Active control of interior noise in model aircraft fuselages using piezoceramic actuators
Explore the source record for details and available documents.
Fuller, C. R.↗
Engineering topics
Hansen, C. H.
Publications and source records attributed to Hansen, C. H..
Active control of sound radiation from a vibrating rectangular panel by sound sources and vibration inputs - An experimental comparison
Active control of sound radiation from a rectangular panel by two different methods has been experimentally studied and compared. In the first method a single control force applied directly to the structure is used with a single error microphone located in the radiated acoustic field. Global attenuation of radiated sound was observed to occur by two main mechanisms. For 'on-resonance' excitation, the control force had the effect of increasing the total panel input impedance presented to the nosie source, thus reducing all radiated sound. For 'off-resonance' excitation, the control force tends not significantly to modify the panel total response amplitude but rather to restructure the relative phases of the modes leading to a more complex vibration pattern and a decrease in radiation efficiency. For acoustic control, the second method, the number of acoustic sources required for global reduction was seen to increase with panel modal order. The mechanism in this case was that the acoustic sources tended to create an inverse pressure distribution at the panel surface and thus 'unload' the panel by reducing the panel radiation impedance. In general, control by structural inputs appears more effective than control by acoustic sources for structurally radiated noise.
Fuller, C. R.↗
Active control of interior noise in model aircraft fuselages using piezoceramic actuators
Active control of interior noise in model aircraft fuselages using piezoceramic actuators is experimentally studied. The actuators are bonded directly to the structure and error information is taken from up to two microphones located in the interior acoustic field. The results demonstrate that global attenuation of the order of 10 to 15 dB of interior noise can be achieved with piezoceramic actuators, irrespective of whether the shell system is vibrating at an acoustic or structural resonant frequency. The work also proves that active control using vibration (moment) inputs works well when a floor simulating that of an aircraft is installed in the model. This result suggests that the technique will be successful in controlling interior noise in realistic aircraft structures.
Fuller, C. R.↗
An experimental investigation of the active control of sound transmission into a cylindrical enclosure
Preliminary results are reported from experiments involving the use of vibration sources in the active control of sound transmission into a cylindrical chamber (as in aircraft cabin-noise suppression). Electrodynamic shakers are used to provide vibrational excitation in a 3-m-high 900-mm-diameter cylindrical stainless-steel chamber with damped ends, subjected to single-frequency (384-Hz) sound from a horn driver located 150 mm from the cylinder midway along its length. When vibration is applied only diametrically opposite the source, rotation of the sound field occurs, but global attenuation is not achieved; with additional vibration applied at an angle of 225 deg to the source, moderate reduction of the global field is obtained. The need to identify and control all offending coupled structural/acoustic modes is indicated.
Snyder, S. D.↗