Catalytic Tandem CO 2 –Ethane Reactions and Hydroformylation for C3 Oxygenate Production
Explore the source record for details and available documents.
Engineering topics
Publications and source records attributed to Guo, H..
Explore the source record for details and available documents.
Explore the source record for details and available documents.
A multi-function divertor feedback control system has been built on Experimental Advanced Superconducting Tokamak (EAST) to treat the divertor heat load issue. With the real-time data of the Langmuir probes and the impurity seeding, the divertor electron temperature (T e,div ) is well controlled to achieve the partial detachment phase. The first trial of the CD 4 seeding for the T e,div reduction has been achieved on EAST long-pulse discharge. In the seeding phase, the T e,div was maintained close to 5 eV, and the surface temperature of the target plate (T surface,div ) had a reduction of about 150° C. The plasma stored energy had a reduction in the control phase, so it is necessary to find a way to keep the good plasma confinement in the next step. The CD 4 injection also mitigated the low hybrid wave coupling rate in some degree. The big volume of the CD 4 injection lifted the Greenwald density fraction from ~0.4 to ~0.7, which made the SOL into high recycling state. As a result, most of the injected carbon particles were in the high ionized state, and with the lower of the T e,div , the tungsten line emission was suppressed obviously.
Pore pressure diffusion along faults influences induced seismicity and rupture mechanics. In situ hydraulic diffusivity measurements along faults are rare and generally lower than inferred from seismicity migration. Here we use the tidal response of deep geothermal boreholes to measure fault diffusivity and permeability. Initial interpretations of the observation with a homogeneous confined aquifer model result in diffusivities of 10 -3 –10 -1 m 2 /s. However, this model mixes signals from both the conduit and the host rock. We develop a model for tidal response with a fault passing through the aquifer based on the fault-guided fracture network and solve for hydraulic properties in both the fault and the host rock. The resulting fault permeability is 2 × 10 -14 –7 × 10 -14 m 2 (90% confidence interval[CI]) and fault diffusivity is 0.08–0.33 m 2 /s (90% CI), which is 2 orders of magnitude higher than the host rock diffusivity in some wells, thus highlighting the role of faults as fluid conduits.
Explore the source record for details and available documents.
In this work, we study, by numerical and analytical means, the evolution of a collisionless plasma initiated between absorbing walls. The ensuing flow is described by rarefaction waves that travel inward from the boundaries, interact, and eventually vanish after crossing through, leading up to the asymptotic stage of the decay. Particle simulations indicate that the kinetic evolution strongly resembles one found in isentropic gas dynamics. Namely, a very gradual density profile forms in the expanding central region where the rarefaction waves interact, with an accompanying linear velocity profile. Asymptotically, the density falls off as 1/t. The density and the flux at the boundary show little variation over the period when rarefaction waves still exist. Plasma potential, on the other hand, drops quite rapidly (on the underlying ion-acoustic timescale) to less than initial electron temperature Te when over 70% of the particles still remain in the system. This is due to electron kinetics being governed by conservation of adiabatic invariant in a slowly varying potential well. Analytical model of the velocity distribution is presented to explain the simulations. The results have implications for afterglow plasmas used in material processing and also for ion-extraction devices. One property of potential interest is good uniformity of the decaying plasma that occurs after approximately one ion-acoustic time.
Anthropogenic air pollutants such as nitrogen oxides (NO(x) = NO + NO(2)), sulfur dioxide (SO(2)), and volatile organic compounds (VOC), among others, are emitted to the atmosphere throughout the year from energy production and use, transportation, and agriculture. These primary pollutants lead to the formation of secondary pollutants such as fine particulate matter (PM(2.5)) and ozone (O(3)) and perturbations to the abundance and lifetimes of short-lived greenhouse gases. Free radical oxidation reactions driven by solar radiation govern the atmospheric lifetimes and transformations of most primary pollutants and thus their spatial distributions. During winter in the mid and high latitudes, where a large fraction of atmospheric pollutants are emitted globally, such photochemical oxidation is significantly slower. Using observations from a highly instrumented aircraft, we show that multi-phase reactions between gas-phase NO(x) reservoirs and aerosol particles, as well as VOC emissions from anthropogenic activities, lead to a suite of atypical radical precursors dominating the oxidizing capacity in polluted winter air, and thus, the distribution and fate of primary pollutants on a regional to global scale.
We illustrate the Geophysical Fluid Dynamics Laboratory's CM4.0 physical climate model, with emphasis on those aspects that may be of particular importance to users of this model and its simulations. The model is built with the AM4.0/LM4.0 atmosphere/land model and OM4.0 ocean model. Topics include the rationale for key choices made in the model formulation, the stability as well as drift of the preindustrial control simulation, and comparison of key aspects of the historical simulations with observations from recent decades. Notable achievements include the relatively small biases in seasonal spatial patterns of top-of-atmosphere fluxes, surface temperature, and precipitation; reduced double Intertropical Convergence Zone bias; dramatically improved representation of ocean boundary currents; a high-quality simulation of climatological Arctic sea ice extent and its recent decline; and excellent simulation of the El Niño-Southern Oscillation spectrum and structure. Areas of concern include inadequate deep convection in the Nordic Seas; an inaccurate Antarctic sea ice simulation; precipitation and wind composites still affected by the equatorial cold tongue bias; muted variability in the Atlantic Meridional Overturning Circulation; strong 100 year quasiperiodicity in Southern Ocean ventilation; and a lack of historical warming before 1990 and too rapid warming thereafter due to high climate sensitivity and strong aerosol forcing, in contrast to the observational record. Overall, CM4.0 scores very well in its fidelity against observations compared to the Coupled Model Intercomparison Project Phase 5 generation in terms of both mean state and modes of variability and should prove a valuable new addition for analysis across a broad array of applications.
Experiments to combine a radiating divertor or mantle with high power, high βN plasma operation have successfully reduced the divertor heat flux by 40% but have also encountered several challenging problems. For example, injecting either neon or argon seed impurities have led both to significant fuel dilution of the core plasma and to the emergence of harmful tearing mode activity which compromised plasma beta and energy confinement time. Increased divertor closure ended in more effective control over the injected seed impurity inventory, although it was also observed that small radial variations in the placement of the outer separatrix strike point within the DIII-D ‘closed’ divertor could lead to clear differences in the impurity build-up inside the core plasma. Active particle pumping of argon seed impurities through the divertor leg on the high-field side of a double-null divertor configuration showed little effect on seed impurity inventory and only modest control over the deuterium fuel inventory. Normally, 80% or greater of injected argon was removed by the corresponding cryo-pump on the low-field (outboard) side of that divertor, with the remaining argon being removed by the outboard cryo-pump from the opposite divertor. For single-null divertor cases, the contribution of the inner (high-field) cryo-pump to impurity and main-ion control appears to be complicated by the levels of divertor recycling and degree of divertor detachment. In general, divertor design that impedes the escape of seed impurities, plasma shaping that allows a higher stability limit, and electron cyclotron deposition profiles that prevent tearing mode onset and impede impurity accumulation in the core are under consideration for addressing the issues presented in our work.
In this two–part paper, a description is provided of a version of the AM4.0/LM4.0 atmosphere/land model that will serve as a base for a new set of climate and Earth system models (CM4 and ESM4) under development at NOAA's Geophysical Fluid Dynamics Laboratory (GFDL). This version, with roughly 100 km horizontal resolution and 33 levels in the vertical, contains an aerosol model that generates aerosol fields from emissions and a “light” chemistry mechanism designed to support the aerosol model but with prescribed ozone. In Part 1, the quality of the simulation in AMIP (Atmospheric Model Intercomparison Project) mode—with prescribed sea surface temperatures (SSTs) and sea–ice distribution—is described and compared with previous GFDL models and with the CMIP5 archive of AMIP simulations. Here, the model's Cess sensitivity (response in the top–of–atmosphere radiative flux to uniform warming of SSTs) and effective radiative forcing are also presented. In Part 2, the model formulation is described more fully and key sensitivities to aspects of the model formulation are discussed, along with the approach to model tuning.
Here, in Part 2 of this two–part paper, documentation is provided of key aspects of a version of the AM4.0/LM4.0 atmosphere/land model that will serve as a base for a new set of climate and Earth system models (CM4 and ESM4) under development at NOAA's Geophysical Fluid Dynamics Laboratory (GFDL). The quality of the simulation in AMIP (Atmospheric Model Intercomparison Project) mode has been provided in Part 1. Part 2 provides documentation of key components and some sensitivities to choices of model formulation and values of parameters, highlighting the convection parameterization and orographic gravity wave drag. The approach taken to tune the model's clouds to observations is a particular focal point. Care is taken to describe the extent to which aerosol effective forcing and Cess sensitivity have been tuned through the model development process, both of which are relevant to the ability of the model to simulate the evolution of temperatures over the last century when coupled to an ocean model.
Multi-hydrogenated species with proper symmetry properties can present different spin configurations, and thus exist under different spin symmetry forms, labeled as para and ortho for two-hydrogen molecules. We investigated here the ortho-to-para ratio (OPR) of H 2 Cl + in the light of new observations performed in the z = 0.89 absorber toward the lensed quasar PKS 1830-211 with the Atacama Large Millimeter/submillimeter Array (ALMA). Two independent lines of sight were observed, to the southwest (SW) and northeast (NE) images of the quasar, with OPR values found to be 3.15 ± 0.13 and 3.1 ± 0.5 in each region, respectively, in agreement with a spin statistical weight of 3:1. An OPR of 3:1 for a molecule containing two identical hydrogen nuclei can refer to either a statistical result or a high-temperature limit depending on the reaction mechanism leading to its formation. It is thus crucial to identify rigorously how OPRs are produced in order to constrain the information that these probes can provide. To understand the production of the H 2 Cl + OPR, we undertook a careful theoretical study of the reaction mechanisms involved with the aid of quasi-classical trajectory calculations on a new global potential energy surface fit to a large number of high-level ab initio data. Our study shows that the major formation reaction for HH 2 Cl + produces this ion via a hydrogen abstraction rather than a scrambling mechanism. Finally, such a mechanism leads to a 3:1 OPR, which is not changed by destruction and possible thermalization reactions for H 2 Cl + and is thus likely to be the cause of observed 3:1 OPR ratios, contrary to the normal assumption of scrambling.
Based on recent Herschel results, the ortho-to-para ratio (OPR) of NH2 has been measured towards the following high-mass star-forming regions: W31C (G10.6-0.4), W49N (G43.2-0.1), W51 (G49.5-0.4), and G34.3+0.1. The OPR at thermal equilibrium ranges from the statistical limit of three at high temperatures to infinity as the temperature tends toward zero, unlike the case of H 2 . Depending on the position observed along the lines-of-sight, the OPR was found to lie either slightly below the high temperature limit of three (in the range 2.2–2.9) or above this limit (~3.5, ≳ 4.2, and ≳5.0). In low temperature interstellar gas, where the H 2 is para-enriched, our nearly pure gas-phase astrochemical models with nuclear-spin chemistry can account for anomalously low observed NH 2 -OPR values. In this study, we have tentatively explained OPR values larger than three by assuming that spin thermalization of NH 2 can proceed at least partially by H-atom exchange collisions with atomic hydrogen, thus increasing the OPR with decreasing temperature. In this paper, we present quasi-classical trajectory calculations of the H-exchange reaction NH 2 + H, which show the reaction to proceed without a barrier, confirming that the H-exchange will be efficient in the temperature range of interest. With the inclusion of this process, our models suggest both that OPR values below three arise in regions with temperatures ≳20–25 K, depending on time, and values above three but lower than the thermal limit arise at still lower temperatures.
N/A
Gaining in-situ access to relaxation dynamics of radiation induced defects will lead to a better understanding of materials and is important for the verification of theoretical models and simulations. We show preliminary results from experiments at the new Neutralized Drift Compression Experiment (NDCX-II) at Lawrence Berkeley National Laboratory that will enable in-situ access to defect dynamics through pump-probe experiments. Here, the unique capabilities of the NDCX-II accelerator to generate intense, nanosecond pulsed ion beams are utilized. Preliminary data of channeling experiments using lithium and potassium ions and silicon membranes are shown. We compare these data to simulation results using Crystal Trim. Furthermore, we discuss the improvements to the accelerator to higher performance levels and the new diagnostics tools that are being incorporated.