokamaks. We present here the first evidence of dust particles observed by the new high resolution Thomson scattering system on JET. The system consists of filter spectrometers that analyze the Thomson scattering spectrum from 670 to 1050 nm in four spectral channels. The laser source is a 5 J Q-switched Nd:YAG laser. Without a spectral channel at the laser wavelength, only dust particles that emit broadband light could be detected; these particles have been observed on JET after disruptions. The timing of their emission is clearly different from that expected for a Thomson scattering pulse. The light pulse from dust happens after the peak of the laser light and has a long tail.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

A new calibration code for the JET polarimeter

An equivalent model of JET polarimeter is presented, which overcomes the drawbacks of previous versions of the fitting procedures used to provide calibrated results. First of all the signal processing electronics has been simulated, to confirm that it is still working within the original specifications. Then the effective optical path of both the vertical and lateral chords has been implemented to produce the calibration curves. The principle approach to the model has allowed obtaining a unique procedure which can be applied to any manual calibration and remains constant until the following one. The optical model of the chords is then applied to derive the plasma measurements. The results are in good agreement with the estimates of the most advanced full wave propagation code available and have been benchmarked with other diagnostics. The devised procedure has proved to work properly also for the most recent campaigns and high current experiments.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

Dust in FTU with the Thomson Scattering diagnostic

The Thomson scattering diagnostic has been used to measure the dust present in plasma discharges on FTU tokamak after disruption. The vaporization of the dust particles due to the high power of the laser used by the Thomson scattering diagnostic imply that only a rough estimate of the particle size could be derived from the elastic scattering of the laser light. A simple model for dust particle evaporation has been used to infer the size of the dust particle from the scattered light data.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Models comparison for JET polarimeter data

A complete comparison between the theory and the measurements in polarimetry was done by using the Far Infrared Polarimeter at JET. More than 300 shots were analyzed, including a wide spectrum of JET scenarios in all critical conditions for polarimetry: high density, high and very low fields, high temperatures.This work is aimed at the demonstration of the robustness of the theoretical models for the JET polarimeter measurements in the perspective of using these models for ITER like plasma scenarios . In this context, an assessment was performed on how the line-integrated plasma density along the central vertical chord of FIR polarimeter could be evaluated using the Cotton-Mouton effect and its possible concrete use to correct fringe jumps of the interferometer.The models considered are: i) the rigorous numerical solution of the Stokes propagation equations, using dielectric tensor evaluated from JET equilibrium and Thomson scattering [1,2]; ii) two types of approximated solutions [2,3] and iii) the Guenther empirical model [4] that considers the mutual effect between Cotton-Mouton and Faraday rotation angle. The model calculations have been compared with polarimeter measurements for the Cotton-Mouton phase shift.The agreement with theory is satisfactory within the limits of experimental errors [3].

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Dust Measurement With Thomson Scattering In FTU

The size distribution of dust particles present in FTU after disruptions has been evaluated in the range 0.05 {mu}m-0.1 {mu}m using the Thomson scattering system. Rayleigh approximation has been used to estimate the dust size. The distribution, although the radii considered do not differ more than an order of magnitude, behave like a power law. The laser energy density far exceed that necessary to vaporize, at least partially, the particles. This can affect the previous estimate of the particle sizes, and suggests that the effective radii might be larger than the estimated values. A preliminary analysis on the broad band signal is presented.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗