Engineering topics

Gowdey, J. C.

Publications and source records attributed to Gowdey, J. C..

3 records

NASA NTRS1983

IPACS Electronics: Comments on the Original Design and Current Efforts at Langley Research Center

The development of the integrated power altitude control system (IPACS) is described. The power bridge was fabricated, and all major parts are in hand. The bridge was tested with a 1/4 HP motor for another program. The PWM, Control Logic, and upper bridge driver power supply are breadboarded and are debugged prior to starting testing on a passive load. The Hall sensor circuit for detecting rotor position is in design.

Gowdey, J. C.↗

NASA NTRS1982

Response control for fatigue testing of non-linear systems

A signal conditioner which ensures that peak and low values during vibration testing are not lost during nonlinear or asymmetric vibration testing on small structures is described. The trapped signals may be for acceleration, velocity, or displacement. The test signal is sent through an analog circuit to a multiplexer, which resets to zero each time a zero-line is crossed by another incoming signal. Peak positive and negative amplitude and frequency are retained and nonsymmetric responses are thus detected, rather than averaged out.

Gowdey, J. C.↗

NASA NTRS1981

Mission load dynamic tests of two undensified Space shuttle thermal protection system tiles

Two tests of undensified Space Shuttle thermal protection tiles under combined static and dynamic loads were conducted. The tiles had a density of approximately 144 Kg/cum (LI900 tiles) and were mounted on a strain isolation pad which was 0.41 cm (.160 inch) thick. A combined static and dynamic mission stress histogram representative of the W-3 area of the wing of the orbiter vehicle was applied. The stress histogram was provided by the space shuttle project. Results presented include: tabulation of measured peak and root-mean-square (RMS) accelerations in both compression and tension; peak SIP stress in compression and tension, peak and RMS amplitude response ratios; lateral to vertical response ratios; response time histories; peak stress distributions (histograms), and SIP extension measured both with and without static tension at various mission times.

Leatherwood, J. D.↗