Search NASA⌕ Search

Engineering topics

Gurovich, V Tz

Publications and source records attributed to Gurovich, V Tz.

Generation of extreme state of water by spherical wire array underwater electrical explosion

The results of the first experiments on the underwater electrical explosion of a spherical wire array generating a converging strong shock wave are reported. Using a moderate pulse power generator with a stored energy of {<=}6 kJ and discharge current of {<=}500 kA with a rise-time of {approx}300 ns, explosions of Cu and Al wire arrays of different diameters and with a different number and diameter of wires were tested. Electrical, optical, and destruction diagnostics were used to determine the energy deposited into the array, the time-of-flight of the shock wave to the origin of the implosion, and the parameters of water at that location. The experimental and numerical simulation results indicate that the convergence of the shock wave leads to the formation of an extreme state of water in the vicinity of the implosion origin that is characterized by pressure, temperature, and compression factors of (2 {+-} 0.2) Multiplication-Sign 10{sup 12} Pa, 8 {+-} 0.5 eV, and 7 {+-} 0.5, respectively.

42 ENGINEERING↗

Numerical simulation of the pre-ionization processes during nanosecond-pulse discharge in nitrogen

The pre-ionization of nitrogen gas by high-voltage nanosecond pulse discharges is studied using one-dimensional particle-in-cell numerical simulations. The comparison between the various mechanisms of pre-ionization, i.e., by runaway electrons, x-rays, and ultraviolet radiation, is presented. It is shown that runaway electrons produce a much higher number of electron-ion pairs than those generated by x-rays, which accompany the process of runaway electron generation. Also, results of simulations showed that among photo-ionization mechanisms the most significant gas pre-ionization is caused by x-rays generated in the process of impact ionization of the K-shell of nitrogen atoms.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Numerical simulations of runaway electron generation in pressurized gases

The results of a numerical simulation of the generation of runaway electrons in pressurized nitrogen and helium gases are presented. It was shown that runaway electrons generation occurs in two stages. In the first stage, runaway electrons are composed of the electrons emitted by the cathode and produced in gas ionization in the vicinity of the cathode. This stage is terminated with the formation of the virtual cathode, which becomes the primary source of runaway electrons in the second stage. Also, it was shown that runaway electrons current is limited by both the shielding of the field emission by the space charge of the emitted electrons and the formation of a virtual cathode. In addition, the influence of the initial conditions, such as voltage rise time and amplitude, gas pressure, and the type of gas, on the processes that accompany runaway electrons generation is presented.

74 ATOMIC AND MOLECULAR PHYSICS↗

Generation of a 400 GPa pressure in water using converging strong shock waves

Results related to the generation of an extreme state of water with pressure up to (4.3 {+-} 0.2){center_dot}10{sup 11} Pa, density up to 4.2 {+-} 0.1 g/cm{sup 3}, and temperature up to 2.2 {+-} 0.1 eV in the vicinity of the implosion axis of a converging strong shock wave are reported. The shock wave was produced by the underwater electrical explosion of a cylindrical Cu wire array. A {approx}8 kJ pulse generator with a current amplitude {<=}550 kA and rise time of 350 ns was used to explode arrays having varying lengths, radii, and number of wires. Hydrodynamic numerical simulations coupled to the experimental data of the shock wave propagation in water, rate of energy deposition into the array, and light emission from the compressed water in the vicinity of the implosion axis were used to determine the pressure, density, and temperature profiles during the implosion. Results of a comparison between these parameters obtained with the SESAME and quantum molecular dynamics data bases of equation of state for water are reported as well. Also, the dependences of the maximal pressure in the vicinity of the implosion axes on the array radius and the deposited energy density per unit length are reported.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

High-current diode with ferroelectric plasma source-assisted hollow anode

The operation of a ferroelectric plasma source-assisted hollow anode (HA) electron source in a vacuum diode powered by an {approx}200 kV and {approx}400 ns pulsed generator was studied using time- and space-resolved laser induced fluorescence diagnostics. It was found that the plasma ion ''temperature'' in the vicinity of the HA output grid increases up to {approx}15 eV during the accelerating pulse, which is consistent with a model of the potential screening of the grid by the randomly moving ions [Phys. Plasmas 13, 073506 (2006)]. Also it was shown that the increase in the HA plasma potential up to several kilovolts because of the appearance of a noncompensated ion charge in the HA bulk plasma due to electrons fast extraction, leads to explosive emission centers being generated at the HA grid and to nonuniformity in the cross-sectional electron beam current density. Finally, the plasma prefilled mode of diode operation was studied using a simple one-dimensional model of the plasma erosion and the HA plasma electron heating by energetic ions was considered.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Extreme water state produced by underwater wire-array electrical explosion

The generation of an extreme water state (130 GPa, 5000 K, and 3.4 g/cm{sup 3}) which is characterized as dense plasma at the axis of a converging shock wave is reported. A 4 kJ pulse generator was used to explode a 40 Cu-wire array, generating a cylindrical shock wave. The measured shock wave trajectory and energy deposited into the water flow were used in hydrodynamic simulations coupled with the equation of state to determine the water parameters. The temperature estimated using the emission data of water in the vicinity of the implosion axis agrees with the simulation results, indicating shock wave symmetry in such extreme conditions.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Laser induced fluorescence of the ferroelectric plasma source assisted hollow anode discharge

Parameters of the plasma produced by a ferroelectric plasma source (FPS) assisted high-current ({approx}1 kA), hollow anode (HA), low-pressure (10{sup -4} Torr) Ar gas discharge were studied using a time- and space-resolved laser induced fluorescence (LIF) diagnostic technique. It was shown that the plasma filling of the HA cavity occurs due to the expansion of the plasma flows generated by the FPSs with a gradual time-dependent increase in the plasma density along the length of the HA cavity. These data were verified by the results of one-dimensional modeling of the plasma expansion in vacuum and time-dependent collisional-radiative modeling. Also, LIF diagnostics, which was tested on the saturation effect both experimentally and numerically, showed that the plasma ion temperature gradually increases during the discharge reaching {approx}9 eV at its end. Various phenomena (plasma kinetic instabilities, charge-exchange processes during the plasma ion interaction with the HA walls, and the model of neutral atoms ionization inside the Debay's sphere), which could be responsible for such ion temperature, were considered.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Addressing the efficiency of the energy transfer to the water flow by underwater electrical wire explosion

Experimental and hydrodynamic simulation results of submicrosecond time scale underwater electrical explosions of planar Cu and Al wire arrays are presented. A pulsed low-inductance generator having a current amplitude of up to 380 kA was used. The maximum current rise rate and maximum power achieved during wire array explosions were dI/dt<=830 A/ns and approx10 GW, respectively. Interaction of the water flow generated during wire array explosion with the target was used to estimate the efficiency of the transfer of the energy initially stored in the generator energy to the water flow. It was shown that efficiency is in the range of 18%-24%. In addition, it was revealed that electrical explosion of the Al wire array allows almost double the energy to be transferred to the water flow due to efficient combustion of the Al wires. The latter allows one to expect a significant increase in the pressure at the front of converging strong shock waves in the case of cylindrical Al wire array underwater explosion.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

Pulsed plasma electron sources

There is a continuous interest in research of electron sources which can be used for generation of uniform electron beams produced at E{<=}10{sup 5} V/cm and duration {<=}10{sup -5} s. In this review, several types of plasma electron sources will be considered, namely, passive (metal ceramic, velvet and carbon fiber with and without CsI coating, and multicapillary and multislot cathodes) and active (ferroelectric and hollow anodes) plasma sources. The operation of passive sources is governed by the formation of flashover plasma whose parameters depend on the amplitude and rise time of the accelerating electric field. In the case of ferroelectric and hollow-anode plasma sources the plasma parameters are controlled by the driving pulse and discharge current, respectively. Using different time- and space-resolved electrical, optical, spectroscopical, Thomson scattering and x-ray diagnostics, the parameters of the plasma and generated electron beam were characterized.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗