Search NASA⌕ Search

Engineering topics

Harris, C. D.

Publications and source records attributed to Harris, C. D..

25 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1972

Tabulated pressure measurements of a NASA supercritical-wing research airplane model with and without fuselage area-rule additions at Mach 0.25 to 1.00

Basic pressure measurements were made on a 0.087-scale model of a supercritical wing research airplane in the Langley 8 foot transonic pressure tunnel at Mach numbers from 0.25 to 1.00 to determine the effects on the local aerodynamic loads over the wing and rear fuselage of area-rule additions to the sides of the fuselage. In addition, pressure measurements over the surface of the area-rule additions themselves were obtained at angles of sideslip of approximately - 5 deg, 0 deg, and 5 deg to aid in the structural design of the additions. Except for representative figures, results are presented in tabular form without analysis.

Harris, C. D.↗
NASA NTRS1972

Aerodynamic characteristics of an NASA supercritical-wing research airplane model with and without fuselage area-rule additions at Mach 0.25 to 1.00

Transonic pressure tunnel tests at Mach numbers from 0.25 to 1.00 were performed to determine the effects of area-rule additions to the sides of the fuselage on the aerodynamic characteristics of a 0.087 scale model of an NASA supercritical-wing research airplane. Presented are the longitudinal aerodynamic force and moment characteristics for horizontal-tail deflection angles of -2.5 deg and -5 deg with the side fuselage area-rule additions on and off the model. The effects of the side fuselage area-rule additions on selected wing and fuselage pressure distributions at near-cruise conditions are also presented.

Bartlett, D. W.↗
NASA NTRS1972

Aerodynamic characteristics of 2 NASA supercritical airfoils with different maximum thickness

Transonic wind tunnel tests were conducted at Mach numbers from 0.60 to 0.81 to determine the aerodynamic characteristics of two NASA supercritical airfoils. The airfoils had maximum thicknesses of 10 and 11 percent of the chord. Normal forces and pitching moments acting on the airfoils were determined from surface static pressure measurements. Drag forces acting on the airfoils were derived from vertical variations of the total and static pressures measured across the wake. For the thinner airfoil, stall begins at approximately 0.1 higher normal-force coefficient at the higher test Mach numbers, and the drag divergence Mach number at a normal-force coefficient of 0.7 was 0.01 higher.

Harris, C. D.↗
NASA NTRS1972

Wind-tunnel measurements of aerodynamic load distribution on an NASA supercritical-wing research airplane configuration

Wind tunnel tests have been conducted on a research airplane model with an NASA supercritical wing to define the general character of the flow over the wing and to aid in structural design of the full scale airplane. Pressure measurements were made at Mach numbers from 0.25 to 1.30 for sideslip angles from -2.50 deg to 2.50 deg over a moderate range of angles of attack and dynamic pressures. Except for representative figures, the results are presented in tabular form without detailed analysis.

Harris, C. D.↗
NASA NTRS1972

Wind-tunnel Investigation of Effects of Rear Upper Surface Modification on a NASA Supercritical Airfoil

Wind tunnel tests were conducted at Mach numbers from 0.60 to 0.81 to examine the effects on supercritical airfoil of modifying the rear upper surface to reduce the magnitude of an intermediate off design second velocity peak. The modification was accomplished by increasing the upper surface curvature around the 50 percent chord station and reducing the curvature over approximately the rearmost 30 percent of the airfoil while maintaining the same trailing edge thickness.

Harris, C. D.↗
NASA NTRS1971

Wind-tunnel investigation of effects of trailing-edge geometry on a NASA supercritical airfoil section

Wind-tunnel tests have been conducted at Mach numbers from 0.60 to 0.81 to determine the effects of trailing-edge geometry on the aerodynamic characteristics of a NASA supercritical airfoil shape. Variations in trailing-edge thicknesses from 0 to 1.5 percent of the chord and a cavity in the trailing edge were investigated with airfoils with maximum thicknesses of 10 and 11 percent of the chord.

Harris, C. D.↗