Engineering topics

Gittner, Nathan M.

Publications and source records attributed to Gittner, Nathan M..

3 records

NASA NTRS1992

The effects of nozzle exit geometry on forebody vortex control using blowing

An experimental study has been undertaken to examine the influence of the blowing jet geometry on the effectiveness of the aft blowing technique for forebody vortex control. The experiments were conducted with a 3.0 tangent caliber ogive model at subsonic, laminar flow conditions. Asymmetric aft blowing was accomplished using both a single nozzle and a double nozzle configuration. Detailed surface pressure measurements on the model were obtained. The experimental results show that the height and the width of the blowing jet are important parameters that determine the effectiveness of aft blowing; a broad, lowly positioned blowing jet is found to be most effective for the forebody vortex control technique using aft blowing.

Gittner, Nathan M.↗

NASA NTRS1992

An investigation of the effects of aft blowing on a 3.0 caliber tangent ogive body at high angles of attack

An experimental investigation of the effects of aft blowing on the asymmetric vortex flow of a slender, axisymmetric body at high angles of attack was conducted. A 3.0 caliber tangent ogive body fitted with a cylindrical afterbody was tested in a wind tunnel under subsonic, laminar flow test conditions. Asymmetric blowing from both a single nozzle and a double nozzle configuration, positioned near the body apex, was investigated. Aft blowing was observed to alter the vortex asymmetry by moving the blowing-side vortex closer to the body surface while moving the non-blowing-side vortex further away from the body. The effect of increasing the blowing coefficient was to move the blowing-side vortex closer to the body surface at a more upstream location. The data also showed that blowing was more effective in altering the initial vortex asymmetry at the higher angles of attack than at the lower. The effects of changing the nozzle exit geometry were investigated and it was observed that blowing from a nozzle with a low, broad exit geometry was more effective in reducing the vortex asymmetry than blowing from a high, narrow exit geometry.

Gittner, Nathan M.↗

NASA NTRS1991

An experimental study of the effects of aft blowing on a 3.0 caliber tangent ogive body at high angles of attack

An experimental study of the effects of aft blowing on the forebody vortex asymmetry over a 3.0 caliber tangent ogive body at high angles of attack was conducted. The tip of the ogive body was equipped with a single blowing nozzle whose position could be adjusted. The tests were conducted in a subsonic wind tunnel at laminar flow conditions. The effects of model roll, angle of attack, blowing coefficient, and blowing nozzle axial position were independently studied. Surface pressure measurements and flow visualization results were obtained. Aft blowing was observed to alleviate the degree of vortex asymmetry at all angles of attack. The blowing was found to be more effective at the higher angles of attack. However, proportional control of the degree of vortex asymmetry was not observed, because the initial flowfield was highly asymmetric.

Gittner, Nathan M.↗