Search NASA⌕ Search

Engineering topics

Hansen, Arthur G

Publications and source records attributed to Hansen, Arthur G.

14 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1956

Aerodynamic Design of Axial-flow Compressors. Volume III

Chapters XI to XIII concern the unsteady compressor operation arising when compressor blade elements stall. The fields of compressor stall and surge are reviewed in Chapters XI and XII, respectively. The part-speed operating problem in high-pressure-ratio multistage axial-flow compressors is analyzed in Chapter XIII. Chapter XIV summarizes design methods and theories that extend beyond the simplified two-dimensional approach used previously in the report. Chapter XV extends this three-dimensional treatment by summarizing the literature on secondary flows and boundary layer effects. Charts for determining the effects of errors in design parameters and experimental measurements on compressor performance are given in Chapters XVI. Chapter XVII reviews existing literature on compressor and turbine matching techniques.

COMPRESSORS - PRESSURE RATIO↗
NASA NTRS1955

A survey of unclassified axial-flow-compressor literature

A survey of unclassified axial-flow-compressor literature is presented in the form of brief reviews of the methods, results, and conclusions of selected reports. The reports are organized into several main categories with subdivisions, and frequent references are made within the individual reviews to pertinent material elsewhere in the survey.

Herzig, Howard Z↗
NASA NTRS1954

A Visualization Study of Secondary Flows in Cascades

Flow-visualization techniques are employed to ascertain the streamline patterns of the nonpotential secondary flows in the boundary layers of cascades, and thereby to provide a basis for more extended analyses in turbomachines. The three-dimensional deflection of the end-wall boundary layer results in the formation of a vortex within each cascade passage. The size and tightness of the vortex generated depend upon the main-flow turning in the cascade passage. Once formed, a vortex resists turning in subsequent blade rows, with consequent unfavorable angles of attack and possible flow disturbances on the pressure surfaces of subsequent blade rows when the vortices impinge on these surfaces. Two major tip-clearance effects are observed, the formation of a tip-clearance vortex and the scraping effect of a blade with relative motion past the wall boundary layer. The flow patterns indicate methods for improving the blade tip-loading characteristics of compressors and of low- and high-speed turbulence.

Herzig, Howard Z↗
NASA NTRS1953

Smoke Studies of Secondary Flows in Bends, Tandem Cascades, and High-turning Configurations

Flow-visualization studies, using smoke, were made of the secondary flows in rectangular bends, tandem cascades, and high-turning configurations. The roll-up of the wall boundary layer of a rectangular bend forms a passage vortex near the suction surface similar to that previously observed for cascades. The vortex so formed then shifts out into the main stream. Because of leading-edge effects, the boundary-layer flows in bends were found to be sufficiently different from the flows in blade rows to make direct application of bend results to blade rows inadvisable. Passage vortices are shown, in the tandem-cascade study, to resist turning with the main stream through which they pass and to disturb the flow in subsequent blade rows. This disturbance may explain in part the appreciable size of the losses sometimes attributed to secondary flows in turbomachines despite the fact that the energy involvement in vortex formation is slight. Tip-flow studies of high-turning blades with relative motion between blades and end wall indicated that if the relative sizes of the passage vortex forces, the tip clearance forces, and the blade-scraping effects are properly controlled, it may be possible to improve the blade-tip loading characteristics in turbomachine.

CASCADES↗