Search NASA⌕ Search

Engineering topics

Hahn Chul Jung

Publications and source records attributed to Hahn Chul Jung.

8 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2022

Measurement of Surface Deformation Related to the December 2018 Mt. Etna Eruption Using Time-Series Interferometry and Magma Modeling for Hazard Zone Mapping

Mount Etna has erupted several times since it was first formed. Recently, Mount Etna began erupting again over 24–27 December 2018. Because it erupts frequently, Mount Etna should be observed on a frequent basis. From June 2018 to October 2019, 34 and 56 interferometric synthetic aperture radar (InSAR) images were acquired from the ascending and descending tracks of the Sentinel-1 satellite, respectively. We employed the Stanford Method for Persistent Scatterers (StaMPS) and a refined small baseline subset (SBAS) InSAR method to produce a surface deformation time-series map. In the time-series analysis, the phase signal remained unaltered with time. The Okada model was then applied to the result to generate a modeled interferogram, and the Q-LavHA program was run to generate a lava flow prediction model. A direct comparison of the results showed that Persistent Scatterers Interferometry (PSI)-StaMPS and the refined SBAS technique were comparable in terms of the displacement pattern, with slightly different velocity values obtained for individual points. In particular, a velocity range of −25 to 21 cm/yr was obtained from PSI-StaMPS, whereas a range of −30 to 25 cm/yr was obtained from the refined SBAS method. Upon computation of the vertical and east-west displacement components based on ascending and descending track data using both methods, deformation velocities of 51.5 and 52.5 cm/yr in the westerly direction on the western flank of Mount Etna were obtained from PSI-StaMPS and the refined SBAS method, respectively, whereas on the eastern flank, deformation toward the east was estimated to occur at a velocity of 50.1 or 54.2 cm/yr, respectively. PSIStaMPS estimated a vertical deformation velocity of −5.3 to 18.3 cm/yr, whereas the refined SBAS method produced a velocity range of approximately −7 to 19 cm/yr. The interferogram obtained via Okada modeling showed two fault sources in the 2018 Mount Etna eruption and a total volume change of approximately 12.39 × 10 6 m 3 . From the modeling results, a lava flow prediction model was generated using the Q-LavHA program. The approaches described in this study can be used by government officials, authorities, and other decision-makers to monitor and assess the risk of volcanic activity in the region.

Suci Ramayanti↗
NASA NTRS2020

Satellite Gravimetry Improves Seasonal Streamflow Forecast Initialization in Africa

West Africa is one of the poorest regions in the world and highly vulnerable to extreme hydrological events due to the lack of reliable monitoring and forecast systems. For the first time, we demonstrate that initial hydrological conditions informed by satellite-based terrestrial water storage (TWS) estimates improve seasonal streamflow forecasts. TWS variability detected by the Gravity Recovery and Climate Experiment (GRACE) satellites is assimilated into a land surface model during 2003–2016 and used to initialize 6-month hindcasts (i.e., forecasts of past events) during West Africa's wet seasons. We find that GRACE data assimilation (DA) generally increases groundwater and soil moisture storage in the region, resulting in increased evapotranspiration and reduced total runoff. Total runoff is particularly lower at the headwaters of the Niger River, positively impacting streamflow simulations and hindcast initializations. Compared to simulations without GRACE-DA, hindcasts are notably improved at locations draining from large basin areas, in particular, over the Niger River basin, which is consistent with GRACE's coarse spatial resolution. The long memory of groundwater and deep soil moisture, two main TWS components updated by GRACE-DA, is reflected in prolonged improvements in the streamflow hindcasts. Model accuracy at Niamey, Niger, the most populated city where streamflow observations are available, improved up to 33% during the flood season. These new findings directly contribute to ongoing developments in food security, flood potential forecast, and water-related disaster warning systems for Africa.

Augusto Getirana↗
NASA NTRS2019

Improving Surface Soil Moisture Estimates in West Africa Through GRACE Data Assimilation

Recent annual trends of precipitation and terrestrial water storage (TWS) in West Africa have been increasing over the past decade. Despite a significant impact of soil moisture on the TWS in West Africa, there is little research on the recent spatial and temporal behaviors of surface soil moisture (SSM) along with the hydrological trends and variability in West Africa. In this study, we assimilate TWS estimates from the Gravity Recovery and Climate Experiment (GRACE) mission into the Catchment Land Surface Model (CLSM) and evaluate its impacts on SSM simulations for the years, 2002–2017. The evaluation is performed using reference datasets: the African Monsoon Multidisciplinary Analysis (AMMA) in situ soil moisture observations, three currently available microwave satellite SSM observations from the Advanced Scatterometer (ASCAT), the Soil Moisture Ocean Salinity (SMOS), and the Soil Moisture Active Passive (SMAP) satellites and also the triple collocation analysis (TCA). Overall, modeled SSM shows good agreement with the reference datasets in terms of the anomaly SSM correlations. However, both modeled and ASCAT SSM are limited in their representation of the drying rates, as observed by ground observations, SMOS and SMAP estimates. Further, GRACE data assimilation results in improved SSM simulations in the humid regions with large annual TWS variability. This study demonstrates the utility of land data assimilation to inform hydrological conditions in West Africa, where soil moisture monitoring is necessary for water resource and livestock management.

West Africa↗
NASA NTRS2018

A Predictive Model for Lake Chad Total Surface Water Area Using Remotely Sensed and Modeled Hydrological and Meteorological Parameters and Multivariate Regression Analysis

Lake Chad is an endorheic lake in the Sahel region of Africa at the southern edge of the Sahara Desert. The lake, which is well known for its dramatic decrease in surface area during the 1970s and 1980s, experiences an annual flood resulting in a maximum total surface water area generally during February or March, though sometimes earlier or later. People along the shores of Lake Chad make their living fishing, farming, and raising livestock and have a vested interest in knowing when and how extensive the annual flooding will be, particularly those practicing recession farming in which the fertile ground of previously flooded area is used for planting crops. In this study, the authors investigate the relationship between lake and basin parameters, including rainfall, basin evapotranspiration, lake evapotranspiration, lake elevation, total surface water area, and the previous year’s total surface water area, and develop equations for each dry season month (except November) linking total surface water area to the other parameters. The resulting equations allow the user to estimate the December average monthly total surface water area of the lake in late November, and to make the estimates for January to May in early December. Based on the results of a Leave One Out Cross Validation analysis, the equations for lake area are estimated to have an average absolute error ranging from 5.3 percent (for February estimates) to 7.6 percent (for May estimates).

Lake Chad↗
NASA NTRS2018

Deriving Three Dimensional Reservoir Bathymetry from Multi-Satellite Datasets

We evaluate different techniques that rebuild reservoir bathymetry by combining multi-satellite imagery of surface water elevation and extent. Digital elevation models (DEMs) are processed in two distinct ways in order to determine 3-D reservoir bathymetry. They are defined as (a) linear extrapolation and (b) linear interpolation. The first one linearly extrapolates the land slope, defining the bottom as the intersection of all extrapolated lines. The second linearly interpolates the uppermost and lowermost pixels of the reservoir's main river, repeating the process for all other tributaries. A visible bathymetry, resulting from the combination of radar altimetry and water extent masks, can be coupled with the DEM, improving the accuracy of techniques (a) and (b). Envisat-and Altika-based altimetric time series is combined to a Landsat-based water extent database over the2002-2016 period in order to generate the visible bathymetry, and topography is derived from the 3-arcsecHydroSHEDS DEM. Fourteen 3-D bathymetries derived from the combination of these techniques and datasets, plus the inclusion of upstream and downstream riverbed elevations, are evaluated over Lake Mead. Accuracy is measured using ground observations, and show that metrics improve as a function of added data requirement and processing. Best bathymetry estimates are obtained when the visible bathymetry, linear extrapolation technique and riverbed elevation are combined. Water storage variability is also evaluated and shows that best results are derived from the aforementioned combination. This study contributes to our understanding and representation of reservoir water impoundment impacts on the hydrological cycle.

HydroSHEDS↗
NASA NTRS2017

Upper Blue Nile Basin Water Budget from a Multi-Model Perspective

Improved understanding of the water balance in the Blue Nile is of critical importance because of increasingly frequent hydroclimatic extremes under a changing climate. The intercomparison and evaluation of multiple land surface models (LSMs) associated with different meteorological forcing and precipitation datasets can offer a moderate range of water budget variable estimates. In this context, two LSMs, Noah version 3.3 (Noah3.3) and Catchment LSM version Fortuna 2.5 (CLSMF2.5) coupled with the Hydrological Modeling and Analysis Platform (HyMAP) river routing scheme are used to produce hydrological estimates over the region. The two LSMs were forced with different combinations of two reanalysis-based meteorological datasets from the Modern-Era Retrospective analysis for Research and Applications datasets (i.e., MERRA-Land and MERRA-2) and three observation-based precipitation datasets, generating a total of 16 experiments. Modeled evapotranspiration (ET), streamflow, and terrestrial water storage estimates were evaluated against the Atmosphere-Land Exchange Inverse (ALEXI) ET, in-situ streamflow observations, and NASA Gravity Recovery and Climate Experiment (GRACE) products, respectively. Results show that CLSMF2.5 provided better representation of the water budget variables than Noah3.3 in terms of Nash-Sutcliffe coefficient when considering all meteorological forcing datasets and precipitation datasets. The model experiments forced with observation-based products, the Climate Hazards group Infrared Precipitation with Stations (CHIRPS) and the Tropical Rainfall Measuring Mission (TRMM) Multi-Satellite Precipitation Analysis (TMPA), outperform those run with MERRA-Land and MERRA-2 precipitation. The results presented in this paper would suggest that the Famine Early Warning Systems Network (FEWS NET) Land Data Assimilation System incorporate CLSMF2.5 and HyMAP routing scheme to better represent the water balance in this region.

Rainfall↗
NASA NTRS2012

Calibration of Two-dimensional Floodplain Modeling in the Atchafalaya River Basin Using SAR Interferometry

Two-dimensional (2D) satellite imagery has been increasingly employed to improve prediction of floodplain inundation models. However, most focus has been on validation of inundation extent, with little attention on the 2D spatial variations of water elevation and slope. The availability of high resolution Interferometric Synthetic Aperture Radar (InSAR) imagery offers unprecedented opportunity for quantitative validation of surface water heights and slopes derived from 2D hydrodynamic models. In this study, the LISFLOOD-ACC hydrodynamic model is applied to the central Atchafalaya River Basin, Louisiana, during high flows typical of spring floods in the Mississippi Delta region, for the purpose of demonstrating the utility of InSAR in coupled 1D/2D model calibration. Two calibration schemes focusing on Manning s roughness are compared. First, the model is calibrated in terms of water elevations at a single in situ gage during a 62 day simulation period from 1 April 2008 to 1 June 2008. Second, the model is calibrated in terms of water elevation changes calculated from ALOS PALSAR interferometry during 46 days of the image acquisition interval from 16 April 2008 to 1 June 2009. The best-fit models show that the mean absolute errors are 3.8 cm for a single in situ gage calibration and 5.7 cm/46 days for InSAR water level calibration. The optimum values of Manning's roughness coefficients are 0.024/0.10 for the channel/floodplain, respectively, using a single in situ gage, and 0.028/0.10 for channel/floodplain the using SAR. Based on the calibrated water elevation changes, daily storage changes within the size of approx 230 sq km of the model area are also calculated to be of the order of 107 cubic m/day during high water of the modeled period. This study demonstrates the feasibility of SAR interferometry to support 2D hydrodynamic model calibration and as a tool for improved understanding of complex floodplain hydrodynamics

Hahn Chul Jung↗