Search NASA⌕ Search

Engineering topics

Goodwin, F. E.

Publications and source records attributed to Goodwin, F. E..

13 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1977

Opto-mechanical subsystem with temperature compensation through isothemal design

An opto-mechanical subsystem for supporting a laser structure which minimizes changes in the alignment of the laser optics in response to temperature variations is described. Both optical and mechanical structural components of the system are formed of the same material, preferably beryllium, which is selected for high mechanical strength and good thermal conducting qualities. All mechanical and optical components are mounted and assembled to provide thorough thermal coupling throughout the subsystem to prevent the development of temperature gradients.

Goodwin, F. E.↗
NASA NTRS1977

CO2 laser communication systems for near-earth space applications

Projections of the growth of earth-sensing systems for the latter half of the 1980's show a data-transmission requirement of 300 Mbit/s and above. The most efficient technique to return the data from a sensing satellite to a ground station is through a geosynchronous data relay satellite. A laser system is most attractive for the space-to-space link. A five-year program was conducted which has shown the basic technical feasibility of accomplishing this link with a CO2 laser system operating at a wavelength near 10 microns. The system uses a mercury-cadmium-telluride infrared mixer cooled to approximately 100 K by a radiative cooler. The laser local oscillator and coupling-modulated laser transmitter use conductively cooled beryllium oxide construction. The optical antenna for transmission and reception has a gain of nominally 92 dB with a 3-dB beamwidth of 80 microrad. Tracking jitter is less than ten microrad, and signal acquisition occurs in less than 1 min. The receiver subsystem has a sensitivity of 10 to the -19th power W/Hz, accommodates a 300-Mbit/s data rate, and can track Doppler frequency variations over a + or - 700-MHz range.

Mcelroy, J. H.↗
NASA NTRS1975

Spaceborne CO2 laser communications systems

Projections of the growth of earth-sensing systems for the latter half of the 1980's show a data transmission requirement of 300 Mbps and above. Mission constraints and objectives lead to the conclusion that the most efficient technique to return the data from the sensing satellite to a ground station is through a geosynchronous data relay satellite. Of the two links that are involved (sensing satellite to relay satellite and relay satellite to ground), a laser system is most attractive for the space-to-space link. The development of CO2 laser systems for space-to-space applications is discussed with the completion of a 300 Mpbs data relay receiver and its modification into a transceiver. The technology and state-of-the-art of such systems are described in detail.

Mcelroy, J. H.↗
NASA NTRS1975

Spaceborne CO2 laser communications systems

Projections of the growth of earth-sensing systems for the latter half of the 1980's show a data transmission requirement of 300 Mbps and above. Mission constraints and objectives lead to the conclusion that the most efficient technique to return the data from the sensing satellite to a ground station is through a geosynchronous data relay satellite. Of the two links that are involved (sensing satellite to relay satellite and relay satellite to ground), a laser system is most attractive for the space-to-space link. During 1975 a major step toward the development of CO2 laser systems for space-to-space applications is being completed. This step is the completion of a 300 Mbps data relay receiver and its modification into a transceiver. The technology and state-of-the-art of such systems are described in detail in this paper.

Mcelroy, J. H.↗
NASA NTRS1973

Laser space communication experiment: Modulator technology

Results are presented of a contractual program to develop the modulator technology necessary for a 10.6 micron laser communication system using cadmium telluride as the modulator material. The program consisted of the following tasks: (1) The growth of cadmium telluride crystals of sufficient size and purity and with the necessary optical properties for use as laser modulator rods. (2) Develop a low loss antireflection coating for the cadmium telluride rods. (3) Design and build a modulator capable of 300 MHz modulation. (4) Develop a modulator driver capable of a data rate of 300 MBits/sec, 12 W rms output power, and 40 percent efficiency. (5) Assemble and test the modulator system. All design goals were met and the system was built and tested.

Goodwin, F. E.↗
NASA NTRS1972

Modulation and detection of optical signals

A summary of information is presented which is related to the modulation and detection of information on optical carriers. It emphasizes the treatment of information transfer through an entire system. The most common configurations are considered: intensity modulation, amplitude modulation, frequency or phase modulation, and both direct and coherent detection. In assessing these configurations information capacity and message signal-to-noise ratio are used as a basis of comparison. The physical and geometric treatment of optical heterodyne (or coherent) detection is given.

Goodwin, F. E.↗
NASA NTRS1972

Intracavity CdTe modulators for CO2 lasers.

The use of cadmium telluride as an electrooptic material for intracavity modulation of CO2 lasers is described. Included are the predicted and measured effects of CdTe intracavity modulators on laser performance. Coupling and frequency modulation are discussed and experimental results compared with theoretically predicted performance for both techniques. Limitations on the frequency response of the two types of modulation are determined.

Kiefer, J. E.↗
NASA NTRS1972

Wide-band laser communications in space.

Candidate wideband (1 Gbit/sec) satellite laser communications systems are compared with respect to projected component technology and launch cost. It appears that the carbon dioxide (10.6-micron) system offers a SNR advantage over the Nd:YAG (1.06-micron) or doubled Nd:YAG (0.53-micron) systems for comparable satellite burden. The launch costs for the carbon dioxide and doubled Nd:YAG systems can be similar, but the latter is very sensitive to the projected weight of a large lightweight photon-bucket receiving aperture. The most critical technology problem for the carbon dioxide system is that of Doppler compensation.

Forster, D. C.↗