Search NASA⌕ Search

Engineering topics

Heremans, Joseph P.

Publications and source records attributed to Heremans, Joseph P..

9 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2023

Synergizing a Large Ordinary Nernst Effect and Axis‐Dependent Conduction Polarity in Flat Band KMgBi Crystals

The exploration of quantum materials in which an applied thermo/electrical/magnetic field along one crystallographic direction produces an anisotropic response has led to unique functionalities. Along these lines, KMgBi is a layered, narrow gap semiconductor near a critical state between multiple Dirac phases due to the presence of a flat band near the Fermi level. The valence band is highly anisotropic with minimal cross-plane dispersion, which, in combination with an isotropic conduction band, enables axis-dependent conduction polarity. Thermopower and Hall measurements indicate dominant p-type conduction along the cross-plane direction, and n-type conduction along the in-plane direction, leading to a significant zero-field transverse thermoelectric response when the heat flux is at an angle to the principal crystallographic directions. Additionally, a large Ordinary Nernst effect (ONE) is observed with an applied field. It arises from the ambipolar term in the Nernst effect, whereby the Lorentz force on electrons and holes makes them drift in opposite directions so that the resulting Nernst voltage becomes a function of the difference between their partial thermopowers, greatly enhancing the ONE. It is proven that axis-dependent polarity can synergistically enhance the ONE, in addition to leading to a zero-field transverse thermoelectric performance.

36 MATERIALS SCIENCE↗
DOE OSTI2023

Axis dependent conduction polarity in the air-stable semiconductor, PdSe 2

Axis-dependent conduction polarity (ADCP) is a unique electronic phenomena in which the charge polarity of carrier conduction can differ from p-type to n-type depending on the direction of travel through the crystal. Most materials that exhibit ADCP are metals, and very few semiconducting materials exhibit this effect. Here, in this work, we establish that PdSe 2 , a ~0.5 eV band gap semiconductor that is air- and water-stable, exhibits ADCP, through the growth and characterization of the transport properties of crystals with extrinsic p- and n-type doping levels of Ir and Sb, respectively, in the 10 16 –10 18 cm –3 range. Electron doped PdSe 2 exhibits p-type conduction in the cross-plane direction and n-type conduction along the in-plane directions above an onset temperature of 100–200 K that varies with doping level. Lightly p-doped samples show p-type thermopower in all directions at low temperatures, but above ~360 K the in-plane thermopower turns negative. Density functional theory calculations indicate that the origin of ADCP arises from the complementary effective mass anisotropies in the valence and conduction bands in this material, which facilitate hole transport in the cross-plane direction, and electron transport along the in-plane directions. ADCP occurs at temperatures with sufficient thermal population of both carrier types to overcome the extrinsic doping levels to exploit the effective mass anisotropy. In total, the development of this stable semiconductor in which thermally or optically excited holes and electrons inherently migrate along different directions opens up numerous potential applications in a multitude of technologies.

36 MATERIALS SCIENCE↗
DOE OSTI2022

Thermoelectrics: From longitudinal to transverse

Thermoelectric power generation is a promising technology to realize a sustainable society because it directly converts thermal energy into electricity in a solid. Conventional thermoelectric generation is driven by the Seebeck effect, discovered by T.J. Seebeck in 1821, in which a charge current J c is generated in the direction parallel to a temperature gradient ∇T, the longitudinal geometry. Here, the ratio between the generated longitudinal electromotive force and applied ∇T is defined as the Seebeck coefficient. As shown in Figure 1A, a thermoelectric module based on the Seebeck effect typically consists of many pairs (128 for a 12V unit) of p-type and n-type conductors alternately arranged and connected in series. Since the Seebeck coefficient of a p-type (n-type) conductor is positive (negative), the thermopower in each element adds to the total output in the Seebeck module. This configuration is needed to achieve a practical voltage because each element only supplies millivolts but limits the use of thermoelectric generators. The efficiency of thermoelectric generators is characterized by the thermoelectric figure of merit, zT. Despite a 3-fold improvement in zT resulting from materials research over the last two decades, little progress has been made in their practical use; this is ascribed to the technological challenges in contact technology. The contacts on the hot side are subject to thermal degradation. All contacts (512 for a 12V unit) add electrical and thermal contact resistances that reduce the device efficiency to a fraction of that promised by the materials.

30 DIRECT ENERGY CONVERSION↗
DOE OSTI2022

Adiabatic and isothermal configurations for Re 4 Si 7 transverse thermoelectric power generators

We report that transverse thermoelectric generators (TTEGs) have the potential to overcome two challenging problems that limit the commercial application of classical thermoelectric generators (TEGs): the significant irreversible efficiency losses in the contacts and the thermal degradation of the contacts at the hot end. TTEGs are built from a single material that can generate a thermoelectric current in a direction that is orthogonal to a temperature gradient. They only require a single set of contacts that are displaced away from the hot end. Here, we experimentally explore the device design considerations for optimizing the performance of this far less explored class of thermal-to-electric generation devices. We fabricate Re 4 Si 7 TTEGs and show that there is no measurable loss in efficiency with a single set of contacts that are midway between the hot and cold ends. We show that a new effect must be considered: the appearance of transverse thermal gradients that lead to significant differences between the performance of TTEGs implemented in isothermal and adiabatic geometries. The isothermal TTEG configuration leads to much higher device efficiencies. Overall, this work highlights how different the design of TTEGs is from that of conventional TEGs and the importance of controlling the device geometry for optimum waste heat recovery.

30 DIRECT ENERGY CONVERSION↗
DOE OSTI2021

Giant anomalous Nernst signal in the antiferromagnet YbMnBi 2

A large anomalous Nernst effect (ANE) is crucial for thermoelectric energy conversion applications because the associated unique transverse geometry facilitates module fabrication. Topological ferromagnets with large Berry curvatures show large ANEs; however, they face drawbacks such as strong magnetic disturbances and low mobility due to high magnetization. Herein, we demonstrate that YbMnBi 2 , a canted antiferromagnet, has a large ANE conductivity of ~10 A m –1 K –1 that surpasses large values observed in other ferromagnets (3–5 A m –1 K –1 ). The canted spin structure of Mn guarantees a non-zero Berry curvature, but generates only a weak magnetization three orders of magnitude lower than that of general ferromagnets. The heavy Bi with a large spin–orbit coupling enables a large ANE and low thermal conductivity, whereas its highly dispersive p x/y orbitals ensure low resistivity. The high anomalous transverse thermoelectric performance and extremely small magnetization make YbMnBi 2 an excellent candidate for transverse thermoelectrics.

30 DIRECT ENERGY CONVERSION↗
DOE OSTI2021

Large magnon-induced anomalous Nernst conductivity in single-crystal MnBi

Thermoelectric modules are a promising approach to energy harvesting and efficient cooling. In addition to the longitudinal Seebeck effect, transverse devices utilizing the anomalous Nernst effect (ANE) have recently attracted interest. For high conversion efficiency, it is required that the material have a large ANE thermoelectric power and low electrical resistance, which lead to the conductivity of the ANE. ANE is usually explained in terms of intrinsic contributions from Berry curvature. Our observations suggest that extrinsic contributions also matter. Studying single-crystal manganese-bismuth (MnBi), we find a high ANE thermopower (~10 μV/K) under 0.6 T at 80 K, and a transverse thermoelectric conductivity of over 40 A/Km. With insight from theoretical calculations, we attribute this large ANE predominantly to a new advective magnon contribution arising from magnon-electron spin-angular momentum transfer. We propose that introducing a large spin-orbit coupling into ferromagnetic materials may enhance the ANE through the extrinsic contribution of magnons.

36 MATERIALS SCIENCE↗
DOE OSTI2021

Computationally Guided Discovery of Axis-Dependent Conduction Polarity in NaSnAs Crystals

Most electronic materials exhibit a single dominant charge carrier type, either holes or electrons, along all crystallographic directions. However, there are a small number of compounds, mostly metals, that exhibit simultaneous p-type and n-type conduction behavior along different crystallographic directions. We demonstrate that the experimental discovery of semiconductors with this axis-dependent conduction polarity can be facilitated by identifying a large anisotropy of either the electron or hole effective masses (m*) or both, providing the electron and hole masses dominate along different crystallographic directions. We calculated the layered semiconductor NaSnAs to have a lower electron m* in-plane than the cross-plane and a very large hole m* in-plane and small hole m* cross-plane. We established the growth of >3 mm-sized NaSnAs crystals via Sn flux and confirmed the band gap to be 0.65 eV, in agreement with theory. NaSnAs exhibits p-type thermopowers cross-plane and n-type thermopowers in-plane, confirming that the large anisotropy in the effective mass at the band edges is an excellent indicator for axis-dependent conduction polarity. Altogether, this work shows that the discovery of semiconductors with such a phenomenon can be accelerated by computationally evaluating the anisotropic curvatures of the band edges, paving the way for their future discovery and application.

30 DIRECT ENERGY CONVERSION↗