Engineering topics

Hall-Chen, V. H.

Publications and source records attributed to Hall-Chen, V. H..

3 records

DOE OSTI2024

Using convolutional neural networks to detect edge localized modes in DIII-D from Doppler backscattering measurements

In H-mode tokamak plasmas, the plasma is sometimes ejected beyond the edge transport barrier. These events are known as edge localized modes (ELMs). ELMs cause a loss of energy and damage the vessel walls. Understanding the physics of ELMs, and by extension, how to detect and mitigate them, is an important challenge. In this paper, we focus on two diagnostic methods—deuterium-alpha (D α ) spectroscopy and Doppler backscattering (DBS). The former detects ELMs by measuring Balmer alpha emission, while the latter uses microwave radiation to probe the plasma. DBS has the advantages of having a higher temporal resolution and robustness to damage. These advantages of DBS diagnostic may be beneficial for future operational tokamaks, and thus, data processing techniques for DBS should be developed in preparation. In sight of this, we explore the training of neural networks to detect ELMs from DBS data, using D α data as the ground truth. With shots found in the DIII-D database, the model is trained to classify each time step based on the occurrence of an ELM event. The results are promising. When tested on shots similar to those used for training, the model is capable of consistently achieving a high f1-score of 0.93. Furthermore, this score is a performance metric for imbalanced datasets that ranges between 0 and 1. We evaluate the performance of our neural network on a variety of ELMs in different high confinement regimes (grassy ELM, RMP mitigated, and wide-pedestal), finding broad applicability. Beyond ELMs, our work demonstrates the wider feasibility of applying neural networks to data from DBS diagnostic.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2022

Evaluation of a new DIII-D Doppler backscattering system for higher wavenumber measurement and signal enhancement

The high density fluctuation poloidal wavenumber, k θ (k θ > 8 cm –1 , k θ ρ s > 5, ρs is the ion gyro radius using the ion sound velocity), measurement capability of a new Doppler backscattering (DBS) system at the DIII-D tokamak has been experimentally evaluated. In DBS, wavenumber (k) matching becomes more important at higher wavenumbers, owing to the exponential dependence of the measured signal loss factor on wave vector mismatch. Wave vector matching allows for the Bragg scattering condition to be satisfied, which minimizes the signal loss at higher k’s. In the previous DBS system, without toroidal wave vector matching, the measured DBS signal-to-noise ratio at higher k θ (>8 cm –1 ) is substantially reduced, making it difficult to measure higher k θ turbulence. The new DBS system has been optimized to access higher wavenumber, k θ ≤ 20 cm –1 , density turbulence measurement. The optimization hardware addresses fluctuation wave vector matching using toroidal steering of the launch mirror to produce a backscattered signal with improved intensity. The probe’s sensitivity to high-k density fluctuations has been increased by approximately an order of magnitude compared to the old system that has been in use at DIII-D. Note that typical measurement locations are above or below the tokamak midplane on the low field side with normalized radial ranges of 0.5–1.0. As a result, the new DBS probe system with the toroidal matching of fluctuation wave vectors is thought to be critical to understanding high-k turbulent transport in fusion-relevant research at DIII-D.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2022

Interpreting radial correlation Doppler reflectometry using gyrokinetic simulations

A linear response, local model for the DBS amplitude applied to gyrokinetic simulations shows that radial correlation Doppler reflectometry measurements (RCDR, Schirmer et al 2007 Plasma Phys. Control. Fusion 49 1019) are not sensitive to the average turbulence radial correlation length, but to a correlation length that depends on the binormal wavenumber $k_{\perp}$ selected by the Doppler backscattering (DBS) signal. Nonlinear gyrokinetic simulations show that the turbulence naturally exhibits a nonseparable power law spectrum in wavenumber space, leading to a power law dependence of the radial correlation length with binormal wavenumber $l_r \sim C k_{\perp}^{-\alpha} (\alpha \approx 1)$ which agrees with the inverse proportionality relationship between the measured $l_r$ and $k_{\perp} $ observed in experiments (Fernández-Marina et al 2014 Nucl. Fusion 54 072001). This new insight indicates that RCDR characterizes the eddy aspect ratio in the perpendicular plane to the magnetic field. It also motivates future use of a nonseparable turbulent spectrum to quantitatively interpret RCDR and potentially other turbulence diagnostics. The radial correlation length is only measurable when the radial resolution at the cutoff location $W_\text n$ satisfies $W_\text n \ll l_r$, while the measurement becomes dominated by $W_\text n$ for $W_\text n \gg l_r$. This suggests that $l_r$ is likely to be inaccessible for electron-scale DBS measurements (${k_{\perp}}{\rho_{\text s}} \gt 1$). The effect of $W_\text n$ on ion-scale radial correlation lengths could be nonnegligible.

radial correlation Doppler reflectometry↗