Fe 2 P-decorated N,P Codoped Carbon Synthesized via Direct Biological Recycling for Endurable Sulfur Encapsulation
Not Available
37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
Engineering topics
Han, Bin
Publications and source records attributed to Han, Bin.
Aerosol Impacts on Mesoscale Convective Systems Forming Under Different Vertical Wind Shear Conditions
Following our previous study of wind shear effect on mesoscale convective system (MCS) organization under a clean atmospheric condition using the Weather Research and Forecasting model coupled with Spectral-Bin Microphysics, we conduct sensitivity simulations by increasing cloud condensation nuclei (CCN) concentration and investigate aerosol impacts on MCSs forming under different wind shear conditions. We find that, aerosols induce stronger updrafts and downdrafts in all MCSs. The stronger updrafts and enlarged convective core area contribute to larger vertical mass fluxes and enhance precipitation, indicating convective invigoration. Increased updraft speed below 8-km altitude mainly results from enhanced condensational heating, and increased water loading effect is not large enough to overcome the increase in thermal buoyancy. Interestingly, above 8-km altitude we see reduced updraft speed by the increased aerosols due to reduced vertical pressure perturbation gradient force, and weakened depositional growth due to competition of water vapor by enhanced condensation. The accumulated rainfall and mean rain rate are increased, with an increased occurrence frequency of heavy rain. The increase of rain rate is seen in both convective and stratiform regions, with a more significant increase in convective rain rate. In general, we see a higher frequency of deep convective cloud in the polluted condition because of invigorated convection, and more stratiform/anvil clouds, but a lower frequency of shallow warm clouds. The unanimously invigorated MCSs by aerosols under various wind shear conditions revealed by this study has an important implication in weather and climate at warm and humid regions that are influenced by pollution.
54 ENVIRONMENTAL SCIENCES↗
Simulating a Mesoscale Convective System Using WRF with a New Spectral Bin Microphysics: Part 1: Hail vs Graupel
A modified Fast Spectral Bin Microphysics scheme (FSBM-2) embedded into the Weather Research and Forecasting Model (WRF) is used to simulate a mesoscale deep convective system observed during the Midlatitude Continental Convective Clouds Experiment (MC3E). FSBM-2 uses modified source codes as compared to the current FSBM (FSBM-1). In contrast to FSBM-1, FSBM-2 can simulate hail of several cm in diameter and includes additional processes such as spontaneous breakup of raindrops and aerosol regeneration by drop evaporation. It is shown that allowing large hail particles of diameters exceeding about 1 cm substantially increases the agreement between the simulated and observed squall-line structures both in the convective and stratiform regions. In contrast, if graupel particles are used to represent high-density hydrometeors in convective areas, the ratio of convective-to-stratiform areas diverges from the ratio seen in observations and maximum radar reflectivities are substantially underestimated. Analysis of snow size distributions in the stratiform area shows an important link between the ice crystals formed by homogeneous freezing in the convective area to ice particle number concentration in the stratiform region. Simulated raindrop size distributions in the stratiform area below the melting level from FSBM-2 show a good agreement with observations. The regeneration of CCN by droplet evaporation and detrainment of these CCN to the stratiform region increases the concentration of CCN there up to 8-9 km altitude; the additional CCN penetrate clouds and produce new droplets, leading to some convection intensification. Key words: Mesoscale convective systems (MCS), squall lines, spectral bin microphysics, large hail, in-cloud nucleation, size distributions of hydrometeors in MCS.
Shpund, Kobby↗