Engineering topics

Hansen, L. E.

Publications and source records attributed to Hansen, L. E..

7 records

DOE OSTI2024

Atomic structure and melting of Ni and Fe 36 Ni up to 400 GPa

Iron, nickel and its alloys are critically important materials for industrial and technological applications due to their unique magnetic properties, strength, and thermal expansion. In this study, lasers were used to compress and heat Fe 36 Ni alloy (36 wt% Ni) and pure nickel up to the melting temperature using a combination of shock and ramp compression. The structure was measured using nanosecond in-situ x-ray diffraction, and simultaneous velocimetry was used to measure the pressure up to 454 GPa. A mixed face-centered-cubic (fcc) solid–liquid phase in Fe 36 Ni at 311 GPa provides experimental evidence that, compared to pure iron, the incorporation of nickel expands the stability field of the fcc phase to the melting curve. At lower temperatures, a mixed fcc and hexagonal-close-packed (hcp) phase is observed in ramp-compressed Fe 36 Ni at 278 GPa. At the higher compressions, a structure inconsistent with fcc, hcp, and body-centered cubic (bcc) is observed. In the case of pure Ni, the fcc phase is stable under ramp compression up to 402 GPa.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

DOE OSTI2024

Sound speed and Grüneisen parameter up to three terapascal in shock-compressed iron

This paper presents the first sound speed and Grüneisen parameter data for fluid iron compressed to 3 TPa (30 million atmospheres) and 20 g/cm 3 on the Hugoniot. Both the sound speed and Grüneisen parameter are derivatives of the equation of state (EOS), and thus tightly constrain the contours of the EOS surface. The sound speed data are systematically lower than expected from a simple extrapolation of previous data. The Grüneisen parameter shows a 30% drop at pressures and temperatures above the melt transition. Furthermore, while some models compare well with either the sound speed or Grüneisen parameter, none of today’s state-of-the-art models can explain both sets of data. Furthermore these new data will provide pivotal benchmarks for both future theoretical EOSs of warm dense iron and modeling planetary states and processes.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

DOE OSTI2024

Evidence for dissociation in shock-compressed methane

Theory and experiments show that with increasing pressure, the chemical bonds of methane rearrange, leading to the formation of complex polymers and then to dissociation. However, there is disagreement on the exact conditions where these changes take place. In this study, methane samples were precompressed in diamond-anvil cells and then shock compressed to pressures reaching 400 GPa, the highest pressures yet explored in methane. Furthermore, the results reveal a qualitative change in the Hugoniot curve at 80-150 GPa, which is interpreted as a signature of dissociation based on thermodynamic calculations and theoretical predictions.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

DOE OSTI2023

A flexible polymer-based luminescent ink for combined thermographic phosphors and digital image correlation (TP+DIC)

Recent work on the development of integrated thermographic phosphors and digital image correlation (TP+DIC) for combined thermal–mechanical measurements has revealed the need for a flexible, stretchable phosphor coating for metal surfaces. Herein, we coat stainless steel substrates with a polymer-based phosphor ink in a DIC speckle pattern and demonstrate that the ink remains well bonded under substrate deformation. In contrast, a binderless phosphor DIC coating produced via aerosol deposition (AD) partially debonded from the substrate. DIC calculations reveal that the strain on the ink coating matches the strain on the substrate within 4% error at the highest substrate loads (0.05 mm/mm applied substrate strain), while the strain on the AD coating remains near 0 mm/mm as the substrate deforms. Spectrally resolved emission from the phosphor is measured through the transparent binder throughout testing, and the ratio method is used to infer temperature with an uncertainty of 1.7 °C. In conclusion, this phosphor ink coating will allow for accurate, non-contact strain and temperature measurements of a deforming surface.

36 MATERIALS SCIENCE↗

DOE OSTI2022

Shocked silica aerogel radiance transition

Silica (SiO 2 ) aerogel is widely used in high-energy-density shock experiments due to its low and adjustable density. Reported here are measurements of the shock velocity, optical radiance, and reflectivity of shocked SiO 2 aerogel with initial densities of 0.1, 0.2, and 0.3 g/cm 3 . These results are compared with similar data from three solid polymorphs of SiO 2 , silica, quartz, and stishovite with initial densities 2.2, 2.65, and 4.3 g/cm 3 , respectively. Interestingly, below a brightness temperature of T bright ≈ 35,000 K, the slope of the radiance vs shock velocity is the same for each of the SiO 2 aerogels and solid polymorphs. At T bright ≈ 35000 K, there is an abrupt change in the radiance vs shock velocity slope for aerogels, but not seen in the solid polymorphs over the pressures and temperatures explored here. An empirical model of shock front radiance as a function of SiO 2 density and laser drive parameters is reported to aid in the design of experiments requiring maximum shock front radiance.

42 ENGINEERING↗

DOE OSTI2022

Energy dispersive x-ray diffraction of luminescent powders: A complement to visible phosphor thermometry

Energy-dispersive x-ray diffraction of thermographic phosphors has been explored as a complementary temperature diagnostic to visible phosphor thermometry in environments where the temperature-dependent optical luminescence of the phosphors is occluded. Powder phosphor samples were heated from ambient to 300°C in incremental steps and probed with polychromatic synchrotron x rays; scattered photons were collected at a fixed diffraction angle of 3.9°. Crystal structure, lattice parameters, and coefficients of thermal expansion were calculated from the diffraction data. Finally, of the several phosphors surveyed, YAG:Dy, ZnO:Ga, and GOS:Tb were found to be excellent candidates for diffraction thermometry due to their strong, distinct diffraction peaks that shift in a repeatable and linear manner with temperature.

47 OTHER INSTRUMENTATION↗

DOE OSTI2021

Melting of magnesium oxide up to two terapascals using double-shock compression

Constraining the melting behavior of magnesium oxide, a major constituent of gaseous and rocky planets, is key to benchmarking their evolutionary models. Using a double-shock technique, we extended the MgO melt curve measurements to 2 TPa; this is twice the pressure achieved by previous melting experiments on any material. A temperature plateau is observed between 1218 and 1950 GPa in the second shock states, which is attributed to latent heat of melting. At 1950 GPa, the measured melting temperature is 17,600 K, 17% lower than recent theoretical predictions. Furthermore, the melting curve is steeper than that of MgSiO 3 , indicating that MgO is likely solid in the interior of Saturn-sized gas giants and extra-solar super-Earth planets.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗