Engineering topics

Greenstein, Emily P.

Publications and source records attributed to Greenstein, Emily P..

3 records

DOE OSTI2024

Observing the Surface Termination of LaScO 3 Perovskite Using Solid-State Nuclear Magnetic Resonance

Materials with well-defined surfaces are drawing increased attention for the design of bespoke catalysts and nanomaterials. Gaining a detailed understanding of the surfaces of these materials is an important challenge, which is often complicated by surface polymorphism and dynamic restructuring. We introduce the use of surface-enhanced NMR spectroscopy for the observation of such surfaces, focusing on LaScO 3 as an example. Here, we show that double-resonance NMR experiments correlating surface oxygen and probe molecules to the 139 La and 45 Sc nuclei at the surface reveal the material to be terminated by a ScO x monolayer. Surface-selective 17 O and 45 Sc NMR experiments further showed the material to be hydroxyl terminated and that the surface may be prone to dynamic restructuring as a result of moisture exposure. Perhaps most interestingly, surface-selective 139 La NMR experiments revealed the existence of previously undetected surface lanthanum defects, suggesting that surface-enhanced NMR may be useful as a guide in the synthesis of defect-free surfaces in the design of various nanomaterials.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2023

Wet to Dry Controls Lanthanide Scandate Synthesis

The choice of temperature and gas conditions used in a water pressure-controlled reactor is guided by density functional theory (DFT) to synthesize nearly phase pure lanthanide scandate nanoparticles (LnScO 3 , Ln = La, Nd, Sm, Gd). In this synthetic method, low water vapor partial pressures, well below water’s gas liquidus, inhibit particle growth, while an excess of water vapor results in undesired rare earth hydroxide and oxyhydroxide secondary phases. The optimal humidity for high-purity LnScO 3 particle synthesis is shown to vary with the lanthanide; DFT is used to calculate the thermodynamics of secondary phase formation for each lanthanide tested, such that the role of water vapor may be quantified and used to maintain phase purity (greater than 96 mol%) across the series. Furthermore, the combination of thermodynamic calculation and experimental confirmation with this pressure-controlled reactor provides an opportunity to explore analogous syntheses of other inorganic perovskite nanoparticles.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2021

Identifying Support Effects in Au-Catalyzed CO Oxidation

Some catalytic oxide supports are more equal than others, with numerous variable properties ranging from crystal symmetry to surface chemistry and electronic structure. As a consequence, it is often very difficult to determine which of these act as the driver of performance changes observed in catalysis. In this work, we hold many of these variable properties constant with structurally similar LnScO 3 (Ln = La, Sm, and Nd) nanoparticle supports with cuboidal shapes and a common Sc-rich surface termination. Using CO oxidation over supported Au nanoparticles as a probe reaction, we observe higher activation energy and a slower rate using NdScO 3 as the support material. This change is found to correlate to the strength of CO 2 binding to the support surface, identified by temperature-programmed desorption measurements. Furthermore, the change is due to differences in the 4f electrons of the lanthanide cations, the cations’ Lewis acidity, and the inductive effect they impose.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗