Engineering topics
Publications and source records attributed to Haehner, C. L..
Simplified, compact apparatus uses fixtures that can test three samples at once for flexure, compression, or double-shear creep. Each fixture uses series of rods and plates to divide one load equally among three samples. Fixtures could be expanded to carry more samples by adding more rods and plates.
The static coefficient of friction between contacting surfaces of a plurality of bodies is determined by applying a load to the bodies in a direction normal to the contacting surfaces. Opposite ends of a flexible filament are connected to a load cell and the first of the bodies. A motor continuously moves the second of the bodies away from the load cell at constant velocity at right angles to the force of the normal load so that the first body moves intermittently relative to the second body across a contact surface between them. The load on the surfaces, the nature of the surfaces, and the speed of the first body relative to the load cell are such that the filament is alternately and cyclically tensioned and relaxed as the movement occurs. The maximum tension occurs at the incipient stages of movement of the first body relative to the second body. The load cell derives a series of measurements which are coupled to an x-y recorder, from which the maximum forces of the filament are determined to enable the static coefficient of friction to be determined. From the maximum forces and the normal force, the coefficient is determined. For determining coefficients of friction where there are large compression loads, the normal load is applied with a calibrated compression spring that is deflected by a predetermined amount determined by a spring load vs. deflection calibration curve.
Device includes load cell attached to rigid structure. Crosshead directly beneath cell is connected to constant-speed electrical motor. Crossarm supported by crosshead serves as platform on which bodies are tested. Test data are recorded on X-Y recorder which is connected to load cell and motor.
In response to an emergency request, the mechanical properties of two complex laminate materials, used as thermal shields on the Skylab spacecraft, were investigated. Concern over the prolonged use of these materials in the space environment prompted this investigation. Shields made of both of these materials, popularly called the parasol and the sail types, were taken to the Skylab spacecraft by the original Skylab astronauts. Both were used to restore thermal control after the original control surfaces were damaged during launch. During the tests the tensile properties were measured at anticipated service temperature and after prolonged exposure to increasing degrees of ultraviolet radiation at intensities approaching two solar constants. Some samples received exposures equivalent to 2,350 hours. The performance and degradation of the two materials are presented in terms of orientation, vacuum, and degree of irradiation. In general, the 75-micron (3-mil) parasol laminate showed a decrease in tensile properties as a function of exposure time, while the 200-micron (8-mil) sail laminate was little affected by exposure to the ultraviolet radiation.
A process for metal plating which comprises spraying a mixture of metallic powder and small peening particles at high velocity against a surface is described. The velocity must be sufficient to impact and bond metallic powder onto the surface. In the case of metal surfaces, the process has as one of its advantages providing mechanical working (hardening) of the surface simultaneously with the metal plating.
Technique permits plating of primarily metallic substrates with either metals or nonmetals at normal temperature. Peening uses compressed air to apply concurrent streams of small glass beads and powdered plating material to the substrate.
Developing empirical equation for calculating effects of container geometry on liquid lubricant evaporation in vacuum