Search NASA⌕ Search

Engineering topics

Henderson, Roger A.

Publications and source records attributed to Henderson, Roger A..

Liquid semiconductor-halogen based electronics

According to one embodiment, a device includes a first electrode, a second electrode spaced from the first electrode, a well extending between the first electrode and the second electrode, one or more chalcogens in the well, and at least one halogen mixed with the one or more chalcogens in the well. In addition, the chalcogens are selected from the group consisting of sulfur, selenium, tellurium, and polonium.

Voss, Lars↗

Parallel-Plate Avalanche Counter (PPAC) Fabrication for 240 Pu PFNS Measurement [Slides]

A LANL-LLNL joint program has been developed successfully to measure PFNS and established the most precisely determined $\chi$ matrices for 235,238 U and 239 Pu. It has been extended to 240 Pu now and possibly to 233 U in the future. An alternative method was developed to fabricate 240 Pu and a total of 12 targets were made with a total mass of 17.9 mg. The PFNS measurement for 240 Pu will begin in June, 2022 when the new beam cycle starts and the data analysis follows immediately afterward.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

A parallel-plate avalanche counter for the prompt fission neutron spectrum measurement

Neutrons, gamma’s, and fission fragments are among the prompt fission observables. Their precision measurements are fundamental to advance our understanding of fission and any application of fission. For our programmatic need, the χ matrix, which defines as the outgoing neutron spectrum as a function of incoming neutron energy, is sparsely populated and poorly measured for 233,235,238 U and 239,240 Pu. To improve the quality of those χ matrices, a joint LANLLLNL project was undertaken to measure their prompt fission neutron spectra at the LANSCE/WNR facility using neutron detector arrays and a charged-particle detector for the fission-fragment detection. A typical setup is shown in Fig. 1, where one of neutron detector array with a charged-particle detector is given.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

Demonstration of a Three-Dimensionally Structured Betavoltaic

In this work, we present a demonstration of a high-aspect ratio, three-dimensionally structured betavoltaic device. High-aspect ratio silicon PIN diodes were used as the semiconductor absorber and 147 PmCl 3 was used as the beta emitter. Three devices were fabricated with 147 Pm activities of 2.4 mCi, 7.4 mCi, and 29.5 mCi. The device with the highest activity produced an initial power output of 200 nW and was monitored over a period of 8 months to observe the current–voltage behavior over time, during which time the output current decreased in accordance with the radioactive half-life of 147 Pm. Small deviations in the output current of a few percent during the long-term measurement were found to be attributable to the humidity in the room where the experiment was done. Furthermore, the output current generated from the devices was 68–77% of the theoretical maximum, indicating significant infiltration of the radioisotope into the ridged structures.

42 ENGINEERING↗

Three dimensional radioisotope battery and methods of making the same

According to one embodiment, a product includes an array of three dimensional structures, where each of the three dimensional structure includes a semiconductor material; a cavity region between each of the three dimensional structures; and a first material in contact with at least one surface of each of the three dimensional structures, where the first material is configured to provide high energy particle and/or ray emissions.

07 ISOTOPE AND RADIATION SOURCES↗

Radiation tolerant microstructured three dimensional semiconductor structure

According to one embodiment, a product includes an array of three dimensional structures, a cavity region between each of the three dimensional structures, and a first material in contact with at least one surface of each of the three dimensional structures. In addition, each of the three dimensional structures includes a semiconductor material, where at least one dimension of each of the three dimensional structures is in a range of about 0.5 microns to about 10 microns. Moreover, the first material is configured to provide high energy particle and/or ray emissions.

25 ENERGY STORAGE↗

Design considerations for three-dimensional betavoltaics

Betavoltaic devices are suitable for delivering low-power over periods of years. Typically, their power density is on the order of nano to micro-Watts per cubic centimeter. In this work we evaluate the potential for using high-aspect ratio three-dimensional semiconductor structures to enhance the power and efficiency of these devices. The Monte Carlo transport code MCNP6 is used to provide realistic estimates of the theoretical levels of charge generation, which is in turn used to make predictions about the power output from three-dimensional betavoltaics. The focus of this work is on silicon and promethium-147, but other semiconductors and radioisotopes are considered as well. In the case of silicon diodes with three-dimensional features that are comparable to what is commercially available we estimate that power densities in the range of 20-25 mW/cm 3 can be achieved at efficiencies of 2.9-5.8% when coupled with promethium-147 oxide.

25 ENERGY STORAGE↗

Characterization of the homologs of flerovium with crown ether based extraction chromatography resins: studies in nitric acid

Eichrom’s Pb resin, a crown-ether-based extraction chromatography resin, was characterized for separation of the flerovium (Fl) homologs, Pb and Sn. Batch uptake of Pb(II) and Sn(IV) radionuclides was determined from an HNO 3 matrix. Pb(II) was strongly retained on the resin at all HNO 3 concentrations, while Sn(IV) showed no uptake. Extraction kinetics for Pb(II) were examined and show suitable uptake on the second time scale. Here, separation methods for the isolation of individual homologs, Pb(II) and Sn(IV), have been established using 2 mL pre-packed vacuum flow Pb resin columns.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Production and isolation of homologs of flerovium and element 115 at the Lawrence Livermore National Laboratory Center for Accelerator Mass Spectrometry

Here, new procedures have been developed to isolate no-carrier-added (NCA) radionuclides of the homologs and pseudo-homologs of flerovium (Hg, Sn) and element 115 (Sb), produced by 12–15 MeV proton irradiation of foil stacks with the tandem Van-de-Graaff accelerator at the Lawrence Livermore National Laboratory Center for Accelerator Mass Spectrometry (CAMS) facility. The separation of 113 Sn from nat In foil was performed with anion-exchange chromatography from hydrochloric and nitric acid matrices. A cation-exchange chromatography method based on hydrochloric and mixed hydrochloric/hydroiodic acids was used to separate 124 Sb from nat Sn foil. A procedure using Eichrom TEVA resin was developed to separate 197 Hg from Au foil. These results demonstrate the suitability of using the CAMS facility to produce NCA radioisotopes for studies of transactinide homologs.

38 RADIATION CHEMISTRY, RADIOCHEMISTRY, AND NUCLEA↗

Nuclear Smuggling International Technical Working Group (ITWG): Round Robin #3 (Final Report)

Full nuclear forensics analysis of the two samples is complete. All uranium isotopic analyses indicate that both samples are weapons-usable, highly enriched uranium. Therefore, both seizures indicate that the statutes of the country of Texmex regarding the transport of uranium materials have been violated (>1 gram, >1% enriched in U235). Isotopic analysis by multicollector inductively coupled plasma-mass spectrometry (MC-ICP-MS) indicates that the two samples (Sample A, Sample B) have isotopic compositions that differ outside analytical uncertainty (k=2). The model ages of the two samples (apparent time since last chemical separation of parent and daughter nuclides) also differ outside analytical uncertainty (k=2). These results would indicate that, even with all of the other similarities between the two samples, the two questioned samples originate from different source materials.

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗