Engineering topics

Herling, W. W.

Publications and source records attributed to Herling, W. W..

4 records

NASA NTRS1978

Unsteady loads due to propulsive lift configurations. Part D: The development of an experimental facility for the investigation of scaling effects on propulsive lift configurations

The design and construction of an experimental facility for the investigation of scaling effects in propulsive lift configurations are described. The facility was modeled after an existing full size NASA facility which consisted of a coaxial turbofan jet engine with a rectangular nozzle in a blown surface configuration. The flow field of the model facility was examined with and without a simulated wing surface in place at several locations downstream of the nozzle exit plane. Emphasis was placed on obtaining pressure measurements which were made with static probes and surface pressure ports connected via plastic tubing to condenser microphones for fluctuating measurements. Several pressure spectra were compared with those obtained from the NASA facility, and were used in a preliminary evaluation of scaling laws.

Haviland, J. K.↗

NASA NTRS1977

Modelling techniques for jet impingement

A technique for testing scale models for the determination of fluctuating pressure loads due to jet impingement has been investigated using a quarter-scale model of a boilerplate test facility in which a JT-15D engine with a rectangular outer nozzle blows over a small curved airfoil representing the upper-surface of a wing. When model and full-scale spectra of fluctuating surface pressures are reduced to plots of pressure coefficient power-spectral density vs Strouhal number, moderate agreement is obtained, but a shift of spectral peaks is noted. However, when a correction for the ratio of average jet to ambient temperature is applied, the spectral peaks agree.

Haviland, J. K.↗

NASA NTRS1976

Investigations of scaling laws for jet impingement

The statistical properties of tangential flows over surfaces were investigated by two techniques. In one, a laser-Doppler velocimeter was used in a smoke-laden jet to measure one-point statistical properties, including mean velocities, turbulent intensities, intermittencies, autocorrelations, and power spectral densities. In the other technique, free stream and surface pressure probes connected to 1/8 inch microphones were used to obtain single point rms and 1/3 octave pressures, as well as two point cross correlations, the latter being converted to auto spectra, amplitude ratios, phase lags, and coherences. The results of these studies support the vortex model of jets, give some insights into the effects of surface impingement, and confirm that jet diameter and velocity are the scaling parameters for circular jets, while Reynolds number is relatively unimportant.

Morton, J. B.↗

NASA NTRS1975

Unsteady loads due to propulsive lift configurations

The flow of a jet over an airfoil representative of upper surface blowing was studied using laser techniques. Experimental techniques were developed for the investigation of unsteady pressures behind a cold model jet. Construction of a 1/4 scale model of the 'Beach' test configuration was completed along with construction of a portable detector. The portable detector is used in conjunction with a laser to measure jet flows during tests on the 'Beach' facility. The detector incorporates both optical and electronic components.

Morton, J. B.↗