Search NASA⌕ Search

Engineering topics

Hanson, Susan Meriel Kloek

Publications and source records attributed to Hanson, Susan Meriel Kloek.

A new method for quantifying 64 Cu in nuclear debris samples

Quantifying 64 Cu in post-detonation nuclear debris samples can provide important diagnostic information regarding the structural materials used within a nuclear device. However, this task is challenging due to the weak gamma emissions associated with the decay of 64 Cu, its short half-life (12.701 h), and the presence of interfering fission product radioisotopes. Large quantities of debris sample are generally needed to accurately quantify 64 Cu, which can be problematic in sample-limited scenarios where other radiometric analyses are required. Herein, we present a new method for the separation of 64 Cu from solutions of mixed fission products and demonstrate the quantification of its activity through use of gas-flow proportional beta counting. Here, the new method was validated through a series of rigorous tests and was shown to improve the detection limit of 64 Cu by over two orders of magnitude, from 2.5 × 10 6 to 1.3 × 10 4 atoms/sample for 100 min measurements.

38 RADIATION CHEMISTRY, RADIOCHEMISTRY, AND NUCLEA↗

Chemical separation and measurement of platinum activation products

Here, a method has been developed to purify and measure platinum radioisotopes in the presence of fission products and environmental constituents. The method uses a combination of cation exchange and anion exchange chromatography and selective precipitation steps to remove other radioisotopes from the sample. The addition of stable platinum carrier allows for a gravimetric determination of the chemical yield of the procedure. Overall, the method is fast, simple, and potentially applicable for rapid turnaround of unknown samples. Using this method, multiple platinum radioisotopes were measured in two different irradiation experiments. The measured ratios of the platinum radioisotopes clearly reflect the neutron spectrum of the irradiation, suggesting that platinum radioisotopes could be valuable signatures in nuclear forensic analyses.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Measurement of Mass-Independent Perturbations of Cadmium in Nuclear Debris Samples

The isotopic composition of cadmium in nuclear debris was measured by multi-collector inductively coupled plasma-mass spectrometry (MC-ICP-MS). Mass-independent perturbations due to fission product decay on the isotopes of Cd were observed. Relative fission yields for masses 111, 112, 114 and 116 were determined in each sample of nuclear debris and compared with reported values found in irradiated plutonium and uranium fuels. Mass spectrometry measurements of the valley fission product endpoints are extremely challenging due to the low cumulative fission yields and small amounts of each isotope that are produced. To overcome these challenges, a new purification method for Cd was developed and validated by examination of a number of geological reference materials.

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗

Analysis of a Bulk 237 Np Oxide Sample for Trace Actinides

A neptunium oxide sample was dissolved and trace actinide constituents were measured by isotope dilution ICP-MS (for 239–244 Pu, 233–238 U, 237 Np, 241–243 Am) and alpha spectrometry ( 238 Pu, 242 Cm, 244 Cm). This material contained significant quantities of transuranic elements, notably americium and curium. The isotopic composition of the material will continue to evolve over time due to radioactive decay; the measurements reported here include all isotopes decay corrected to a reference date of 1/1/2022. These factors may be considerations in criticality studies of the related 237 Np sphere.

38 RADIATION CHEMISTRY, RADIOCHEMISTRY, AND NUCLEA↗

Measuring Signatures of Fuel Irradiation in Large Particle Samples

Understanding the operating history of a nuclear facility is one of the key goals in nuclear safeguards, enabling the verification of declared activities. This is accomplished via a number of mechanisms, including the analysis of samples collected at the facility. The best metrics for understanding and verifying the history of nuclear fuel are (1) actinide isotopic content and (2) actinide inter-element ratios. While techniques have long existed for measuring these values with high accuracy and precision in bulk samples, as samples become smaller – such as may be collected in environmental collection – new methods are required both for clean processing of pure samples, and for analysis of these small samples. This study describes a new extraction chromatography technique for recovering U, Pu, and Am from single small aliquots, and advanced mass spectrometry methods for high-precision and high-accuracy analysis of trace and ultra-trace levels of actinides. These techniques are applied to particle samples cut from fuel from a historic nuclear reactor. Ages calculated from Pu–Am chronometry of particles are in excellent agreement with the known operating history of the reactor.

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗

Measurements of Extinct Radionuclides in Filter Paper Samples

Radiochemical diagnostics rely on measurements of short-lived fission product isotopes. Once months to years have passed since isotope formation, the most useful short-lived signatures have decayed away and become extinct. Recent work at our lab has developed new methods to reconstruct the concentrations of extinct radionuclides using mass spectrometry to measure the stable daughter elements formed from radioactive decay. However, the applicability of these techniques to different types of samples has not been fully investigated.

38 RADIATION CHEMISTRY, RADIOCHEMISTRY, AND NUCLEA↗

June 2019 Depleted Uranium Irradiation

Three different irradiations were performed at the Annular Core Research Reactor (ACRR) at Sandia National laboratory on June 4-6, 2019. Each target assembly included two or three depleted uranium targets, as well as a bismuth target and dosimetry packets. In July 2019, the target assemblies were received at TA-48 RC-1, unpackaged, and radiochemical analyses were performed. The analyses included autoradiography and gamma counting of the whole depleted uranium targets, gamma counting of the activation foils, and dissolution of six of the depleted uranium targets, followed by separated radiochemical analysis for a suite of fission products. This report describes the details of the radiochemical analysis and provides final results for the fission and activation product concentrations.

38 RADIATION CHEMISTRY, RADIOCHEMISTRY, AND NUCLEA↗

Final Results for 99 Mo, 111 Ag, 147 Nd, 140 Ba

Seven depleted uranium targets were irradiated at the ACRR reactor in three different irradiations occurring on June 4th, 5th, and 6th, 2019. The targets were received at LANL on July 10, 2019, unpackaged, and analyzed by autoradiography and gamma-ray spectrometry. Table 1 shows a chart of the Target ID, target mass, time the irradiation occurred, and the corresponding LANL sample ID. Six of the targets were dissolved and chemically separated radiochemical analyses were performed for a suite of radionuclides on four of the targets. The final results of the radiochemical separation and analysis of 99 Mo, 111 Ag, 147 Nd and 140 Ba for depleted U samples 4416-01, 4417-01, 4418-01 and 4418-03 are presented in Table 2. Associated errors represent 1σ uncertainty.

38 RADIATION CHEMISTRY, RADIOCHEMISTRY, AND NUCLEA↗