Search NASA⌕ Search

Engineering topics

Graham, R. W.

Publications and source records attributed to Graham, R. W..

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1977

Flow and heat transfer in a curved channel

Flow and heat transfer in a curved channel of aspect ratio 6 and inner- to outer-wall radius ratio 0.96 were studied. Secondary currents and large longitudinal vortices were found. The heat-transfer rates of the outer and inner walls were independently controlled to maintain a constant wall temperature. Heating the inner wall increased the pressure drop along the channel length, whereas heating the outer wall had little effect. Outer-wall heat transfer was as much as 40 percent greater than the straight-channel correlation, and inner-wall heat transfer was 22 percent greater than the straight-channel correlation.

Brinich, P. F.↗
NASA NTRS1976

Preliminary assessment of systems for deriving liquid and gaseous fuels from waste or grown organics

The overall feasibility of the chemical conversion of waste or grown organic matter to fuel is examined from the technical, economic, and social viewpoints. The energy contribution from a system that uses waste and grown organic feedstocks is estimated as 4 to 12 percent of our current energy consumption. Estimates of today's market prices for these fuels are included. Economic and social issues are as important as technology in determining the feasibility of such a proposal. An orderly program of development and demonstration is recommended to provide reliable data for an assessment of the viability of the proposal.

Graham, R. W.↗
NASA NTRS1976

A preliminary assessment of the feasibility of deriving liquid and gaseous fuels from grown and waste organics

The anticipated depletion of our resources of natural gas and petroleum in a few decades has caused a search for renewable sources of fuel. Among the possibilities is the chemical conversion of waste and grown organic matter into gaseous or liquid fuels. The overall feasibility of such a system is considered from the technical, economic, and social viewpoints. Although there are a number of difficult problems to overcome, this preliminary study indicates that this option could provide between 4 and 10 percent of the U.S. energy needs. Estimated costs of fuels derived from grown organic material are appreciably higher than today's market price for fossil fuel. The cost of fuel derived from waste organics is competitive with fossil fuel prices. Economic and social reasons will prohibit the allocation of good food producing land to fuel crop production.

Graham, R. W.↗
NASA NTRS1976

A preliminary assessment of the feasibility of deriving liquid and gaseous fuels from grown and waste organics

An estimate is obtained of the yearly supply of organic material for conversion to fuels, the energy potential is evaluated, and the fermentation and pyrolysis conversion processes are discussed. An investigation is conducted of the estimated cost of fuel from organics and the conclusions of an overall evaluation are presented. It is found that climate, land availability and economics of agricultural production and marketing, food demand, fertilizer shortage, and water availability combine to cast doubts on the feasibility of producing grown organic matter for fuel, in competition with food, feed, or fiber. Less controversial is the utilization of agricultural, industrial, and domestic waste as a conversion feedstock. The evaluation of a demonstration size system is recommended.

Graham, R. W.↗
NASA NTRS1976

Transport processes in boiling and two-phase systems, including near-critical fluids

Aspects of pool boiling are considered, taking into account nucleate boiling, the nucleate boiling mechanism, film boiling, and the transition between nucleate and film boiling. The characteristics of two-phase flow are also investigated, giving attention to two-phase flow parameters and equations, the flow pattern in two-phase flow, the pressure drop in two-phase flow, heat transfer in two-phase flow, two-phase flow dynamics, the boiling crisis in two-phase flow, the critical flow rate, the propagation of the pressure pulse and the sonic velocity in two-phase media, instrumentation for two-phase flow, and geometry and field effects on boiling and two-phase flow. Near-critical fluids are also considered.

Hsu, Y.-Y.↗
NASA NTRS1974

Convective heat transfer to low-temperature fluids

Research into forced and natural convection processes in low-temperature (cryogenic) fluids is reviewed with primary emphasis on forced convection. Boundaries of the near-critical region are defined, fluid properties near the critical state are discussed, and heat-transfer processes around the critical point are described. The thermodynamics of the critical point is analyzed together with transport properties of a near-critical fluid, and the quantum states of low-temperature molecular hydrogen (para and ortho) are discussed. Experimental work on heat transfer in free, natural, and forced convection systems is briefly summarized. Graham's (1969) penetration model for near-critical fluids is outlined, near-critical heat transfer is discussed in relation to conventional geometric effects, and the effects of curvature on the properties of near-critical hydrogen are noted. Theoretical considerations in free and forced convection are examined.

Graham, R. W.↗
NASA NTRS1972

Momentum flux in two phase two component low quality flow.

Values of a one-dimensional momentum flux at a test section discharge station of a two-phase two-component low quality flow computed by two methods, one based on a one-dimensional homogeneous model and the other on a variable slip model, are compared to experimental values for a range of two-phase flow conditions. The comparison seems to indicate the superior accuracy in momentum flux predictions to be on the side of the one-dimensional homogeneous model.

Baumeister, K. J.↗
NASA NTRS1972

Design and performance evaluation of a cryogenic condenser for an in-pile experiment

An apparatus was designed to enable in-pile irradiation of materials in liquid hydrogen at cryogenic temperatures. One of the principal components of this apparatus was a horizontal tube condenser. The performance of the condenser was evaluated by running a liquid-nitrogen prototype of the apparatus at heat loads comparable to or greater than those expected during the irradiation. The test showed that the condenser was capable of handling the design heat load and that the design procedure was sound.

Graham, R. W.↗
NASA NTRS1972

Heat transfer and boundary layer in conical nozzles

A review of a comprehensive experimental investigation of the heat transfer and boundary layer in 30 deg to 15 deg and 60 deg to 15 deg conical nozzles is presented. The experiments were conducted with air at a stagnation temperature of 539 K (970 R) and throat Reynolds numbers based on a diameter ranging from 6 x 10 to the 5th power to 5 x 10 to the 6th power. Nozzle wall surface finish was varied from a smooth machine finish to a 826 x 10 to the minus 6th power cm (325 x 10 to the minus 6th in.) rms sandblasted finish. Measured heat transfer and wall temperatures are tabulated.

Boldman, D. R.↗
NASA NTRS1972

Momentum flux in two phase two component low quality flow

In two phase flow systems line losses comprise frictional and momentum pressure drops. For design purposes, it would be desirable to estimate the line losses employing a one-dimensional calculation. Two methods for computing one-dimensional momentum flux at a test section discharge station are compared to the experimental value for a range of two-phase flow conditions. The one-dimensional homogeneous model appears to be more accurate generally in predicting the momentum than the variable slip model.

Baumeister, K. J.↗
NASA NTRS1972

Some contributions to energetics by the Lewis Research Center and a review of their potential non-aerospace applications

The primary technology areas are aerospace propulsion, power and materials. As examples in these technologies, the programs in the fields of cryogenics and liquid metals are reviewed and potential non-aerospace applications for the results of these programs are discussed. These include such possibilities as: hydrogen as a non-polluting industrial fuel; more efficient central power stations; and powerplants for advanced ground transportation.

Graham, R. W.↗