Engineering topics
Publications and source records attributed to Hertel, Tobias.
Molecular charge transfer doping affords widely tunable carrier density and conductivity in s-SWCNTs (and OSCs in general), however, a pervasive challenge for such systems is reliable measurement of charge carrier density and mobility.
Understanding and controlling the impact that electrostatic interactions have on the transport of injected charge carriers is important for the utilization of pi-conjugated semiconductors in opto-electronic applications. Here, we explore the impact of dopant chemical and electronic structure on the doping efficacy and charge carrier transport in semiconducting single-walled carbon nanotube (s-SWCNT) networks using molecular charge-transfer dopants based on functionalized icosahedral dodecaborane (DDB) clusters. Calculations indicate that localization of electron density on the DDB core reduces the coulombic interactions that contribute to hole localization in the s-SWCNTs, thereby improving charge carrier transport. The enhanced delocalization produces an increase in the electrical conductivity and thermopower at lower charge carrier densities, yielding enhanced thermoelectric transport and a thermoelectric power factor that surpasses the previous best in class for enriched s-SWCNT thin-film networks. This strategy can be applied broadly across pi-conjugated semiconductors to tune and enhance performance in a variety of energy harvesting devices.
Individual single-walled carbon nanotubes with covalent sidewall defects have emerged as a class of photon sources whose photoluminescence spectra can be tailored by the carbon nanotube chirality and the attached functional group/molecule. Here we present electroluminescence spectroscopy data from single-tube devices based on (7, 5) carbon nanotubes, functionalized with dichlorobenzene molecules, and wired to graphene electrodes. We observe electrically generated, defect-induced emissions that are controllable by electrostatic gating and strongly red-shifted compared to emissions from pristine nanotubes. The defect-induced emissions are assigned to excitonic and trionic recombination processes by correlating electroluminescence excitation maps with electrical transport and photoluminescence data. At cryogenic conditions, additional gate-dependent emission lines appear, which are assigned to phonon-assisted hot-exciton electroluminescence from quasi-levels. Similar results were obtained with functionalized (6, 5) nanotubes. We also compare functionalized (7, 5) electroluminescence data with photoluminescence of pristine and functionalized (7, 5) nanotubes redox-doped using gold(III) chloride solution. This work shows that electroluminescence excitation is selective toward neutral defect-state configurations with the lowest transition energy, which in combination with gate-control over neutral versus charged defect-state emission leads to high spectral purity.
Highlights: • Incorporation of 35 wt% of bauxite residue for production of CSAF clinker • Thermochemical calculations as suitable tool for predicting phase assemblage • Hydration of the cement was found to be accelerated in contrast to other CSA cements. • High early compressive strengths of 40 MPa In the present work, calciumsulfoaluminate-ferrite clinker was produced using 35 wt% of bauxite residue in combination with alumina, clay, limestone and gypsum. At a temperature of 1300 °C, the hydraulic phases ye'elimite, ferrite and C{sub 2}S were formed. Computed thermochemical predictions were a significantly better match for the real mineralogy than modified Bogue equations. Hydration of the clinker led to the formation of ettringite and monosulfate, resulting in compressive strengths of 17 MPa after 28d. Compressive strengths of 40 MPa after 2d, and 28d-strengths exceeding 50 MPa, were reached in blends with 10 wt% of anhydrite. The strength development was due to the rapid formation of ettringite, mainly originating from ye'elimite, which did not convert to AFm phases and led to a compact microstructure. Only when the ye'elimite dissolution decreased, did the ferrite phase react. In pastes with additional sulfates, ferrite hydration led to the formation of ettringite and to hydrogarnet. Cement nomenclature is used in this work.{sup 1}.