Engineering topics
Gran, R.
Publications and source records attributed to Gran, R..
Measurement of the underground atmospheric muon charge ratio using the MINOS Near Detector
Not Available
Neutrino and antineutrino inclusive charged-current cross section measurements with the MINOS near detector
The energy dependence of the neutrino-iron and antineutrino-iron inclusive charged-current cross sections and their ratio have been measured using a high-statistics sample with the MINOS near detector exposed to the NuMI beam from the main injector at Fermilab. Neutrino and antineutrino fluxes were determined using a low hadronic energy subsample of charged-current events. We report measurements of {nu}-Fe ({nu}-Fe) cross section in the energy range 3-50 GeV (5-50 GeV) with precision of 2%-8% (3%-9%) and their ratio which is measured with precision 2%-8%. The data set spans the region from low energy, where accurate measurements are sparse, up to the high-energy scaling region where the cross section is well understood.
Sudden stratospheric warmings seen in MINOS deep underground muon data
Explore the source record for details and available documents.
T-0977: Test Beam Calibration of the MINERvA Detector Components
Explore the source record for details and available documents.
Control of flexible structures: A systematic overview of the problem
A way of designing a control system using a finite model that accounts for the distributed nature of the control problem in a systematic way is described. This is accomplished by using a mode description of the system and from that description determining the number of modes that must be retained based on the performance and the disturbance descriptions. The design then uses a full order model that includes all of the dynamics: sensor, actuator, disturbance and flexible motion. The designs that result are simple, robust, perform well and have the added distinction of being easy to implement.
A robot in space as a large space structures control experiment
The control systems design issues for large space structures can be addressed by a robotics experiment which defines a teleoperator or a robot or uses the RMS. The robotics control demonstration brings the large space structures control technology to an effective state of readiness and provides a useful robot when the experiment is finished. Three major options in such an experiment are the RMS, a flexible arm that is going to be put on the Shuttle for other reasons, or a dexetrous manipulator or teleoperator.
A modern control approach to the design of the SPS control system
The structural dynamics of the solar power satellite were considered. The requirements on the vibration of the microwave antenna and the possibility of thermal induced vibration and severe structural-thermal interactions were considered. The possibility of using an active control system and modern control methods to mitigate structural problems is discussed.
Control of large space structures
The control of large space structures was studied to determine what, if any, limitations are imposed on the size of spacecraft which may be controlled using current control system design technology. Using a typical structure in the 35 to 70 meter size category, a control system design that used actuators that are currently available was designed. The amount of control power required to maintain the vehicle in a stabilized gravity gradient pointing orientation that also damped various structural motions was determined. The moment of inertia and mass properties of this structure were varied to verify that stability and performance were maintained. The study concludes that the structure's size is required to change by at least a factor of two before any stability problems arise. The stability margin that is lost is due to the scaling of the gravity gradient torques (the rigid body control) and as such can easily be corrected by changing the control gains associated with the rigid body control. A secondary conclusion from the study is that the control design that accommodates the structural motions (to damp them) is a little more sensitive than the design that works on attitude control of the rigid body only.
The feasibility of digital control techniques for the LEM primary and abort control paths in support of the LEM GN and C definition phase studies
Explore the source record for details and available documents.