Engineering topics

Graham, D. R.

Publications and source records attributed to Graham, D. R..

3 records

NASA NTRS1989

Helicopter hub fairing and pylon interference drag

A wind tunnel test was conducted to study the aerodynamics of helicopter hub and pylon fairings. The test was conducted in the 7-by 10 Foot Subsonic Wind Tunnel (Number 2) at Ames Research Center using a 1/5-scale XH-59A fuselage model. The primary focus of the test was on the rotor hub fairing and pylon mutual interference drag. Parametric studies of pylon and hub fairing geometry were also conducted. This report presents the major findings of the test as well as tabulated force and moment data, flow visualization photographs, and graphical presentations of the drag data. The test results indicate that substantial drag reduction can be attained through the use of a cambered hub fairing with circular arc upper surface and flat lower surface. Furthermore, a considerable portion of the overall drag reduction is attributed to the reduction in the hub-on-pylon interference drag. It is also observed that the lower surface curvature of the fairing has a strong influence on the hub fairing and on pylon interference drag. However, the drag reduction benefit that was obtained by using the cambered hub fairing with a flat lower surface was adversely affected by the clearance between the hub fairing and the pylon.

Graham, D. R.↗

NASA NTRS1986

Real-time simulator for helicopter rotor wind-tunnel operations

This paper describes the elements and operation of a simulator that is being used to train operators of the Rotor Test Apparatus (RTA) in the large-scale 40- by 80-Foot Wind Tunnel at Ames Research Center. The simulator, named TUTOR (for Tunnel Utilization Trainer with Operating Rotor) duplicates the controls of the rotor and its dynamic behavior, as well as the wind-tunnel controls. The simulation software uses a preexisting blade-element model of a four-bladed rotor with flapping and lead-lag degrees of freedom. Equations were developed for all hardware and controls of the RTA and of the wind tunnel that are normally required to perform a wind-tunnel test of a helicopter rotor. The simulator hardware consists of consoles designed to have the same appearance and functions as those in the control room of the 40- by 80-Foot Wind Tunnel, allowing input from three operators who normally establish the required operating conditions during a test run. Normal operating procedures can be practiced, as well as simulated emergencies such as rotor power failure.

Talbot, P. D.↗

NASA NTRS1986

Experimental investigation of rotorcraft hub and shaft fairing drag reduction

A wind-tunnel test was conducted to obtain data on several rotorcraft hub and shaft fairing drag reduction configurations. Aerodynamic loads and moments were acquired for each test configuration. Limited wake pressure measurements and flow visualization (tuft) photographs were obtained for some configurations. All hub and shaft fairing configurations were tested on a 1/5-scale XH-59A model fuselage. Both coaxial and single rotor configurations were tested. All rotor assemblies were modeled with nonrotating hardware. The drag reduction methods tested included cambered elliptical hub fairings, several different shaft fairings, and strakes. Test data show that significant drag reductions can be attained with certain fairing configurations. The lowest drag values for the single rotor configurations were obtained for a cambered elliptical hub fairing with a large thickness airfoil shaft fairing. The lowest coaxial configuration drag values were obtained with cambered elliptical hub fairings and a long chord intermediate shaft fairing.

Young, L. A.↗