Search NASA⌕ Search

Engineering topics

Hall, Thomas Wesley

Publications and source records attributed to Hall, Thomas Wesley.

Initial Conditioning of the Rod-style RFQ

The RFQ test stand will allow new sources to be tested and will provide information on the performance of our RFQ designs. The RFQ must sustain the high peak power that will be necessary for bunching and accelerating beam, and that peak power must be sustained at a duty factor that is higher than other facilities that use similar rod-style RFQs. The conditioning of the RFQ allows both requirements to be tested, and in addition the intricacies of its operation are discovered and can be corrected for future work. In addition, the conditioning procedure was able to be done concurrently with the source development.

43 PARTICLE ACCELERATORS↗

Improving Longitudinal Impedance of Inductive Inserts

Space charge compensation is essential to keeping the beam inside a ring such as PSR in the desired bunch form. The space charges of the ring will lead to the beam debunching, and the most prominent form of compensation for this is the use of RF to bunch the ring back. It has long been known however, that the impedance presented to the beam by its space charge could be compensated by a passive component. Such a passive component has been in use in PSR since 2000, but upgrading it could greatly improve the capabilities of the PSR. Additionally, the inserts presently used would require updating to match any changes in the beam pipe, both mechanically and to increase the space charge compensation.

43 PARTICLE ACCELERATORS↗

System study of the use of ferrite inductive inserts to improve beam in PSR

The effect of space charge has long been compensated in the PSR by offsetting the capacitive impedance of the ring with an inductive component. The effect of space charge will be discussed in detail as it pertains to rings in general, and the history of the use of the inductive insert in the PSR is also presented. An overview of ferrite properties is then provided, as well as methods for measuring ferrite properties, and several candidate ferrites are discussed. Finally, the considerations for designing an inductive insert will be fully presented.

43 PARTICLE ACCELERATORS↗

Window Test Stand Status and Future Work [Slides]

Challenges to getting the window test stand running that were addressed. Initial design of half-anchor connector was insufficient. Accommodation of non-Rexolite windows required engineering.

42 ENGINEERING↗

Emergence of Novel Multipactor Modes Under Standing Wave Conditions in a Coaxial Line With an RF Window

The multipactor (MP) phenomenon can generate exponentially increasing electron populations in RF vacuum systems, leading to components becoming damaged. This paper uses numerical methods to analyze an RF vacuum window in a coaxial line under various standing wave conditions. Our methods are first benchmarked against the analytic and experimental results for the traveling wave and the numerical results for standing waves that were found in previous work. Second, the effect of standing waves on electron motion in the axial direction is discussed and related to electron trajectories in the presence of an RF window. It is found that standing waves with the magnetic maximum located behind the RF window lead to window collisions that can affect MP depending on the power, frequency, and conductor radii. For a low number of window collisions, MP was highly predictable by earlier work, but as the percentage of collisions occurring on the window surpassed approximately 50%, a novel mode of MP emerged to dominate the phenomenon.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Reduction of Simulation Times for High-Q Structures using the Resonance Equation

Simulating steady state performance of high quality factor (Q) resonant RF structures is computationally difficult for structures with sizes on the order of more than a few wavelengths because of the long times (on the order of ~ 0.1 ms) required to achieve steady state in comparison with maximum time step that can be used in the simulation (typically, on the order of ~ 1 ps). This paper presents analytical and computational approaches that can be used to accelerate the simulation of the steady state performance of such structures. The basis of the proposed approach is the utilization of a larger amplitude signal at the beginning to achieve steady state earlier relative to the nominal input signal. Finally, the methodology for finding the necessary input signal is then discussed in detail, and the validity of the approach is evaluated.

43 PARTICLE ACCELERATORS↗