Engineering topics

Hepp, A. F.

Publications and source records attributed to Hepp, A. F..

26 records · Page 2

NASA NTRS1990

Subtle porosity variation in the YBa2Cu3O(7-x) high-temperature superconductor revealed by ultrasonic imaging

The characterization of global porosity variation within a nominally 93-percent-dense specimen of YBa2Cu3O(7-x) high-temperature superconductor is reported. With a computer-controlled scanning system, precision ultrasonic velocity measurements were obtained at 100 micron increments over an 8- by 8-mm area of the YBa2Cu3O(7-x) specimen. The measurements were used to form a color map of velocity variation across the scanned region of the specimen. Subtle velocity variation on the order of 1 percent was observed. The specimen was shown by experimental methods to be single-phase, untextured, and free of nonuniform residual microstresses. From this knowledge and an established velocity-density relationship, a likely conclusion is that the observed velocity variations are solely due to porosity variations of similar magnitude. Locating these subtle porosity variations is critical since they can result in an order of magnitude variation in J(sub c) for dense YBCO specimens. Thus, mapping the global porosity distribution within YBa2Cu3O(7-x) may reveal regions that have poorer superconducting properties. Ultrasonic velocity results are translated into useful microstructural information for the material scientist.

Roth, D. J.↗

NASA NTRS1989

Properties of Pb(1-x)Bi(x)/Ba2YCu3O(x) composites - Reaction of Ba2YCu3O(x) with Pb and Bi

This paper describes experiments conducted with a purpose of fabricating superconducting composites from Pb, Bi, and Ba2YCu3O(x), together the results of SEM examinations and energy dispersive spectroscopy performed on products. Results showed a limited utility of Pb and Pb(1-x)Bi(x) as matrices for ceramic superconductors. It was found that cold pressing followed by sintering at 200 C resulted in a composite which excluded flux below 90 K but did not show zero electrical resistance until the metal superconducting transition. Processing at 400 or 950 C resulted in oxygen depleted perovskite and/or metal oxides; these materials displayed greatly degraded superconducting properties. Finally, processing at 800 C resulted in high Tc only for composites containing more than 90 wt pct ceramic.

Hepp, A. F.↗

NASA NTRS1988

Synthesis and structural chemistry of Au(III)-substituted Ba2YCu3O(7-delta)

Gold-substituted superconductors, Ba2Y(Au(x)Cu(1-x))3O(7-delta) (x = 0-0.1) were synthesized. For x = 0.1, there was no change in the a and b lattice parameters (a = 3.826 A and b = 3.889 A) but a 0.06 A c axis expansion to 11.75 A was observed. Substituted gold is found to be trivalent by XPS. Replacing Cu(1) in the copper oxide chain with a slight reordering of oxygen is consistent with c axis expansion. The formal charge of the site remains trivalent; remaining Cu in the chains may be reduced resulting in an oxygen stoichiometry is less than or equal to 7. A small effect on T(sub c)(89 K for x = 0.10) is observed upon gold substitution.

Hepp, A. F.↗

NASA NTRS1988

Advantages of barium peroxide in the powder synthesis of perovskite superconductors

This paper compares reaction chemistry, material processing, and material characteristics for the solid state reaction using BaCO3 or BaO2 in the synthesis of perovskite superconductors. Results are presented for weight loss and X-ray diffraction, sample morphology and homogeneity as monitored by SEM and EDS, and the superconductivity critical temperature and ac susceptibility. Greater mass density, increased sample homogeneity, lower resistance, and improved reproducibility for material are found when BaO32 is used.

Hepp, A. F.↗

NASA NTRS1988

Characterization of Ba2YCu3O(7-x) prepared in an inert atmosphere

Reaction data, X-ray data, and critical temperature measurements have been used to show that superconducting Ba2YCu3O(7-x) can be produced in an inert atmosphere using BaO2 as the barium source. Weight loss data are presented for samples produced in O2 and N2. The use of BaO2 is found to result in decreased levels of intergrain BaCO3. The necessity for total inert atmosphere handling and tighter control of the carbon content of starting materials is pointed out. It is shown that materials made with BaO2 and handled in inert atmospheres can be used to improve the J sub c of melt processed materials.

Hepp, A. F.↗

NASA NTRS1988

Structural chemistry of Au(III)-substituted Ba2YCu3O(7-delta)

A series of gold-substituted perovskite superconductors Ba2Y(Cu/1-x/Aux)3O(7-delta)(x = 0-0.1) was synthesized. For x = 0.1, there was no change in the a and b lattice parameters (a = 3.826 A and b = 3.889 A), but a 0.06 A c-axis expansion to 11.75 A was observed. Substituted gold was found to be trivalent by X-ray photoelectron spectroscopy. Replacing Cu(1) in the copper oxide chain with a slight reordering of oxygen is consistent with c-axis expansion. The formal charge of the site remains trivalent, while remaining Cu in the chains is reduced to Cu(I), resulting in an oxygen stoichiometry of less than 7. Finally, no large effect on Tc is observed (Tc = 89 K for x = 0.10), in contrast to the effect of a number of other metal ion dopants. These results are discussed relative to the chemistry of Au(III) and to the use of the metal in structures containing gold and ceramic superconductors.

Hepp, A. F.↗

NASA NTRS1988

Interaction of Au, Ag, and Bi ions with Ba2YCu3O(7-y) - Implications for superconductor applications

Results are presented on the reactions of Au, Ag, and Bi ions with Ba2YCu3O(7-y) oxides and on the properties of the resultant materials. The results indicate that Au(3+) structural chemistry makes gold an excellent candidate for multiphase structures of the Ba2Y(Cu/1-x/Au/x/)3O(7-y)-type substituted superconductors. Silver is structurally and chemically compatible with the perovskite structure, but when it forms a second phase, it does so without the destruction of the superconducting phase, making silver a useful metal for metal/ceramic applications. On the other hand, bismuth was shown to degrade Tc phase or to form other phases, indicating that it may not be useful in applications with rare-earth-based superconductors.

Hepp, A. F.↗

NASA NTRS1988

Improved synthesis of ceramic superconductors with alkaline earth peroxides - Synthesis and processing of Ba2YCu3O(7-x)

Synthesis processes for the preparation of ceramic conductors Ba2YCu3O(7-x) from BaO2 or BaCO3 in flowing O2 or N2 are described, and the characteristics of the materials produced in these processes are compared. Results of EDAX, XRD, SEM, and dc resistivity analyses demonstrated that superconducting materials made from BaO2 were more homogeneous, denser, and more metallic than materials produced from BaCO3, because of the higher reactivity of BaO2. Potential applications of this processes are discussed.

Hepp, A. F.↗