Engineering topics
Publications and source records attributed to Hecker, T. P..
Technique is developed for making cleanly-contoured holes in assembled process systems without introducing chips or other contaminants into system. Technique uses portable equipment and does not require dismantling of system. Method was tested on Inconel, stainless steel, ASTMA-53, and Hastelloy X in all positions.
Testing was conducted to develop a technique of providing clean holes in process piping or in a metal surface accessible from one side only without disassembling the system. The method was performed on sample pieces of piping and worked successfully with no contaminants being found on the inside of the pipe. The materials tested were Inconel 600, 304 stainless steel, Hastelloy X, and ASTM-A53 black steel. The technique was developed such that it could be done in the field with hand-held power tools and a portable tungsten inert gas welding machine.
Compressor performance was mapped during the Brayton cycle power system testing. The range of testing included three shaft speeds: the design speed of 36,000 rpm, 10 percent overspeed (39,600 rpm), and 10 percent underspeed (32,400 rpm). A range of compressor inlet temperatures from 60 F to 120 F and discharge pressures from 20 to 45 psia were included. The effects of turbine inlet temperatures (from 1200 F to 1600 F) on the compressor were also studied. The data presented include plots of weight flow, compressor pressure ratio, efficiency, and temperature-rise ratio.
Shutdown characteristics of SNAP-8 mercury Rankine power conversion system
Brayton cycle power system gas loop operating with krypton over turbine inlet temperature of 1200 F to 1600 F
Transient response of SNAP 8 power conversion system at shutdown
Liquid-metal centrifugal pump at mercury loop
Performance tests on liquid metal pumps for sodium potassium loops