Search NASA⌕ Search

Engineering topics

Harris, W. L.

Publications and source records attributed to Harris, W. L..

25 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1977

Modelling the effects of turbulence on acoustic wave propagation

A review of recent theoretical modeling of the effects of turbulence on acoustic wave propagation is presented. The Born approximation limit of the smoothing method of Keller and of the kinetic theory method of Howe are compared with the classical perturbation results of Chernov. Secular growth is observed in the higher order terms of the kinetic theory method of Howe when multiple scaling is ignored. The forward propagation - beam broadening model of Brown and Clifford is discussed as well as the single scatter model of DeLoach and of Rudd. Each model is examined with respect to its prediction of conservation of energy.

Harris, W. L.↗
NASA NTRS1977

An experimental investigation of helicopter rotor high frequency broadband noise

The paper describes experiments involving a 4.17 foot diameter model rotor operating in a 5 times 7.5 ft open jet wind tunnel enclosed in an anechoic chamber. The effects of rotor thrust, advance ratio, and the number of blades on the intensity and spectrum of high frequency broadband noise (HFBN) have been investigated. The effects of each parameter were determined by keeping the other two constant. The directivities of the two- and three-bladed rotors were measured in a direction perpendicular to the plane of the rotor disk. The effects of heading edge, pressure side, and suction side serrations on HFBN were measured under several operating conditions, and the effects of the serrations on the mean thrust generated by the rotor were studied. A scaling law is proposed to determine the location of the peak frequency and intensity of HFBN.

Lee, A.↗
NASA NTRS1976

An experimental study of helicopter rotor rotational noise in a wind tunnel

The rotational noise of model helicopter rotors in forward flight was studied in an anechoic wind tunnel. The parameters under study were the rotor thrust (blade loading), blade number and advance ratio. The separate effects of each parameter were identified with the other parameters being held constant. The directivity of the noise was also measured. Twelve sets of data for rotational noise as a function of frequency were compared with the theory of Lowson and Ollerhead. In general, the agreement is reasonably good, except for the cases of (1) low and high disk loadings, (2) the four bladed rotor, and (3) low advance ratios. The theory always under-estimates the rotational noise at high harmonics.

Lee, A.↗
NASA NTRS1975

The development of experimental techniques for the study of helicopter rotor noise

The acoustic characteristics of a low noise open jet wind tunnel have been obtained by employing two different calibration techniques. One technique is to measure the decay of sound pressure with distance in far field. The other technique is to utilize a calibrated speaker as a sound source. The sound pressure level vs frequency was obtained in the wind tunnel testing chamber and compared with the corresponding calibrated values. The results of two different techniques agree with each other. Fiberglass board-block units were installed on the testing chamber interior. The free field was increased significantly after this treatment and the testing chamber cut-off frequency was reduced to 160 Hz from the original designed 250 Hz. The flow field characteristics of the rotor-tunnel configuration were studied by using flow visualization techniques.

Harris, W. L.↗
NASA NTRS1974

The development of experimental techniques for the study of helicopter rotor noise

The features of existing wind tunnels involved in noise studies are discussed. The acoustic characteristics of the MIT low noise open jet wind tunnel are obtained by employing calibration techniques: one technique is to measure the decay of sound pressure with distance in the far field; the other technique is to utilize a speaker, which was calibrated, as a sound source. The sound pressure level versus frequency was obtained in the wind tunnel chamber and compared with the corresponding calibrated values. Fiberglas board-block units were installed on the chamber interior. The free field was increased significantly after this treatment and the chamber cut-off frequency was reduced to 160 Hz from the original designed 250 Hz. The flow field characteristics of the rotor-tunnel configuration were studied by using flow visualization techniques. The influence of open-jet shear layer on the sound transmission was studied by using an Aeolian tone as the sound source. A dynamometer system was designed to measure the steady and low harmonics of the rotor thrust. A theoretical Mach number scaling formula was developed to scale the rotational noise and blade slap noise data of model rotors to full scale helicopter rotors.

Widnall, S. E.↗