Search NASA⌕ Search

Engineering topics

Hindson, W. S.

Publications and source records attributed to Hindson, W. S..

At least 19 records

Helmet-Mounted Display Research Capabilities of the NASA/Army Rotorcraft Aircrew Systems Concepts Airborne Laboratory (RASCAL)

The Rotorcraft Aircrew Systems Concepts Airborne Laboratory (RASCAL) is a UH-60A Black Hawk helicopter that is being modified by the US Army and NASA for flight systems research. The principal systems that are being installed in the aircraft are a Helmet Mounted Display (HMD) and imaging system, and a programmable full authority Research Flight Control System (RFCS). In addition, comprehensive instrumentation of both the rigid body of the helicopter and the rotor system is provided. The paper will describe the capabilities of these systems and their current state of development. A brief description of initial research applications is included. The wide (40 X 60 degree) field-of-view HMD system has been provided by Kaiser Electronics. It can be configured as a monochromatic system for use in bright daylight conditions, a two color system for darker ambients, or a full color system for use in night viewing conditions. Color imagery is achieved using field sequential video and a mechanical color wheel. In addition to the color symbology, high resolution computer-gene rated imagery from an onboard Silicon Graphics Reality Engine Onyx processor is available for research in virtual reality applications. This synthetic imagery can also be merged with real world video from a variety of imaging systems that can be installed easily on the front of the helicopter. These sensors include infrared or tv cameras, or potentially small millimeter wave radars. The Research Flight Control System is being developed for the aircraft by a team of contractors led by Boeing Helicopters. It consists of a full authority high bandwidth fly-by-wire actuators that drive the main rotor swashplate actuators and the tail rotor actuator in parallel. This arrangement allows the basic mechanical flight control system of the Black Hawk to be retained so that the safety pilot can monitor the operation of the system through the action of his own controls. The evaluation pilot will signal the fly-by-wire actuators through the flight computer from electrical sidearm controllers located in the right hand cockpit. The system will have very substantial input/output capacity and impressive computational power. These systems are installed in the aircraft using predominantly a MIL-STD 1553B data bus architecture. Sensor data from the RFCS, the basic aircraft and rotor system instrumentation including navigation information, and the HMD system are easily exchanged among user systems, or are available at the systems operator station located in the cabin for real time monitoring or data recording.

Jacobsen, R. A.↗

Precise Autohover Control For A Helicopter

Report describes development and testing of experimental precise autohover control system for helicopter. Attempts to maintain constant horizontal position. Part of continuing effort to develop such systems for next generation of military rotorcraft.

Hindson, W. S.↗

Development and flight test of a precision autohover capability for tactical rotorcraft

This paper describes the implementation of an automatic position-hold system in the NASA/Army CH47B variable-stability research helicopter. The test helicopter is briefly described, and a detailed documentation is given of the position-measurement system. The control system design model and the design procedure are described, and flight-test data describing overall system performance in strong winds are presented.

Hindson, W. S.↗

Influence of high-order dynamics on helicopter flight-control system bandwidth

The increasing use of highly augmented digital flight-control systems in modern military helicopters prompted an examination of the influence of the influence of rotor dynamics and other high-order dynamics on control-system performance. A study was conducted at NASA Ames Research Center to correlate theoretical predictions of feedback gain limits in the roll axis with experimental test data obtained from a variable-stability research helicopter. Feedback gains, the break frequency of the presampling sensor filter, and the computational frame time of the flight computer were systematically varied. The results, which showed excellent theoretical and experimental correlation, indicate that the rotor-dynamics, sensor-filter, and digital-data processing delays can severely limit the usable values of the roll-rate and roll-attitude feedback gains.

Chen, R. T. N.↗

Flight investigation of a multivariable model-following control system for rotorcraft

A high-bandwidth, multivariable, explicit model-following control system for advanced rotorcraft has been developed and evaluated on the NASA Ames CH-47B fly-by-wire helicopter. This control system has expanded the in-flight simulation capabilities of the CH-47B to support research efforts directed at the next generation of superaugmented helicopters. A detailed, analytical model of the augmented CH-47B has also been developed to support the flight tests. Analysis using this theoretical model was used to expose fundamental limitations caused by the basic vehicle characteristics and original control system implementation that had affected the performance of the model-following control system. Improvements were made to the nominal control system design to compensate for large time delays created by the higher-orderd dynamics of the aircraft and its control system. With these improvements, high bandwidth control and excellent model-following performance were achieved. Both analytical and flight-test results for the lateral axis are presented and compared. In addition, frequency-domain techniques are employed for documenting the system performance.

Hilbert, K. B.↗

Optimal landing of a helicopter in autorotation

The landing of a helicopter in autorotation is formulated as a nonlinear optimal control problem. A unique feature in the present formulation is the addition of path inequality constraints on both the control and the state vectors. The control variable inequality constraint is a reflection of the limitation on the rotor thrust coefficient. The state-variable inequality constraint is an upper bound on the vertical sink-rate of the helicopter during descent. Optimal trajectories are calculated for entry conditions well within the height-velocity (H-V) restriction curve, with the helicopter initially in hover or in forward flight. The optimal solutions exhibited control techniques similar to those used by helicopter pilots in actual autorotational landings. The study indicates that, subject to pilot acceptability, a substantial reduction could be made in the H-V restriction zone using optimal control techniques.

Lee, A. Y.↗

Flight evaluation of height response characteristics for the hover bob-up task and comparison with proposed criteria

The CH-47B variable-stability helicopter was used to evaluate a range of height-response configurations while performing a precision hover bob-up task. The purpose of the study was to assess the validity of results obtained in previous ground-based and in-flight simulations in the context of a precision bob-up task and to provide additional flight data for inclusion in revisions to specifications for helicopter handling qualities. Height response characteristics were implemented using explicit model-following techniques, and the resulting CH-47B dynamics were validated using time-domain and frequency-domain data-analysis methods. The tests complemented the previous investigations by providing detailed pilot comments and ratings, and performance and control-utilization data that relate exclusively to the hover bob-up task. The results are compared with those from previous investigations and with new criteria that have been proposed for handling qualities requirements for helicopters.

Hindson, W. S.↗

New capabilities and recent research programs of the NASA/Army CH-47B variable-stability helicopter

The CH-47B is the third in a series of variable-stability helicopters developed and operated by NASA since 1952 to investigate helicopter and VTOL handling qualities. Recently, several new capabilities were added to this helicopter to enable it to better support new and evolving research requirements. The installation of a programmable force-feel system for the evaluation pilot's conventional cyclic stick, and a four-axis side-stick controller permit a range of in-flight investigations concerning manipulator characteristics and augmentation system features that had not been possible with earlier NASA research helicopters. A recently installed color electronic display system with a programmable symbol generator will permit the investigation of display formats for a variety of VTOL and helicopter missions. Finally, a powerful new general-purpose flight computer is now in operation. It is programmable in high-level languages and will provide more efficient support of research programs. In addition to these new hardware capabilities, flight-control software has been developed to improve the in-flight simulation capability of the aircraft. A brief description of the CH-47B's variable-stability research equipment is provided, recent research programs are summarized, and some remarks concerning the potential of the helicopter are presented.

Hindson, W. S.↗

Analytical and flight investigation of the influence of rotor and other high-order dynamics on helicopter flight-control system bandwidth

The increasing use of highly augmented digital flight-control systems in modern military helicopters prompted an examination of the influence of rotor dynamics and other high-order dynamics on control-system performance. A study was conducted at NASA Ames Research Center to correlate theoretical predictions of feedback gain limits in the roll axis with experimental test data obtained from a variable-stability research helicopter. Feedback gains, the break frequency of the presampling sensor filter, and the computational frame time of the flight computer were systematically varied. The results, which showed excellent theoretical and experimental correlation, indicate that the rotor-dynamics, sensor-filter, and digital-data processing delays can severely limit the usable values of the roll-rate and roll-attitude feedback gains.

Chen, R. T. N.↗

A flight-test and simulation evaluation of the longitudinal final approach and landing performance of an automatic system for a light wing loading STOL aircraft equipped with wing spoilers

As part of a comprehensive flight-test investigation of short takeoff and landing (STOL) operating systems for the terminal systems for the terminal area, an automatic landing system has been developed and evaluated for a light wing-loading turboprop-powered aircraft. An advanced digital avionics system performed display, navigation, guidance, and control functions for the test aircraft. Control signals were generated in order to command powered actuators for all conventional controls and for a set of symmetrically driven wing spoilers. This report describes effects of the spoiler control on longitudinal autoland (automatic landing) performance. Flight-test results, with and without spoiler control, are presented and compared with available (basically, conventional takeoff and landing) performance criteria. These comparisons are augmented by results from a comprehensive simulation of the controlled aircraft that included representations of the microwave landing system navigation errors that were encountered in flight as well as expected variations in atmospheric turbulence and wind shear. Flight-test results show that the addition of spoiler control improves the touchdown performance of the automatic landing system. Spoilers improve longitudinal touchdown and landing pitch-attitude performance, particularly in tailwind conditions. Furthermore, simulation results indicate that performance would probably be satisfactory for a wider range of atmospheric disturbances than those encountered in flight. Flight results also indicate that the addition of spoiler control during the final approach does not result in any measurable change in glidepath track performance, and results in a very small deterioration in airspeed tracking. This difference contrasts with simulations results, which indicate some improvement in glidepath tracking and no appreciable change in airspeed tracking. The modeling problem in the simulation that contributed to this discrepancy with flight was not resolved.

Brown, S. C.↗

Helicopter Pilot Performance for Discrete-maneuver Flight Tasks

This paper describes a current study of several basic helicopter flight maneuvers. The data base consists of in-flight measurements from instrumented helicopters using experienced pilots. The analysis technique is simple enough to apply without automatic data processing, and the results can be used to build quantitative matah models of the flight task and some aspects of the pilot control strategy. In addition to describing the performance measurement technqiue, some results are presented which define the aggressiveness and amplitude of maneuvering for several lateral maneuvers including turns and sidesteps.

Heffley, R. K.↗

A flight-test and simulation evaluation of the longitudinal final approach and landing performance of an automatic system for a light wing loading STOL aircraft

As part of a comprehensive flight-test program of STOL operating systems for the terminal area, an automatic landing system was developed and evaluated for a light wing loading turboprop aircraft. The aircraft utilized an onboard advanced digital avionics system. Flight tests were conducted at a facility that included a STOL runway site with a microwave landing system. Longitudinal flight-test results were presented and compared with available (basically CTOL) criteria. These comparisons were augmented by results from a comprehensive simulation of the controlled aircraft which included representations of navigation errors that were encountered in flight and atmospheric disturbances. Acceptable performance on final approach and at touchdown was achieved by the autoland (automatic landing) system for the moderate winds and turbulence conditions encountered in flight. However, some touchdown performance goals were marginally achieved, and simulation results suggested that difficulties could be encountered in the presence of more extreme atmospheric conditions. Suggestions were made for improving performance under those more extreme conditions.

Brown, S. C.↗

Analysis of several glidepath and speed control autopilot concepts for a powered lift STOL aircraft

Longitudinal performance and control utilization data are compared for several different automatic approach autopilot implementations in a powered lift STOL aircraft. As few as two, to as many as four laws reflecting both backside and frontside control techniques. The data are developed from analysis and simulation, but represent configurations which were demonstrated in flight. Transient response characteristics from initial glidepath offsets are presented, along with system operation in turbulence. In furnishing quantitative data in controlled levels of simulated turbulence, these results provide a useful supplement to various flight investigations (including those employing manual control) that involved a comparison of control techniques in this type of aircraft.

Hindson, W. S.↗

Past applications and future potential of variable stability research helicopters

The historical development of variable-stability research helicopters and some of their previous applications are presented as a guide for assessing their future potential. The features of three general-purpose rotary-wing flight research aircraft that provide complementary capabilities are described briefly, and a number of future applications are proposed.

Hindson, W. S.↗

Flight experiments using the front-side control technique during piloted approach and landing in a powered lift STOL aircraft

The essential features of using pitch attitude for glidepath control in conjunction with longitudinal thrust modulation for speed control are described, using a simple linearized model for a powered-lift STOL aircraft operating on the backside of the drag curve and at a fixed setting of propulsive lift. It is shown that an automatic speed-hold system incorporating heave-damping augmentation can allow use of the front-side control technique with satisfactory handling qualities, and the results of previous flight investigations are reviewed. Manual control considerations, as they might be involved following failure of the automatic system, are emphasized. The influence of alternative cockpit controller configurations and flight-director display features were assessed for their effect on the control task, which consisted of a straight-in steep approach flown at constant speed in simulated instrument conditions.

Hindson, W. S.↗

Flight-test evaluation of STOL control and flight director concepts in a powered-lift aircraft flying curved decelerating approaches

Flight tests were carried out to assess the feasibility of piloted steep curved, and decelerating approach profiles in powered lift STOL aircraft. Several STOL control concepts representative of a variety of aircraft were evaluated in conjunction with suitably designed flight directions. The tests were carried out in a real navigation environment, employed special electronic cockpit displays, and included the development of the performance achieved and the control utilization involved in flying 180 deg turning, descending, and decelerating approach profiles to landing. The results suggest that such moderately complex piloted instrument approaches may indeed be feasible from a pilot acceptance point of view, given an acceptable navigation environment. Systems with the capability of those used in this experiment can provide the potential of achieving instrument operations on curved, descending, and decelerating landing approaches to weather minima corresponding to CTOL Category 2 criteria, while also providing a means of realizing more efficient operations during visual flight conditions.

Hindson, W. S.↗

A summary of joint US-Canadian augmentor wing powered-lift STOL research programs at the Ames Research Center, NASA, 1975-1980

Several different flight research programs carried out by NASA and the Canadian Government using the Augmentor Wing Jet STOL Research Aircraft to investigate the design, operational, and systems requirements for powered-lift STOL aircraft are summarized. Some of these programs considered handling qualities and certification criteria for this class of aircraft, and addressed pilot control techniques, control system design, and improved cockpit displays for the powered-lift STOL approach configuration. Other programs involved exploiting the potential of STOL aircraft for constrained terminal-area approaches within the context of present or future air traffic control environments. Both manual and automatic flight control investigations are discussed, and an extensive bibliography of the flight programs is included.

Hindson, W. S.↗

Flight experience with advanced controls and displays during piloted curved decelerating approaches in a powered-lift STOL aircraft

A program to assess the feasibility of piloted STOL approaches along predefined, steep, curved, and decelerating approach profiles was carried out with a powered-lift STOL aircraft. To reduce the pilot workload associated with the basic control requirements of a powered-lift aircraft equipped with redundant controls and operating on the backside of the power curve, separate stability augmentation systems for attitude and speed were provided, as well as a supporting flight director and special electronic cockpit displays. The control, display, and procedural features are described for the flight experiment that led to the conclusion that, given an adequate navigation environment, such constrained approaches may be feasible from a pilot acceptance point of view.

Hindson, W. S.↗