Engineering topics

Harman, Richard

Publications and source records attributed to Harman, Richard.

9 records

NASA NTRS2004

Kalman Filter Estimation of Spinning Spacecraft Attitude using Markley Variables

There are several different ways to represent spacecraft attitude and its time rate of change. For spinning or momentum-biased spacecraft, one particular representation has been put forward as a superior parameterization for numerical integration. Markley has demonstrated that these new variables have fewer rapidly varying elements for spinning spacecraft than other commonly used representations and provide advantages when integrating the equations of motion. The current work demonstrates how a Kalman filter can be devised to estimate the attitude using these new variables. The seven Markley variables are subject to one constraint condition, making the error covariance matrix singular. The filter design presented here explicitly accounts for this constraint by using a six-component error state in the filter update step. The reduced dimension error state is unconstrained and its covariance matrix is nonsingular.

Sedlak, Joseph E.↗

NASA NTRS2003

Implicit Spacecraft Gyro Calibration

This paper presents an implicit algorithm for spacecraft onboard instrument calibration, particularly to onboard gyro calibration. This work is an extension of previous work that was done where an explicit gyro calibration algorithm was applied to the AQUA spacecraft gyros. The algorithm presented in this paper was tested using simulated data and real data that were downloaded from the Microwave Anisotropy Probe (MAP) spacecraft. The calibration tests gave very good results. A comparison between the use of the implicit calibration algorithm used here with the explicit algorithm used for AQUA spacecraft indicates that both provide an excellent estimation of the gyro calibration parameters with similar accuracies.

Harman, Richard↗

NASA NTRS2003

Pseudo Linear Gyro Calibration

Previous high fidelity onboard attitude algorithms estimated only the spacecraft attitude and gyro bias. The desire to promote spacecraft and ground autonomy and improvements in onboard computing power has spurred development of more sophisticated calibration algorithms. Namely, there is a desire to provide for sensor calibration through calibration parameter estimation onboard the spacecraft as well as autonomous estimation on the ground. Gyro calibration is a particularly challenging area of research. There are a variety of gyro devices available for any prospective mission ranging from inexpensive low fidelity gyros with potentially unstable scale factors to much more expensive extremely stable high fidelity units. Much research has been devoted to designing dedicated estimators such as particular Extended Kalman Filter (EKF) algorithms or Square Root Information Filters. This paper builds upon previous attitude, rate, and specialized gyro parameter estimation work performed with Pseudo Linear Kalman Filter (PSELIKA). The PSELIKA advantage is the use of the standard linear Kalman Filter algorithm. A PSELIKA algorithm for an orthogonal gyro set which includes estimates of attitude, rate, gyro misalignments, gyro scale factors, and gyro bias is developed and tested using simulated and flight data. The measurements PSELIKA uses include gyro and quaternion tracker data.

Harman, Richard↗

NASA NTRS2002

Fine Sun Sensor Field of View Calibration

The fine Sun sensor (FSS) used on many spacecraft consists of two independent single-axis sensors, nominally mounted perpendicularly, that detect Sun angle across a typical field of view of +/- 32 degrees. The nonlinear function that maps the measured counts into an observed angle is called the transfer function. The FSS transfer function provided by the manufacturer consists of nine parameters for each of the two sensitive axes. An improved transfer function has been previously reported that achieves a significant accuracy improvement across the entire field of view. This new function expands the parameter set to 12 coefficients per axis and includes cross terms combining counts from both axes. To make best use of the FSS for spacecraft attitude determination, it must be calibrated after launch. We are interested in simplifying the postlaunch calibration procedure for estimating improvements to the 24 parameters in the transfer function. This paper discusses how to recombine the terms of the transfer function to reduce their redundancy without decreasing its accuracy and then presents an attitude dependent procedure for estimating the parameters. The end result is a calibration algorithm that is easier to use and does not sacrifice accuracy. Results of calibration using on-orbit data are presented.

Sedlak, Joseph E.↗

NASA NTRS2002

New Attitude Sensor Alignment Calibration Algorithms

Accurate spacecraft attitudes may only be obtained if the primary attitude sensors are well calibrated. Launch shock, relaxation of gravitational stresses and similar effects often produce large enough alignment shifts so that on-orbit alignment calibration is necessary if attitude accuracy requirements are to be met. A variety of attitude sensor alignment algorithms have been developed to meet the need for on-orbit calibration. Two new algorithms are presented here: ALICAL and ALIQUEST. Each of these has advantages in particular circumstances. ALICAL is an attitude independent algorithm that uses near simultaneous measurements from two or more sensors to produce accurate sensor alignments. For each set of simultaneous observations the attitude is overdetermined. The information content of the extra degrees of freedom can be combined over numerous sets to provide the sensor alignments. ALIQUEST is an attitude dependent algorithm that combines sensor and attitude data into a loss function that has the same mathematical form as the Wahba problem. Alignments can then be determined using any of the algorithms (such as the QUEST quaternion estimator) that have been developed to solve the Wahba problem for attitude. Results from the use of these methods on active missions are presented.

Hashmall, Joseph A.↗

NASA NTRS2001

Calibration of Gyros with Temperature Dependent Scale Factors

The general problem of gyro calibration can be stated as the estimation of the scale factors, misalignments, and drift-rate biases of the gyro using the on-orbit sensor measurements. These gyro parameters have been traditionally treated as temperature-independent in the operational flight dynamics ground systems at NASA Goddard Space Flight Center (GSFC), a scenario which has been successfully applied in the gyro calibration of a large number of missions. A significant departure from this is the Microwave Anisotropy Probe (MAP) mission where, due to the high thermal variations expected during the mission phase, it is necessary to model the scale factors as functions of temperature. This paper addresses the issue of gyro calibration for the MAP gyro model using a manufacturer-supplied model of the variation of scale factors with temperature. The problem is formulated as a least squares problem and solved using the Levenberg-Marquardt algorithm in the MATLAB(R) library function NLSQ. The algorithm was tested on simulated data with Gaussian noise for the quaternions as well as the gyro rates and was found to consistently converge close to the true values. Significant improvement in accuracy was noticed due to the estimation of the temperature-dependent scale factors as against constant scale factors.

Belur, Sheela V.↗

NASA NTRS2000

On-Orbit Calibration of Satellite Gyroscopes

In order to maneuver satellites accurately from one attitude to another, onboard rate sensing gyroscopes usually must be calibrated after launch. Several algorithms have been used to determine gyro biases, misalignments, and scale factors. This paper describes algorithms that have been used in the past, discusses their advantages and limitations, and describes a new algorithm and the gyro calibration results obtained using this new algorithm. The new algorithm has significant operational advantages in addition to being at least as accurate as other algorithms.

Hashmall, Joseph A.↗

NASA NTRS1993

Extreme Ultraviolet Explorer attitude determination support with a multimission three-axis stabilized spacecraft flight dynamics support system

The Extreme Ultraviolet Explorer (EUVE) was launched June 7, 1992 by an expendable Delta 2 launch vehicle. The Flight Dynamics Facility (FDF) at NASA Goddard Space Flight Center used a multimission three-axis stabilized spacecraft (MTASS) Flight Dynamics Support System (FDSS) to support the EUVE launch and mission operations. For EUVE, MTASS has been used to monitor attitude sensor performance, study OBC attitude determination performance, and study attitude perturbations. The current status of these efforts are summarized. After its successful implementation for EUVE, the Upper Atmosphere Research Satellite (UARS), and the Solar Anomalous and Magnetospheric Particle Explorer (SAMPEX), MTASS has demonstrated multimission flight dynamics support systems can effectively bridge the gap between single-mission support systems of the past and future generic systems.

Harman, Richard↗

NASA NTRS1988

An analysis of the Kalman filter in the Gamma Ray Observatory (GRO) onboard attitude determination subsystem

The Gamma Ray Observatory (GRO) spacecraft needs a highly accurate attitude knowledge to achieve its mission objectives. Utilizing the fixed-head star trackers (FHSTs) for observations and gyroscopes for attitude propagation, the discrete Kalman Filter processes the attitude data to obtain an onboard accuracy of 86 arc seconds (3 sigma). A combination of linear analysis and simulations using the GRO Software Simulator (GROSS) are employed to investigate the Kalman filter for stability and the effects of corrupted observations (misalignment, noise), incomplete dynamic modeling, and nonlinear errors on Kalman filter. In the simulations, on-board attitude is compared with true attitude, the sensitivity of attitude error to model errors is graphed, and a statistical analysis is performed on the residuals of the Kalman Filter. In this paper, the modeling and sensor errors that degrade the Kalman filter solution beyond mission requirements are studied, and methods are offered to identify the source of these errors.

Snow, Frank↗