Search NASA⌕ Search

Engineering topics

Hess, R. W.

Publications and source records attributed to Hess, R. W..

15 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1989

Unsteady pressure measurements on a supercritical airfoil at high Reynolds numbers

Steady and unsteady pressures were measured on a 14 percent supercritical airfoil at transonic Mach numbers at Reynolds numbers from 6,000,000 to 35,000,000. Instrumentation techniques were developed to measure unsteady pressures in a cryogenic tunnel at flight Reynolds numbers. Experimental steady data, corrected for wall effects show very good agreement with calculations from a full potential code with an interacted boundary layer. The steady and unsteady pressures both show a shock position that is dependent on Reynolds number. For a supercritical pressure distribution at a chord Reynolds number of 35,000,000 laminar flow was observed between the leading edge and the shock wave at 45 percent chord.

Hess, R. W.↗
NASA NTRS1985

Dynamic Calibration of Pressure Transducers

Sinusoidal calibration signal produced in 4- to 100-Hz range. Portable oscillating-pressure device measures dynamic characteristics of pressure transducers installed in models or aircraft at frequency and oscillating-pressure ranges encountered during unsteady-pressure-measurement tests. Calibration is over range of frequencies and amplitudes not available with commercial acoustic calibration devices.

Hess, R. W.↗
NASA NTRS1985

Recent transonic unsteady pressure measurements at the NASA Langley Research Center

Four semispan wing model configurations were studied in the Transonic Dynamics Tunnel (TDT). The first model had a clipped delta planform with a circular arc airfoil, the second model had a high aspect ratio planform with a supercritical airfoil, the third model has a rectangular planform with a supercritical airfoil and the fourth model had a high aspect ratio planform with a supercritical airfoil. To generate unsteady flow, the first and third models were equipped with pitch oscillation mechanisms and the first, second and fourth models were equipped with control surface oscillation mechanisms. The fourth model was similar in planform and airfoil shape to the second model, but it is the only one of the four models that has an elastic wing structure. The unsteady pressure studies of the four models are described and some typical results for each model are presented. Comparison of selected experimental data with analytical results also are included.

Sandford, M. C.↗
NASA NTRS1985

Recent transonic unsteady pressure measurements at the NASA Langley Research Center

Four semispan wing model configurations were studied in the Transonic Dynamics Tunnel (TDT). The first model had a clipped delta planform with a circular arc airfoil, the second model had a high aspect ratio planform with a supercritical airfoil, the third model has a rectangular planform with a supercritical airfoil and the fourth model had a high aspect ratio planform with a supercritical airfoil. To generate unsteady flow, the first and third models were equipped with pitch oscillation mechanisms and the first, second and fourth models were equipped with control surface oscillation mechanisms. The fourth model was similar in planform and airfoil shape to the second model, but it is the only one of the four models that has an elastic wing structure. The unsteady pressure studies of the four models are described and some typical results for each model are presented. Comparison of selected experimental data with analytical results also are included.

Sandford, M. C.↗
NASA NTRS1983

Portable dynamic pressure generator for static and dynamic calibration of in situ pressure transducers

A portable dynamic pressure generator was developed to meet the requirements of determining the dynamic sensitivities of in situ pressure transducers at low frequencies. The device is designed to operate in a frequency range of 0 to 100 Hz, although it was only tested up to 30 Hz, and to generate dynamic pressures up to 13.8 kPa (2 psi). A description of the operating characteristics and instrumentation used for pressure, frequency, and displacement measurements is given. The pressure generator was used to statically and dynamically calibrate transducers. Test results demonstrated that a difference an exist between the static and dynamic sensitivity of a transducer, confirming the need for dynamic calibrations of in situ pressure transducers.

Bolt, P. A.↗
NASA NTRS1982

Static and unsteady pressure measurements on a 50 degree clipped delta wing at M = 0.9

Static and unsteady pressures were measured on a 50.45 degree clipped delta wing in the Langley Transonic Dynamics Tunnel with Freon as the test medium. Data taken at M = 0.9 is presented for static and oscillatory deflections of the trailing edge control surface and for the wing in pitch. Comparisons of the static measured data are made with results computed using the Bailey-Ballhaus small disturbance code.

Hess, R. W.↗
NASA NTRS1974

Space Shuttle flutter as affected by wing-body aerodynamic interaction

In the NASA Langley Research Center 26-inch transonic blowdown wind-tunnel, flutter speeds were measured on 1/80-th scale semispan models of the orbiter wing, the complete Space Shuttle, and intermediate component combinations. Using the doublet lattice method combined with slender body theory to calculate unsteady aerodynamic forces, subsonic flutter speeds were computed for comparison. Aerodynamic interaction was found by test and analysis to raise the flutter speed in some configurations while lowering it in others. Although at Mach number less than 0.7, predicted speeds correlated to within 6% of those measured, rapid deterioration of the agreement occurred at higher subsonic Mach numbers, especially on the more complicated configurations. Additional analysis showed that aerodynamic forces arising from body flexibility potentially can have a large effect on flutter speed, but that the current shuttle design is not so affected.

Chipman, R. R.↗
NASA NTRS1973

Wind-tunnel roll-damping measurements of a winged space shuttle configuration in launch attitude

Ground-wind load studies were conducted on three model configurations to assess the importance of aeroelastic instabilities of erected space shuttle vehicles. Roll damping was measured on a fuselage-alone model, which had a D cross section, and a fuselage and tail surfaces in combination with either a clipped-delta wing or a low-sweep tapered wing as the primary lifting surface. The largest negative roll-damping coefficients were measured with the fuselage-alone configuration and were a function of wind azimuth. At the wind azimuths at which the wing-fuselage configuration was unstable, the negative roll-damping coefficients were a function of reduced frequency.

Hess, R. W.↗
NASA NTRS1973

Flutter of pairs of aerodynamically interfering delta wings.

To examine the effect on flutter of the aerodynamic interference between pairs of closely spaced delta wings, several structurally uncoupled 1/80th-scale models were studied by experiment and analysis. Flutter test boundaries obtained in NASA Langley's 26-in. transonic blowdown wind tunnel were compared with subsonic analytical results generated using the doublet lattice method. Trends for several combinations of vertical and longitudinal wing separation were determined, showing flutter speed significantly affected in the closely spaced configurations. A new flutter mechanism coupling one wing's first bending mode with the other wing's first torsion mode was predicted and observed.

Chipman, R. R.↗