Search NASA⌕ Search

Engineering topics

Hadjipanayis, G. C.

Publications and source records attributed to Hadjipanayis, G. C..

3 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2023

Semihard magnetic properties of TiFe 2.5 iron-rich Laves phase and the effect of 4d- and 5d-element-substitutions for Ti

Rare-earth-free compounds exhibiting modest intrinsic hard magnetic properties may still yield viable permanent magnets if their constituent elements are abundant and inexpensive, and the properties are at least comparable to those of the hard ferrites. In this study, one such compound, the off-stoichiometric TiFe 2.5 Laves phase with the hexagonal C14 crystal structure, was found to exhibit – in addition to the already known room-temperature ferromagnetism – a uniaxial, albeit weak, magnetic anisotropy. With a Curie temperature of 422 K, saturation magnetization of 55.3 Am 2 /kg and magnetic hardness parameter of 0.97 this semihard compound is just below the threshold for being of interest for the development into permanent magnets. Replacing a small fraction of Ti with the 4d Nb and Mo or with the 5d Ta or W increases the anisotropy field, but only below room temperature. Replacing Ti with Zr or Hf increases the Curie temperature and leads to a spin reorientation below 200 K. All these substitutions, as well as combined (Zr,W) and (Nb,W) substitutions, fail to improve the room-temperature intrinsic hard magnetic properties of the Fe-rich Laves phase. Furthermore, an attempt to develop a room-temperature coercivity through high-energy ball-milling yielded a value of 0.026 T, an unusually small 2.9% fraction of the anisotropy field. Here, defects inherent in the C14 crystal lattice may be responsible for the underperformance.

36 MATERIALS SCIENCE↗
DOE OSTI2020

MnBi-based magnets prepared from melt-spun alloys: Effect of $α → β$ phase transformation during field annealing

The temperature of the annealing treatment applied to the MnBi alloys with the intention to stabilize the α -MnBi “low-temperature” phase – a promising material for the rare-earth-free permanent magnets – is usually kept below the range of the β -Mn 1.08 Bi “high-temperature” phase. This work is focused on the investigation of the effects of partial and complete α → β phase transformation in bulk magnetic-field-annealed magnets on their structure and magnetic properties. MnBi alloys modified with In, Mg and Sb were melt-spun, compacted to their full density and then heated in a magnetic field of 30 kOe to temperatures sufficiently high for the beginning of the α → β transformation. A heating of 15 °C/min was used which was immediately followed by cooling at the rate of 7.5 °C/min; the degree of the phase transformation was measured by in situ monitoring of changes in the sample magnetization. In all the studied alloys, the α → β transformation was found to improve the [0 0 1] fiber texture induced by the applied magnetic field, although it simultaneously decreased the coercivity. A partial transformation has resulted in a 11% increase of the maximum energy product for the Mn 50 Bi 49 Sb 0.5 In 0.5 magnet, to 8.3 MGOe, and a 3% increase for the Mn 50 Bi 46 Mg 3 Sb 0.5 In 0.5 magnet, to 12.8 MGOe. In the latter alloy, the α → β and reverse transformations were found to initially occur in well-defined pockets leading to clusters of large, highly textured α crystallites. In the Mn 50 Bi 48.5 Sb 1.5 magnet, only part of the α phase could be recovered after the transformation, which instead promoted the paramagnetic MnBi 0.9 Sb 0.1 phase.

36 MATERIALS SCIENCE↗