Hannes Schniepp | Search NASA

NASA NTRSDate not supplied

TPSAS-NF1676L-31522-DND

Currently, there are limitations in launch capability regarding requisite payload volume and mass for long duration extra-terrestrial missions. In-space additive manufacturing may provide a solution to this challenge and is applicable for articles ranging from large system and subsystem architectures to small consumables and replacement articles. For small articles, additive manufacturing is becoming more feasible through advances in instrumentation and novel manufacturing strategies capable of generating complex shapes. Many approaches, however, utilize feedstock materials that, once consumed, must be replenished before additional architectures can be generated. Thus, although promising, a major challenge with additive manufacturing is the required starting materials to support on-demand article generation. This presentation describes research toward reversibly assembling materials that can revert to the starting material state for subsequent fabrication. Polyimides were synthesized with thermally reversible Diels-Alder reaction functionalities, furan or maleimide moieties. These materials were characterized utilizing typical spectroscopic, thermal, and mechanical techniques. Amine hardener-enriched epoxy microparticles were synthesized for use as a mechanically robust substrate. Integration of these technologies into a single system and application toward generation of secondary structures on a launch vehicle as a means of in-situ resource utilization will be described.

Christopher J. Wohl↗

NASA NTRSDate not supplied

Computationally Guided Design of Polymer-Coated Microparticles as Reusable Materials

Long-duration space exploration missions and sustained lunar or Martian surface operations present greater demands for multifunctional and reusable materials. By scaling down the amount of material to be launched from Earth, both mission cost and risk can be reduced. In this regard, leveraging in-space manufacturing capabilities with reusable feedstock materials is an attractive option, as it will allow for articles to be generated on demand, utilized, and then recycled for additional use. NASA’s Enabling Sustained Presence Using Recyclables (ESPUR) project aims to develop reusable materials using polymer-coated microparticles that are bonded via reversible Diels-Alder reactions, where only modest heat is needed to trigger the reverse reaction and enable reuse. For proof-of-concept demonstration, research is currently focused on the fabrication of epoxy microparticles that contain a copoly(carbonate urethane) coating with maleimide and furan functionalities. Here, we discuss the integration of computational materials modeling approaches to help navigate the large design space in this development effort. We perform molecular dynamics (MD) simulations with atomistic and coarse-grained models of the copolymer, which allow us to evaluate the effects of design parameters like the molecular weight and composition on the molecular interactions and chain dynamics. We show how the properties change with the reversible bonds. We also leverage discrete element method (DEM) simulations to assess how microparticle design parameters like the size ratio and volume fraction can be tuned to increase the packing density and number of microparticle contacts to improve the mechanical properties. Our results demonstrate how computational tools can be used in close collaboration with experimental efforts to accelerate material design.

reusable materials↗