DOE OSTI2025
These data report aerosol liquid water content (ALWC) and aerosol pH for the S2 (Mt. Airy) site during CoURAGE for April - June 2025. The ISORROPIA-II aerosol thermodynamic equilibrium model was used to compute ALWC and pH. The model was run in forward mode, with solids formation disabled (metastable mode), according to Pye et al. (Atmospheric Chemistry and Physics, 2020). Information about the model can be found at https://www.epfl.ch/labs/lapi/models-and-software/isorropia/, and in Fountoukis and Nenes (Atmospheric Chemistry and Physics, 2007). Inputs to the model were: (1) measured Temperature and relative humidity, both from the DoE ARM “metwxt” data products at S2, (2) aerosol chemical composition from the ARM ACSM, and (3) gas-phase ammonia concentrations. For ISORROPIA-II, ambient RH values above 0.995 were input to the model as 0.995; therefore, caution should be exercised interpreting ALWC when RH was above 0.995. Aerosol composition or NH3(g) concentrations below the LOD were input into the model as 0.5*LOD. Model runs were only conducted for data points at 30-min resolution with all three inputs (meteorology, ACSM, and NH3). If any of the three model inputs were missing, aerosol thermodynamic outputs are flagged as -999. Similarly, aerosol thermodynamic outputs are flagged as -999 if measured NH3(g) and aerosol ammonium (NH4+) were simultaneously below the respective LODs. The ALWC includes liquid water from inorganic aerosol components, calculated directly by ISORROPIA-II, as well as liquid water from organics, estimated from the ACSM organics assuming a kappa value of 0.12 according to Guo et al. (Atmospheric Chemistry and Physics, 2015).
Aerosol Liquid Water Content↗