Search NASA⌕ Search

Engineering topics

Haibin, Tang

Publications and source records attributed to Haibin, Tang.

Study of applied magnetic field magnetoplasmadynamic thrusters with particle-in-cell code with Monte Carlo collision. I. Computation methods and physical processes

A two-dimensional axisymmetric electromagnetic particle-in-cell code with Monte Carlo collision conditions has been developed for an applied-field magnetoplasmadynamic thruster simulation. This theoretical approach establishes a particle acceleration model to investigate the microscopic and macroscopic characteristics of particles. This new simulation code was used to study the physical processes associated with applied magnetic fields. In this paper (I), detail of the computation procedure and results of predictions of local plasma and field properties are presented. The numerical model was applied to the configuration of a NASA Lewis Research Center 100-kW magnetoplasmadynamic thruster which has well documented experimental results. The applied magnetic field strength was varied from 0 to 0.12 T, and the effects on thrust were calculated as a basis for verification of the theoretical approach. With this confirmation, the changes in the distributions of ion density, velocity, and temperature throughout the acceleration region related to the applied magnetic fields were investigated. Using these results, the effects of applied field on physical processes in the thruster discharge region could be represented in detail, and those results are reported.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Study of applied magnetic field magnetoplasmadynamic thrusters with particle-in-cell and Monte Carlo collision. II. Investigation of acceleration mechanisms

The particle-in-cell method previously described in paper (I) has been applied to the investigation of acceleration mechanisms in applied-field magnetoplasmadynamic thrusters. This new approach is an alternative to magnetohydrodynamics models and allows nonlocal dynamic effects of particles and improved transport properties. It was used to model a 100 kW, steady-state, applied-field, argon magnetoplasmadynamic thruster to study the physical acceleration processes with discharge currents of 1000-1500 A, mass flow rates of 0.025-0.1 g/s and applied magnetic field strengths of 0.034-0.102 T. The total thrust calculations were used to verify the theoretical approach by comparison with experimental data. Investigations of the acceleration model offer an underlying understanding of applied-field magnetoplasmadynamic thrusters, including the following conclusions: (1) swirl acceleration mechanism is the dominant contributor to the plasma acceleration, and self-magnetic, Hall, gas-dynamic, and swirl acceleration mechanisms are in an approximate ratio of 1:10:10:100; (2) the Hall acceleration produced mainly by electron swirl is insensitive to the change of externally applied magnetic field and shows only slight increases when the current is raised; (3) self-magnetic acceleration is normally negligible for all cases, while the gas-dynamic acceleration contribution increases with increasing applied magnetic field strength, discharge current, and mass flow rate.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Pulsed thrust measurements using electromagnetic calibration techniques

A thrust stand for accurately measuring impulse bits, which ranged from 10-1000 {mu}N s using a noncontact electromagnetic calibration technique is described. In particular, a permanent magnet structure was designed to produce a uniform magnetic field, and a multiturn coil was made to produce a calibration force less than 10 mN. The electromagnetic calibration force for pulsed thrust measurements was linear to the coil current and changed less than 2.5% when the distance between the coil and magnet changed 6 mm. A pulsed plasma thruster was first tested on the thrust stand, and afterward five single impulse bits were measured to give a 310 {mu}N s average impulse bit. Uncertainty of the measured impulse bit was analyzed to evaluate the quality of the measurement and was found to be 10 {mu}N s with 95% credibility.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗