Engineering topics

Harries, Wynford L.

Publications and source records attributed to Harries, Wynford L..

7 records

NASA NTRS1993

Simulated space environmental effects on a polyetherimide and its carbon fiber-reinforced composites

The selection of materials for spacecraft construction requires identification of candidate materials which can perform reliably in the space environment. Understanding the effects of the space environment on the materials is an important step in the selection of candidate materials. This work examines the effects of energetic electrons, thermal cycling, electron radiation in conjunction with thermal cycling, and atomic oxygen on a thermoplastic polyetherimide and its carbon-fiber-reinforced composites. Composite materials made with non-sized fibers as well as materials made with fibers sized with an epoxy were evaluated. The mechanical and thermomechanical properties of the materials were studied and spectroscopic techniques were used to investigate the mechanisms for the observed effects. Considerations for future material development are suggested.

Kern, Kristen T.↗

NASA NTRS1992

Molecular properties of polymeric materials for space applications

This cooperative agreement was intended to investigate the effects of a space environment on the properties of polymeric materials. In addition, efforts have been made to understand and investigate environment simulation techniques and test methodology. The results identified the changes in the properties of six aerospace structural adhesives, three neat high polymers, and two fiber-reinforced polymers, as caused by exposure to four simulated space environmental conditions. Significant property changes occurred for several of the systems as a result of one or more of the exposures. A summary of the research follows a list of related publications and presentations.

Harries, Wynford L.↗

NASA NTRS1990

Dynamic mechanical analysis of polymeric materials

Polymeric materials exhibit mechanical behavior which is dependent on temperature. Dynamic mechanical analysis measures the mechanical damping and resonant frequency of a material over a temperature range. Values of the dynamic loss modulus, storage modulus, and loss tangent can be calculated from these data. The glass transition temperature and onset temperature are obtained from curves of the dynamic moduli versus temperature.

Kern, Kristen T.↗

NASA NTRS1990

Theoretical studies of solar pumped lasers

One concept for collecting solar energy is to use large solar collectors and then use lasers as energy converters whose output beams act as transmission lines to deliver the energy to a destination. The efficiency of the process would be improved if the conversion could be done directly using solar pumped lasers, and the possibility of making such lasers is studied. There are many applications for such lasers, and these are examined. By including the applications first, the requirements for the lasers will be more evident. They are especially applicable to the Space program, and include cases where no other methods of delivering power seem possible. Using the lasers for conveying information and surveillance is also discussed. Many difficulties confront the designer of an efficient system for power conversion. These involve the nature of the solar spectrum, the method of absorbing the energy, the transfer of power into laser beams, and finally, the far field patterns of the beams. The requirements of the lasers are discussed. Specific laser configurations are discussed. The thrust is into gas laser systems, because for space applications, the laser could be large, and also the medium would be uniform and not subject to thermal stresses. Dye and solid lasers are treated briefly. For gas lasers, a chart of the various possibilities is shown, and the various families of gas lasers divided according to the mechanisms of absorbing solar radiation and of lasing. Several specific models are analyzed and evaluated. Overall conclusions for the program are summarized, and the performances of the lasers related to the requirements of various applications.

Harries, Wynford L.↗

NASA NTRS1988

Theoretical studies of solar-pumped lasers

The investigation of stimulated emission causing transitions from the B(1) pi sub u state of sodium to the overlapping 2(1) sigma(+) sub g electronic state has been continued. A new method of estimating the Franck-Condon factors has been developed which instead of fitting the molecular potential curves with Morse functions, estimates the V(r) dependence by interpolation from given potential curves. The results for the sum of the rates from one vibrational level in the upper state to all the levels in the lower state show good agreement with the previous method, implying that curve crossing by stimulated emission due to photons from the oven is an important mechanism in sodium.

Harries, Wynford L.↗

NASA NTRS1987

Absorption of isotropic radiation

Estimates of the absorption of isotropic radiation are given for an absorbing medium whose geometrical shape is either a plane-parallel sided slab or a cylinder. By including the directional variation of absorption path length, the results show appreciable differences to the 'unidirectional radiation' formulas.

Harries, Wynford L.↗

NASA NTRS1986

Electron-radiation effects on the ac and dc electrical properties and unpaired electron densities of three aerospace polymers

The effects of gigarad-level total absorbed doses from 1-MeV electrons on the post-irradiation alternating-current (ac) and direct-current (dc) electrical properties and the unpaired electron densities have been studied for Kapton, Ultem, and Mylar. The unpaired electron densities (determined from electron paramagnetic resonance spectroscopy) and the dc electrical conductivities of the irradiated materials were monitored as functions of time following the exposures to determine their decay characteristics at room temperature. The elevated-temperature ac electrical dissipations of the Ultem and Mylar were affected by the radiation. The dc conductivity of the Kapton increased by five orders of magnitude, while the dc conductivities of the Ultem and Mylar increased by less than an order of magnitude, due to the radiation. The observed radiation-generated changes in the ac electrical dissipations are explained in terms of known radiation-generated changes in the molecular structures of the three materials. A preliminary model relating the dc electrical conductivity and the unpaired electron density in the Kapton is proposed.

Long, Sheila Ann T.↗