Ferric pyrophosphate citrate: interactions with transferrin
Abstract not provided
Engineering topics
Publications and source records attributed to Gupta, Ajay.
Abstract not provided
Structural changes occurring in a thin amorphous Co{sub 23}Fe{sub 60}B{sub 17} film sandwiched between two Mo layers, as a function of thermal annealing has been studied. Thermal stability of the Co{sub 23}Fe{sub 60}B{sub 17} film is found to be significantly lower than the bulk ribbons. SIMS measurements show that during crystallization, boron which is expelled out of the crystallites, has a tendency to move towards the surface. No significant diffusion of boron in Mo buffer layer is observed. This result is in contrast with some earlier studies where it was proposed that the role of buffer layer of refractory metal is to absorb boron which is expelled out of the bcc FeCo phase during crystallization.
The present work reports the crystallization study of amorphous FeCoB ribbons using x-ray diffraction, {sup 57}Fe Mössbauer spectroscopy in transmission mode and magneto-optical Kerr (MOKE) microscopy. Annealing at 673 K is found to result in crystallization. From the Mossbauer measurements it is observed that the Fe magnetic moments are in the plane of sample for as-cast ribbon; α-FeCo, (Fe{sub 0.5}Co{sub 0.5}){sub 2}B and Fe{sub 2}B phases are formed after crystallization. MOKE microscopy revealed that wide 180° domain walls & narrow fingerprint domains are observed before crystallization and fine domains are observed after crystallization. The results are explained in terms of the presence of internal stresses and their annealing with thermal heat treatment.
Structural, electrical and magnetic properties of magneto-electric composite ceramics viz., 0.9 BaTi{sub 0.95}Sn{sub 0.05}O{sub 3} (BTSO)- 0.1 Ni{sub 0.8}Zn{sub 0.2}Fe{sub 2}O{sub 4} (NZFO) prepared with microwave assisted radiant hybrid sintering (MARH) are reported. Phase purity and isovalent substitution of Ti{sup 4+} by Sn{sup 4+} of the samples is confirmed from x-ray diffraction and {sup 119}Sn Mossbauer measurements respectively. Significant suppression of leakage current and improvement of ferroelectricity is observed for the composites prepared with MARH. The observed results are explained in terms of uniform dispersion of ferrite (NZFO) phase in the ferroelectric (BTSO) matrix as evidenced from back-scattered scanning electron micrographs.
A detailed mechanism of the nanoripple pattern formation on Si substrates generated by the simultaneous incorporation of pure Fe impurities at low energy (1 keV) ion beam erosion has been studied. To understand and clarify the mechanism of the pattern formation, a comparative analysis of the samples prepared for various ion fluence values using two complimentary methods for nanostructure analysis, atomic force microscopy, and grazing incidence small angle x-ray scattering has been done. We observed that phase separation of the metal silicide formed during the erosion does not precede the ripple formation. It rather concurrently develops along with the ripple structure. Our work is able to differentiate among various models existing in the literature and provides an insight into the mechanism of pattern formation under ion beam erosion with impurity incorporation.
Nanocrystalline Fe-X-N thin films (with doping X = 0, 3.1 at. % Al, 1.6 at. % Zr), were deposited using reactive ion beam sputtering. Magnetization study reveals that the deposited films exhibit a perpendicular magnetic anisotropy. Thermal stability of the films was investigated systematically and it was observed that the structural and the magnetic stability gets significantly enhanced with Al doping, whereas Zr doping has only a marginal effect. Fe self-diffusion, obtained using polarized neutron reflectivity, shows a suppression with both additives. A correlation between the thermal stability and the diffusion process gives a direct evidence that the enhancement in the thermal stability is primarily diffusion controlled. A combined picture of diffusion, structural, and magnetic stability has been drawn to understand the obtained results.
Structural, dielectric, ferroelectric (FE), {sup 119}Sn Mössbauer, and specific heat measurements of polycrystalline BaTi{sub 1–x}Sn{sub x}O{sub 3} (x = 0% to 15%) ceramics are reported. Phase purity and homogeneous phase formation with Sn doping is confirmed from x-ray diffraction and {sup 119}Sn Mössbauer measurements. With Sn doping, the microstructure is found to change significantly. Better ferroelectric properties at room temperature, i.e., increased remnant polarization (38% more) and very low field switchability (225% less) are observed for x = 5% sample as compared to other samples and the results are explained in terms of grain size effects. With Sn doping, merging of all the phase transitions into a single one is observed for x ≥ 10% and for x = 5%, the tetragonal to orthorhombic transition temperature is found close to room temperature. As a consequence better electro-caloric effects are observed for x = 5% sample and therefore is expected to satisfy the requirements for non-toxic, low energy (field) and room temperature based applications.
This article describes the development of a soft x-ray beamline on a bending magnet source of Indus-2 storage ring (2.5 GeV) and some preliminary results of x-ray absorption spectroscopy (XAS) measurements using the same. The beamline layout is based on a spherical grating monochromator. The beamline is able to accept synchrotron radiation from the bending magnet port BL-1 of the Indus-2 ring with a wide solid angle. The large horizontal and vertical angular acceptance contributes to high photon flux and selective polarization respectively. The complete beamline is tested for ultrahigh vacuum (UHV) ∼ 10{sup −10} mbar. First absorption spectrum was obtained on HOPG graphite foil. Our performance test indicates that modest resolving power has been achieved with adequate photon flux to carry out various absorption experiments.
In this work we have studied the crystal structural and local ordering of iron and nitrogen in iron mononitride thin films prepared using dc magnetron sputtering at sputtering power of 100W and 500W. The films were sputtered using pure nitrogen to enhance the reactivity of nitrogen with iron. The x-ray diffraction (XRD), conversion electron Mössbauer spectroscopy (CEMS) and soft x-ray absorption spectroscopy (SXAS) studies shows that the film crystallizes in ZnS-type crystal structure.
Evolution of structural and magnetic properties of amorphous Co{sub 68}Fe{sub 14}B{sub 18} thin film with thermal annealing has been studied. Initially, the film exhibits a structural relaxation as evidenced by annihilation of excess free volume and an increase in topological short range order. Annealing at 473 K results in precipitation of primary phase followed by formation of boride phase at a still higher temperature of 598 K. Iron preferentially precipitates out in the primary phase, resulting in the formation of bcc Co{sub 58}Fe{sub 41}. This suggests an affinity of Co towards B. Such affinity between Co and B is evidenced even in the as-deposited film, using hard x-ray photoelectron spectroscopy (HAXPES) measurements. As-deposited film exhibits an in-plane uniaxial magnetic anisotropy which disappears at a temperature well beyond crystallization temperature, suggesting that the origin of anisotropy is mainly a chemical short range order in the system. Variation in the coercivity with thermal annealing can be understood in terms of random anisotropy model. Precise measurement of Fe self-diffusion using neutron reflectivity shows that diffusion length associated with annihilation of excess free volume in the film is about 0.5 nm. This agrees with the length scale of structural fluctuations in amorphous alloys. Secondary ion mass spectrometry measurements show that thermal annealing results in depletion of B in the region of the interface with the substrate, with associated faster Fe diffusion in this region. This faster diffusion of Fe may be a possible cause of preferential crystallization of the film in the interfacial region as seen in some earlier studies.
The Ni/V multilayers are useful as soft x-ray mirrors, polarizers, and phase retarders. For these applications, it is necessary that the interfaces roughness and interdiffusion must be as small as possible. The V-on-Ni and Ni-on-V interfaces are asymmetric due to the difference in the surface free energy of Ni and V. In this work, we report Ag surfactant mediated growth of Ni/V superlattices prepared using ion beam sputter deposition technique. These superlattices were studied using x-ray and neutron scattering techniques. It was found that when added in an optimum amount, Ag surfactant results in reduced interface roughness and interdiffusion across the interfaces. Obtained results can be understood with the surfactant floating-off mechanism leading to a balance in the surface free energy of Ni and V.
Graphical abstract: Display Omitted Highlights: ► Ni{sub 0.5}Zn{sub 0.5}Fe{sub 2}O{sub 4} prepared by self combustion with uniform/nonuniform heating. ► Characterized using TEM, XRD, in-field Mössbauer and DC magnetometry. ► Leads to bimodal (S1) and very narrow size distribution (S2) type nano samples. ► S1 has magnetic properties of bulk Ni{sub 0.5}Zn{sub 0.5}Fe{sub 2}O{sub 4}. ► Although very even sized, S2 large magnetic anisotropy distribution. -- Abstract: Nano powders of Ni{sub 0.5}Zn{sub 0.5}Fe{sub 2}O{sub 4} have been synthesized by the self-combustion method at a relatively low temperature of 473 K under conditions of non-uniform and uniform heating. Rietveld fitting of X-ray diffractograms confirm the formation of the pure spinel phase in both samples. Transmission electron microscopy indicates that the sample prepared under non-uniform heating has a bimodal particle size distribution (average values 16 nm and 6 nm) while the one prepared under uniform heating has a very narrow particle size distribution (average size 4 nm). Low temperature, in-field Mössbauer spectroscopic studies clearly show surface spin contributions. The hyperfine fields and Curie temperature of the non-uniformly heated sample are in good agreement with those reported for the corresponding bulk samples. Despite having a very narrow particle size distribution, the uniformly heated sample has a large anisotropy distribution which is evident in the broad transition visible in the temperature dependent magnetization curve. It is also corroborated by the fact that the experimental magnetization curve at room temperature requires two Langevin functions for satisfactory reproduction.
The energy dispersive x-ray diffraction (EDXRD) beam line at beam port no. BL-11, INDUS-2, RRCAT (Indore) has been adapted for grazing incidence x-ray diffraction (GIXRD) measurements in both out-of plane and in-plane geometry. With the help of energy sensitive high resolution HPGe detector, we have been able to record diffraction data from thin films of thicknesses ranging from few nanometers to hundreds of nanometers. We are presenting here a few demonstrative examples to illustrate the capabilities and possible implications of EDXRD beamline in carrying out structural investigations of thin films.
In this work we studied the magnetic and structural properties of Fe{sub 1-x}Ti{sub x}(x=0, 0.02, 0.05, 0.07) thin films prepared with dc-magnetron sputtering. It was found that the inter-atomic spacing increases as the amount of Ti is increased indicating that Ti is getting dissolved substitutionally in Fe lattice. We found that the addition of 5% Ti is best suited for its usage in Fe-Ti-N alloys.
Ion beam mixing of Pt/Co bilayers using self ion (Pt{sup +}) beam results in formation of CoPt phase. Upon ion beam annealing the ion mixed samples using 4 MeV Si{sup +} ions at 300 deg. C, diffusion of Co towards the Pt/Co interface is observed. The Si{sup +} ion beam rotates the magnetization of the CoPt phase from in plane to out of plane of the film.
The effect of moderately intense ({approx}GWcm{sup -2} The effect of moderately intense ({approx}GWcm-2), 200 ps laser pulse irradiation on silicon single crystal is reported. The x-ray diffraction measurements performed on the irradiated samples reveal irreversible structural deformations. Raman spectroscopic measurements reveal substantial shift of the peak position as well as an overall broadening, pointing towards the presence of residual strain and formation of micromosaic structures on the laser induced shock recovered samples.
The self-diffusion of iron and nitrogen is measured in nm range non-magnetic iron nitride thin films. Two non-magnetic iron nitrides, Fe{sub 2.23}N and FeN, were studied using neutron reflectivity. Neutron reflectivity with a depth resolution in the sub-nm range has a different scattering cross section for isotopes, providing a unique opportunity to measure very small diffusivities. The isotope heterostructure in thin film multilayers [Fe-N/{sup 57}Fe-N]{sub 10} and [Fe-N/Fe-{sup 15}N]{sub 10} were prepared using magnetron sputtering. It was observed that nitrogen diffuses slower than iron although the atomic size of iron is larger than that of nitrogen. It was found that a significantly larger group of N atoms participates in the diffusion process than of Fe, making N diffusion slower than that of Fe.
The multilayer system (MLS)-[{sup 57}Fe{sub 25}A/Co{sub 11}A/Al{sub 17}A]x20 has been deposited by Ion beam sputtering (IBS) technique. The MLS has been annealed at 700 deg. C for 1 h. Overall composition of as deposited and annealed MLS have been characterized by EDX and magnetic properties have been studied through angular dependent magneto optic Kerr effect (MOKE) hysteresis curves. The study shows that the as-deposited MLS has excellent soft magnetic properties coupled with perpendicular magnetic isotropy which is destroyed on annealing.