Search NASA⌕ Search

Engineering topics

Hao, Ming

Publications and source records attributed to Hao, Ming.

11 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2024

Electrical Conductivity and Sound Velocities of Talc Under High Pressure and High Temperature Conditions and Application to the Subducting Cocos Plate

Talc is expected to be an important water carrier in Earth's upper mantle, and understanding its electrical and seismic properties under high pressure and temperature conditions is required to detect possible talc-rich regions in subduction zones imaged using geophysical observations. Here, we conducted acoustic and electrical experiments on natural talc aggregates at relevant pressure-temperature conditions. Compressional wave velocity (V p ) was measured using ultrasonic interferometry in a Paris-Edinburgh press at pressures up to 3.4 GPa and temperatures up to 873 K. Similar Vp values are obtained regardless of the initial crystallographic preferred orientation of the samples, which can be explained by talc grain reorientation during the experiment, with the (001) plane becoming perpendicular to the uniaxial compression axis. Electrical conductivity of the same starting material was determined using impedance spectroscopy in a multi-anvil press up to 6 GPa and 1263 K. Two conductivity jumps are observed, at ∼860–1025 K and ∼940–1080 K, depending on pressure, and interpreted as talc dehydroxylation and decomposition, respectively. Electrical anisotropy is observed at low temperature and decreases with increasing pressure (∼10 at 1.5 GPa and ∼2 at 3.5 GPa). Comparison of acoustic and electrical results with geophysical observations in central Mexico supports the presence of a talc-bearing layer atop the subducted Cocos plate.

Cocos plate↗
DOE OSTI2024

The ultralow viscosity of volatile-rich kimberlite magma: Implications for the water content of primitive kimberlite melts

The eruption of deeply sourced kimberlite magma offers the fastest route to bring deep-seated volatiles back to the Earth’s surface. However, the viscosity of kimberlite magma, a factor governing its migration and eruption dynamics within Earth, remains poorly constrained. We conducted synchrotron in situ falling sphere viscometry experiments to examine kimberlite magma with different volatile contents (0 to 5 wt % H 2 O and 2 to 8 wt % CO 2 ) under high pressure-temperature conditions. The results reveal that the viscosity of volatile-rich kimberlite magma is ~1 to 2 orders lower than that of mid-ocean ridge basalt (MORB) and comparable to the ultramobile pure carbonate melt. Using the measured viscosity values, we simulated the ascent and eruption process of kimberlite magma. We found that a minimum content of ~0.5 wt % water in the primitive magma is necessary to allow the ultrafast eruption process of kimberlite, thereby enabling the preservation of diamonds and high-pressure mineral inclusions transported by the magma.

58 GEOSCIENCES↗
DOE OSTI2024

Migration and accumulation of hydrous mantle incipient melt in the Earth's asthenosphere: Constraints from in-situ falling sphere viscometry measurements

The Earth's oceanic lithosphere-asthenosphere boundary (LAB) is marked by a notable decrease in seismic wave velocities and an increase in attenuation. This phenomenon is likely attributed to the accumulation of partial melt at the top of the asthenosphere. Nevertheless, the process involving the upward migration and aggregation of low-degree partial melts, highly likely to be mantle incipient melts in the asthenosphere, remains underexplored. Viscosity is a key factor controlling the flow of melts, thus in this study, we used In-situ X-ray falling sphere viscometry experiments to determine the viscosity of the mantle incipient melt containing 1.8–4.0 wt.% water at 1.5–6 GPa and 2100 K. We found that water and pressure can effectively decrease the viscosity of the mantle incipient melt. Therefore, the mantle incipient melts are highly mobile with a high segregation velocity in the deeper part of the asthenosphere. However, during ascent, their mobility diminishes due to an increase in viscosity and a decrease in water content. In conclusion, these mechanisms potentially contribute to the accumulation of partial melt at the top of the asthenosphere.

58 GEOSCIENCES↗
DOE OSTI2024

Fast Seismic Anomalies Under Continents Explained by the Delaminated Lower Continental Crust—Implications From High Pressure‐Temperature Elasticity of Jadeite

Seismic tomography has shown that the shear wave velocities (Vs) under continents, especially under cratons, are extremely fast at 100–200 km depth, which is difficult to explain by low temperatures or high Mg#. Alternatively, delaminated eclogitic lower continental crust has been proposed to account for these fast seismic anomalies. However, the thermoelastic properties of jadeite which constitutes up to 60–80 mol% of clinopyroxene in the potentially delaminated lower continental crust are not well constrained. In this study, we measured the single-crystal elasticity of jadeite by Brillouin spectroscopy under simultaneous high pressure and temperature conditions for the first time. We found that the temperature dependence of Vs of jadeite is extremely small if not negligible. The seismic velocities of the potentially delaminated lower continental crusts were subsequently modeled and found to match the widely observed fast seismic anomalies under cratons between 100 and 200 km depth.

Geology↗
DOE OSTI2024

Acoustic and electrical properties of Fe-Ti oxides with application to the deep lunar mantle

The overturn of titanium-rich mantle cumulates has been invoked to explain the structure and dynamics of the Moon. These dense cumulates are stable at the core-mantle boundary (CMB) and could explain field observations inferred from geophysical studies. Here, we report acoustic and electrical experiments on natural ilmenite-rutile aggregates up to 4.5 GPa and 1920 K. Seismic velocities show a weak pressure and temperature dependence, with Vs ~ 4.2 (+/-0.2) km/s and Vp ~8.0 (+/-0.2) km/s at the CMB conditions. Conductivity increases by a factor of 10 4 from 373 to 1920 K and is >10(3) S/m above 1573 K. Seismic and electrical models for the lunar mantle based on our results, considering mixtures of Fe-Ti oxides and olivine, indicate that field velocity and conductivity estimates are reproduced satisfactorily with 3-16 vol.% Fe-Ti oxides and 20 vol.% melt. Interactions between a Ti-rich, melt-bearing layer and the adjacent core likely affect the cooling and magnetic history of the Moon.

58 GEOSCIENCES↗
DOE OSTI2023

Boron adsorption in clay minerals: Implications for martian groundwater chemistry and boron on Mars

Boron has been detected on Mars in calcium-sulfate veins found within clay mineral rich rocks on Mars by the Mars Science Laboratory (MSL) Curiosity rover using Laser Induced Breakdown Spectroscopy (LIBS) analysis. Borates play a vital role in stabilizing ribose on Earth and has been suggested as a key requirement for life. Borate ions readily adsorb to phyllosilicate clay minerals. The discovery of boron on Mars in proximity to phyllosilicate-bearing bedrock may have strong implications for potential past prebiotic conditions on Mars. In this study we generated a suite of clay minerals with adsorbed borate, including both typical terrestrial clay minerals (montmorillonite) and Mars-analog clay minerals (nontronite, saponite, griffithite), to understand controls on borate adsorption and to analyze with LIBS to compare with MSL data. Clay minerals were subjected to mineralogical and chemical analysis before and after adsorption. Adsorption analysis revealed that the Mars analog clay minerals adsorbed less boron than terrestrial counterparts, but within comparable amounts to those detected on Mars and in meteorites. Post-adsorption analysis by X-ray diffraction (XRD) revealed slight changes in the interlayer spacing of many of the clay minerals. Based on the adsorption analysis of the Mars-analog clay minerals, phyllosilicate-bearing bedrock in Gale crater may contain up to 90-110 ppm B. A series of borate-enriched samples were created for analysis of LIBS spectra from ChemCam on the Curiosity rover and SuperCam on the Perseverance Rover. Finally, the results of this study may provide insight into martian groundwater geochemistry processes and the mobility of a key molecule connected with life.

58 GEOSCIENCES↗
DOE OSTI2022

Constraining composition and temperature variations in the mantle transition zone

The mantle transition zone connects two major layers of Earth’s interior that may be compositionally distinct: the upper mantle and the lower mantle. Wadsleyite is a major mineral in the upper mantle transition zone. Here, we measure the single-crystal elastic properties of hydrous Fe-bearing wadsleyite at high pressure-temperature conditions by Brillouin spectroscopy. Our results are then used to model the global distribution of wadsleyite proportion, temperature, and water content in the upper mantle transition zone by integrating mineral physics data with global seismic observations. Our models show that the upper mantle transition zone near subducted slabs is relatively cold, enriched in wadsleyite, and slightly more hydrated compared to regions where plumes are expected. This study provides direct evidence for the thermochemical heterogeneities in the upper mantle transition zone which is important for understanding the material exchange processes between the upper and lower mantle.

58 GEOSCIENCES↗
DOE OSTI2021

Seismic Visibility of Eclogite in the Earth’s Upper Mantle—Implications From High Pressure‐Temperature Single‐Crystal Elastic Properties of Omphacite

Abstract Identifying and locating the geochemical and geophysical heterogeneities in the Earth’s interior is one of the most important and challenging tasks for the deep Earth scientists. Subducted oceanic crust metamorphizes into the dense eclogite in the upper mantle and is considered as a major cause of geochemical and geophysical heterogeneities in the deep Earth. In order to detect eclogitic materials inside the Earth, precise measurements of the high pressure‐temperature single‐crystal elasticity of major minerals in eclogite are thus exceedingly important. Omphacite, a Na,Al‐bearing clinopyroxene, constitutes up to 75 vol% of eclogite. In the present study, we performed the first high pressure‐temperature single‐crystal elasticity measurements of omphacite using Brillouin spectroscopy. Utilizing the finite‐strain approach, we obtained the following thermoelastic parameters for omphacite: K S0 ’ = 4.5(1), G 0 ’ = 1.53(5), ∂K S0 /∂ T = −0.029(5) GPa/K, ∂G 0 /∂ T = −0.013(5) GPa/K, with K S0 = 123(3) GPa, G 0 = 74(2) GPa, and ρ 0 = 3.34(1) g/cm 3 . We found that the seismic velocities of undeformed eclogite are similar to pyrolite at the depths of 200–300 and 410–500 km, thus eclogite is seismically invisible at these depths. Combined with the lattice‐preferred orientations of the omphacite in naturally deformed eclogites, we also modeled seismic anisotropy of eclogite at various pressure‐temperature conditions. A 10 km thick subducted eclogitic crust can result in ∼0.2 s shear wave splitting in the Earth’s upper mantle.

Hao, Ming↗
DOE OSTI2021

The Water-Fe-Pressure dependent single-crystal elastic properties of wadsleyite: Implications for the seismic anisotropy in the upper Mantle Transition Zone

Recent seismic studies suggest an anisotropic Mantle Transition Zone (MTZ) in areas adjacent to subducted slabs. Wadsleyite is the main anisotropy contributor in the upper MTZ, therefore the interpretation of these seismic observations requires the knowledge of single-crystal elastic moduli (C ij s) and the deformation-induced lattice preferred orientation (LPO) of wadsleyite. Wadsleyite can host up to 3 wt% water in its crystal structure as point defects in the form of hydroxyl groups, however, the combined effect of water content, Fe content, and pressure on the C ij s of wadsleyite remains unclear. In this study, we measured the high-pressure single-crystal elasticity of a synthetic hydrous Fe-bearing wadsleyite (0.14(5) wt% water, Fe#=9.4, Fe 3+ /ΣFe=0.3) up to 18.2 (2) GPa. In combination with previous experimental data, we separated the effects of pressure, water, and Fe contents on the Cijs and intrinsic elastic anisotropy of wadsleyite. Overall, our results suggest that the intrinsic elastic anisotropy of wadsleyite decreases with pressure, water, and Fe contents. At 15 GPa, increasing the water content by 0.1 wt% or Fe# by 1 decreases the V P and V S anisotropy of wadsleyite by ~1.1-1.3%, and ~0.8-1.3% in average, respectively. Combined with the LPO determined in previous deformation experiments, we modeled the seismic anisotropy in the upper MTZ generated by a sub-vertical mantle flow near cold subducted slabs and a sub-horizontal mantle flow in the ambient mantle. In both scenarios, the LPO of wadsleyite leads to V SV (vertically polarized shear wave velocity) > V SH (horizontally polarized shear wave velocity). Our results suggest that wadsleyite may account for a weak anisotropic MTZ (<1%) on the global scale. Considering the fact that water decreases the elastic anisotropy but promotes LPO of wadsleyite, seismic anisotropy may not be a good water sensor.

36 MATERIALS SCIENCE↗