Final Report
This final report describes the major accomplishment of UCI personnel during the project period.
Engineering topics
Publications and source records attributed to Heidbrink, William.
This final report describes the major accomplishment of UCI personnel during the project period.
In February 2015, the Department of Energy, Office of Science, Fusion Energy Sciences (FES)” announced the formation of four technical workshops “to seek community engagement and input for future program planning activities.” Three of these workshops focused on the science and technical challenges we must address to meet the emerging needs of ITER and to allow exploration of fusion burning plasma physics in the laboratory. This report represents the work of the fourth workshop, which focused on the broader scientific opportunities at the frontiers of plasma science. The primary charge to the Panel authoring this report was “to ‘identify’ compelling scientific challenges at the frontiers of plasma physics” and “to ‘identify’ research tools and capabilities to address these challenges in the next decade.” This report aims to inform the newly constituted FES Program in Frontiers of Plasma Science on science opportunities and strategy moving forward. This program was created in FY2015 by combining topics from general plasma science, high energy density laboratory plasmas, and exploratory magnetized plasma into a single program area. The Executive Summary, chapter introductions and sidebars to the chapter are intended to provide more general overviews of the findings of the panel. The chapters provide more details following these themes.
A summary of publications, dissertations, and invited talks that resulted from the project is given.
New experiments on DIII-D have demonstrated the steady-state potential of the hybrid scenario, with 1 MA of plasma current driven fully non-inductively and β{sub N} up to 3.7 sustained for ∼3 s (∼1.5 current diffusion time, τ{sub R}, in DIII-D), providing the basis for an attractive option for steady-state operation in ITER and FNSF. Excellent confinement is achieved (H{sub 98y2} ∼ 1.6) without performance limiting tearing modes. The hybrid regime overcomes the need for off-axis current drive efficiency, taking advantage of poloidal magnetic flux pumping that is believed to be the result of a saturated 3/2 tearing mode. This allows for efficient current drive close to the axis, without deleterious sawtooth instabilities. In these experiments, the edge surface loop voltage is driven down to zero for >1 τ{sub R} when the poloidal β is increased above 1.9 at a plasma current of 1.0 MA and the ECH power is increased to 3.2 MW. Stationary operation of hybrid plasmas with all on-axis current drive is sustained at pressures slightly above the ideal no-wall limit, while the calculated ideal with-wall MHD limit is β{sub N} ∼ 4–4.5. Off-axis Neutral Beam Injection (NBI) power has been used to broaden the pressure and current profiles in this scenario, seeking to take advantage of higher predicted kink stability limits and lower values of the tearing stability index Δ′, as calculated by the DCON and PEST3 codes. Results based on measured profiles predict ideal limits at β{sub N} > 4.5, 10% higher than the cases with on-axis NBI. A 0-D model, based on the present confinement, β{sub N} and shape values of the DIII-D hybrid scenario, shows that these plasmas are consistent with the ITER 9 MA, Q = 5 mission and the FNSF 6.7 MA scenario with Q = 3.5. With collisionality and edge safety factor values comparable to those envisioned for ITER and FNSF, the high-β{sub N} hybrid represents an attractive high performance option for the steady-state missions of these devices.