Search NASA⌕ Search

Engineering topics

Heywood, J. B.

Publications and source records attributed to Heywood, J. B..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1988

Computer Code For Turbocompounded Adiabatic Diesel Engine

Computer simulation developed to study advantages of increased exhaust enthalpy in adiabatic turbocompounded diesel engine. Subsytems of conceptual engine include compressor, reciprocator, turbocharger turbine, compounded turbine, ducting, and heat exchangers. Focus of simulation of total system is to define transfers of mass and energy, including release and transfer of heat and transfer of work in each subsystem, and relationship among subsystems. Written in FORTRAN IV.

Assanis, D. N.↗
NASA NTRS1985

A computer simulation of the turbocharged turbo compounded diesel engine system: A description of the thermodynamic and heat transfer models

A computer simulation of the turbocharged turbocompounded direct-injection diesel engine system was developed in order to study the performance characteristics of the total system as major design parameters and materials are varied. Quasi-steady flow models of the compressor, turbines, manifolds, intercooler, and ducting are coupled with a multicylinder reciprocator diesel model, where each cylinder undergoes the same thermodynamic cycle. The master cylinder model describes the reciprocator intake, compression, combustion and exhaust processes in sufficient detail to define the mass and energy transfers in each subsystem of the total engine system. Appropriate thermal loading models relate the heat flow through critical system components to material properties and design details. From this information, the simulation predicts the performance gains, and assesses the system design trade-offs which would result from the introduction of selected heat transfer reduction materials in key system components, over a range of operating conditions.

Assanis, D. N.↗
NASA NTRS1984

Computer simulation of the heavy-duty turbo-compounded diesel cycle for studies of engine efficiency and performance

Reductions in heat loss at appropriate points in the diesel engine which result in substantially increased exhaust enthalpy were shown. The concepts for this increased enthalpy are the turbocharged, turbocompounded diesel engine cycle. A computer simulation of the heavy duty turbocharged turbo-compounded diesel engine system was undertaken. This allows the definition of the tradeoffs which are associated with the introduction of ceramic materials in various parts of the total engine system, and the study of system optimization. The basic assumptions and the mathematical relationships used in the simulation of the model engine are described.

Assanis, D. N.↗
NASA NTRS1981

Premixed turbulent flame blowoff velocity correlation based on coherent structures in turbulent flows

A correlation for the blowoff velocity of premixed turbulent flames stabilized by bluff bodies is devloped using a simple model for coherent structures in turbulent flows. The correlation shows the correct trends for variations in equivalence ratio, free stream pressure and temperature, flameholder characteristic size, and turbulent Reynolds number, and good agreement with published experimental data is obtained.

Radhakrishnan, K.↗
NASA NTRS1980

Combustion and operating characteristics of spark-ignition engines

The spark-ignition engine turbulent flame propagation process was investigated. Then, using a spark-ignition engine cycle simulation and combustion model, the impact of turbocharging and heat transfer variations or engine power, efficiency, and NO sub x emissions was examined.

Heywood, J. B.↗
NASA NTRS1979

Premixing quality and flame stability: A theoretical and experimental study

Models for predicting flame ignition and blowout in a combustor primary zone are presented. A correlation for the blowoff velocity of premixed turbulent flames is developed using the basic quantities of turbulent flow, and the laminar flame speed. A statistical model employing a Monte Carlo calculation procedure is developed to account for nonuniformities in a combustor primary zone. An overall kinetic rate equation is used to describe the fuel oxidation process. The model is used to predict the lean ignition and blow out limits of premixed turbulent flames; the effects of mixture nonuniformity on the lean ignition limit are explored using an assumed distribution of fuel-air ratios. Data on the effects of variations in inlet temperature, reference velocity and mixture uniformity on the lean ignition and blowout limits of gaseous propane-air flames are presented.

Radhakrishnan, K.↗
NASA NTRS1979

Air pollution from aircraft

A series of fundamental problems related to jet engine air pollution and combustion were examined. These include soot formation and oxidation, nitric oxide and carbon monoxide emissions mechanisms, pollutant dispension, flow and combustion characteristics of the NASA swirl can combustor, fuel atomization and fuel-air mixing processes, fuel spray drop velocity and size measurement, ignition and blowout. A summary of this work, and a bibliography of 41 theses and publications which describe this work, with abstracts, is included.

Heywood, J. B.↗
NASA NTRS1979

Air pollution from aircraft

Forty-one annotated abstracts of reports generated at MIT and the University of Sheffield are presented along with summaries of the technical projects undertaken. Work completed includes: (1) an analysis of the soot formation and oxidation rates in gas turbine combustors, (2) modelling the nitric oxide formation process in gas turbine combustors, (3) a study of the mechanisms causing high carbon monoxide emissions from gas turbines at low power, (4) an analysis of the dispersion of pollutants from aircraft both around large airports and from the wakes of subsonic and supersonic aircraft, (5) a study of the combustion and flow characteristics of the swirl can modular combustor and the development and verification of NO sub x and CO emissions models, (6) an analysis of the influence of fuel atomizer characteristics on the fuel-air mixing process in liquid fuel spray flames, and (7) the development of models which predict the stability limits of fully and partially premixed fuel-air mixtures.

Heywood, J. B.↗
NASA NTRS1979

Modelling turbulent flame ignition and blowout

A statistical mixing model incorporating an overall rate equation to describe the fuel oxidation process was developed for studies of ignition and blowout in a combustor primary zone. This zone is treated as a partially stirred reactor whose composition is described by a statistical ensemble of equal mass fluid elements. This ensemble experiences mixing interactions, which represent the turbulent mixing process, at time intervals governed by an empirically determined mixing frequency. Each mixing interaction is computed by ramdomly selecting two different elements which are then allowed to mix completely so that they reach a mean composition depending on their thermodynamic states prior to mixing. The two elements then separate, and the chemical kinetics proceed depending on their new composition and temperature.

Radhakrishnan, K.↗
NASA NTRS1978

Nitric oxide formation in gas turbine engines: A theoretical and experimental study

A modified Zeldovich kinetic scheme was used to predict nitric oxide formation in the burned gases. Nonuniformities in fuel-air ratio in the primary zone were accounted for by a distribution of fuel-air ratios. This was followed by one or more dilution zones in which a Monte Carlo calculation was employed to follow the mixing and dilution processes. Predictions of NOX emissions were compared with various available experimental data, and satisfactory agreement was achieved. In particular, the model is applied to the NASA swirl-can modular combustor. The operating characteristics of this combustor which can be inferred from the modeling predictions are described. Parametric studies are presented which examine the influence of the modeling parameters on the NOX emission level. A series of flow visualization experiments demonstrates the fuel droplet breakup and turbulent recirculation processes. A tracer experiment quantitatively follows the jets from the swirler as they move downstream and entrain surrounding gases. Techniques were developed for calculating both fuel-air ratio and degree of nonuniformity from measurements of CO2, CO, O2, and hydrocarbons. A burning experiment made use of these techniques to map out the flow field in terms of local equivalence ratio and mixture nonuniformity.

Mikus, T.↗
NASA NTRS1977

The influence of droplet evaporation on fuel-air mixing rate in a burner

Experiments involving combustion of a variety of hydrocarbon fuels in a simple atmospheric pressure burner were used to evaluate the role of droplet evaporation in the fuel/air mixing process in liquid fuel spray flames. Both air-assist atomization and pressure atomization processes were studied; fuel/air mixing rates were determined on the basis of cross-section average oxygen concentrations for stoichiometric overall operation. In general, it is concluded that droplets act as point sources of fuel vapor until evaporation, when the fuel jet length scale may become important in determining nonuniformities of the fuel vapor concentration. In addition, air-assist atomizers are found to have short droplet evaporation times with respect to the duration of the fuel/air mixing process, while for the pressure jet atomizer the characteristic evaporation and mixing times are similar.

Komiyama, K.↗
NASA NTRS1975

Air pollution from aircraft

A model which predicts nitric oxide and carbon monoxide emissions from a swirl can modular combustor is discussed. A detailed analysis of the turbulent fuel-air mixing process in the swirl can module wake region is reviewed. Hot wire anemometry was employed, and gas sampling analysis of fuel combustion emissions were performed.

Heywood, J. B.↗
NASA NTRS1974

Partial equilibrium model for predicting concentration of CO in combustion

A simple kinetic model, based upon the concept of partial equilibrium, is developed for predicting carbon monoxide concentrations in such steady-flow hydrocarbon-air combustion systems as gas-turbine combustors. The only two kinetic constraints used in the model are on the rate of change of the total number of gaseous particles in the system, and on the rate of change of the CO concentration. The accuracy of the model is verified by comparison with experimental results obtained by burning kerosene with air in a 130,000 Btu/hr atmospheric-pressure steady-flow burner. Burnt-gas cooling rates of 1,000,000 K/sec, about the magnitude encountered in the dilution zone of gas-turbine combustors, were obtained with a compact water-cooled heat exchanger. Good agreement between measured CO concentrations and the values predicted by the partial-equilibrium model was obtained.

Morr, A. R.↗
NASA NTRS1974

The dispersion of propellants from aircraft

Two aspects of the dispersion of pollutants from aircraft are reviewed. The first is the dispersal of aircraft exhaust emissions in the vicinity of airports; the second is the dispersal of exhaust trails in the upper atmosphere. Techniques available for modeling this dispersal and how they might be applied to the airport problem are discussed. Field studies of airport pollution are then reviewed to assess current pollutant levels around airports and the aircraft's contribution to those levels. The possibility of contrail formation from jet emissions at high altitude is then considered and the effect of uncertainties in the trial mixing processes evaluated.

Fay, J. A.↗
NASA NTRS1973

Parameters controlling nitric oxide emissions from gas turbine combustors

Nitric oxide forms in the primary zone of gas turbine combustors where the burnt gas composition is close to stoichiometric and gas temperatures are highest. It was found that combustor air inlet conditions, mean primary zone fuel-air ratio, residence time, and the uniformity of the primary zone are the most important variables affecting nitric oxide emissions. Relatively simple models of the flow in a gas turbine combustor, coupled with a rate equation for nitric oxide formation via the Zeldovich mechanism are shown to correlate the variation in measured NOx emissions. Data from a number of different combustor concepts are analyzed and shown to be in reasonable agreement with predictions. The NOx formation model is used to assess the extent to which an advanced combustor concept, the NASA swirl can, has produced a lean well-mixed primary zone generally believed to be the best low NOx emissions burner type.

Heywood, J. B.↗
NASA NTRS1973

Parameters controlling nitric oxide emissions from gas turbine combustors

Nitric oxide forms in the primary zone of gas turbine combustors where the burnt gas composition is close to stoichiometric and gas temperatures are highest. It has been found that combustor air inlet conditions, mean primary zone fuel-air ratio, residence time, and the uniformity of the primary zone are the most important variables affecting nitric oxide emissions. Relatively simple model of the flow in a gas turbine combustor, coupled with a rate equation for nitric oxide formation via the Zeldovich mechanism are shown to correlate the variation in measured NOx emissions. Data from a number of different combustor concepts are analyzed and shown to be in reasonable agreement with predictions. The NOx formulation model is used to assess the extent to which an advanced combustor concept, the NASA swirl can, has produced a lean well-mixed primary zone generally believed to be the best low NOx emissions burner type.

Heywood, J. B.↗
NASA NTRS1973

Parameters controlling nitric oxide emissions from gas turbine combustors.

Nitric oxide forms in the primary zone of gas turbine combustors where the burst gas composition is close to stoichiometric and gas temperatures are highest. It has been found that combustor air inlet conditions, mean primary zone fuel-air ratio, residence time, and the uniformity of the primary zone are the most important variables affecting nitric oxide emissions. Relatively simple models of the flow in a gas turbine combustor, coupled with a rate equation for nitric oxide formation via the Zeldovich mechanism are shown to correlate the variation in measured NO sub x emissions. Data from a number of different combustor concepts are analyzed and shown to be in reasonable agreement with predictions. The NO sub x formation model is used to assess the extent to which an advanced combustor concept, the NASA swirl can, has produced a lean well-mixed primary zone generally believed to be the best low NO sub x emissions burner type.

Heywood, J. B.↗