Search NASA⌕ Search

Engineering topics

Haddad, George I.

Publications and source records attributed to Haddad, George I..

A 32-bit Ultrafast Parallel Correlator using Resonant Tunneling Devices

An ultrafast 32-bit pipeline correlator has been implemented using resonant tunneling diodes (RTD) and hetero-junction bipolar transistors (HBT). The negative differential resistance (NDR) characteristics of RTD's is the basis of logic gates with the self-latching property that eliminates pipeline area and delay overheads which limit throughput in conventional technologies. The circuit topology also allows threshold logic functions such as minority/majority to be implemented in a compact manner resulting in reduction of the overall complexity and delay of arbitrary logic circuits. The parallel correlator is an essential component in code division multi-access (CDMA) transceivers used for the continuous calculation of correlation between an incoming data stream and a PN sequence. Simulation results show that a nano-pipelined correlator can provide and effective throughput of one 32-bit correlation every 100 picoseconds, using minimal hardware, with a power dissipation of 1.5 watts. RTD plus HBT based logic gates have been fabricated and the RTD plus HBT based correlator is compared with state of the art complementary metal oxide semiconductor (CMOS) implementations.

Kulkarni, Shriram↗

High-power generation in IMPATT devices in the 100-200-GHz range

A silicon double-drift IMPATT diode with high uniform doping levels was simulated. Simulation results show that it is possible for silicon IMPATT diodes to generate extremely high pulsed output power for frequencies above 100 GHz under high current-density operation. The highest output power matched to a 1-ohm load resistance obtained at 150 GHz is 37.7 W, with a dc current density of 200 kA/sq cm, although the calculated power conversion efficiency is low. It is also shown that the low-power conversion efficiency limits the diode's continuous wave power operation.

Chen, Chien-Chung↗

Microwave and millimeter-wave power generation in silicon carbide (SiC) IMPATT devices

There are two points that should be noted. First, in the thermal resistance calculations it is assumed that the device is operating at 773 K while the results of the room temperature simulations are used. This was done because there is not enough information to correctly predict the material parameters at 773 K. Since, in general, device performance degrades with increasing temperature, the cw results are perhaps a bit optimistic. Second, the electric field in these structures gets extremely high and there might be some possibility of tunneling. This was not incorporated into the simulation. Again, this could result in different device operating conditions.

Mehdi, I.↗