Search NASA⌕ Search

Engineering topics

Hoffman, A. R.

Publications and source records attributed to Hoffman, A. R..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2002

Outer planet spacecraft temperature testing and analysis

Unmanned spacecraft flown on missions to the outer planets of the solar system have included flybys, planetary orbiters, and atmospheric probes during the last three decades. The thermal design, test, and analysis approach applied to these spacecraft evolved from the passive thermal designs applied to the earlier lunar and interplanetary spacecraft. The inflight temperature data from representative sets of engineering subsystems and science instruments from a subset of these spacecraft are compared to those obtained during the ground test programs and from the prelaunch predictions. Several lessons are presented with specific recommendations for considerations for new projects to aid in the planning of cost effective temperature design, test, and analysis programs.

temperature testing planetary spacecraft Voyager G↗
NASA NTRS1991

Galileo environmental test and analysis program summary

This paper presents an overview of the Galileo Project's environmental test and analysis program during the spacecraft development phase - October 1978 through launch in October 1989. After describing the top-level objectives of the program, summaries of-the approach, requirements, and margins are provided. Examples of assembly- and system-level test results are given for both the pre-1986 (direct mission) testing and the post-1986 (Venus-Earth-Earth gravity assist mission) testing, including dynamic, thermal, electromagnetic compatibility (EMC), and magnetic. The approaches and results for verifying by analysis that the requirements of certain environments (e.g., radiation, micrometeoroids, and single event upsets) are satisfied are presented. The environmental program implemented on Galileo satisfied the spirit and intent of the requirements imposed by the Project during the spacecraft's development. The lessons learned from the Galileo environmental program are discussed in this paper.

Hoffman, A. R.↗
NASA NTRS1986

Galileo spacecraft system level environmental test results

Project Galileo, the United States' next planetary mission, will be launched by the Shuttle/Centaur in May 1986. The Galileo spacecraft consists of both a planetary Orbiter and an atmospheric Probe. The spacecraft was environmentally tested as a system in the fall and winter of 1984/1985 at the Jet Propulsion Laboratory. The protoflight qualification program consisted of vibration, acoustics, pyrotechnic shock, Electromagnetic Compatibility (EMC) and Solar Thermal Vacuum (STV) tests. This test program was accomplished on a large, complex, dual-spin spacecraft without the benefit of precursor spacecraft prototype tests. This paper discusses the objectives of these tests and the implementation, and summarizes the results.

Hoffman, A. R.↗
NASA NTRS1985

Determining The Life Expectancy of Photovoltaic Systems

Several tests used to determine adequacy of photovoltaic systems, their modules, and materials to survive in real environments. Tests include outdoor testing of systems, real-time and accelerated outdoor testing of modules and materials, and laboratory testing of modules and materials.

Hoffman, A. R.↗
NASA NTRS1983

Developing Standards for Phtotvoltaic Devices

Ground rules outlined for evaluating photovoltaic technology. Document addresses number of performance attributes: electrical, thermal, mechanical, structural, safety, reliability, durability, installation, operation, maintenance, building and site. Each criterion includes user need or expectation for element and describes method of test.

Hoffman, A. R.↗
NASA NTRS1982

Qualification testing of flat-plate photovoltaic modules

The placement of photovoltaic modules in various applications, in climates and locations throughout the world, results in different degrees and combinations of environmental and electrical stress. Early detection of module reliability deficiencies via laboratory testing is necessary for achieving long, satisfactory field service. This overview paper describes qualification testing techniques being used in the US Department of Energy's flat-plate terrestrial photovoltaic development program in terms of their significance, rationale for specified levels and durations, and test results.

Hoffman, A. R.↗
NASA NTRS1980

Photovoltaic module soiling studies, May 1978 - October 1980

Comparative electrical and optical performance data from photovoltaic modules and materials subjected to outdoor exposure at field test sites throughout the United States were collected and examined. The results show significant time and site dependence. During periods when natural removal processes do not dominate, the rate of particulate contamination accumulation appears to be largely material-independent. The effectiveness of natural removal processes, especially rain, is strongly material-dependent. Glass and acrylic top cover materials retain fewer particles than silicone rubber does. Side by side outdoor exposure testing for long duration is presently the most effective means of evaluating soiling differences between materials. Changes in spectral transmission as a function of time and location and limited scattering data are presented.

Hoffman, A. R.↗
NASA NTRS1980

Improved particulate-sampling filter

Small surface indentations entrain larger and more representative sampling than conventional petri-dish smeared with smooth layer adhesive. Filter is assembled from perforated disk and flat backing plate with sticky surface. Due to design-created currents, particulates come in contact with surface for longer time and have greater probability of being trapped. Filter is useful in air-quality monitoring at industrial sites, in mines, and in and around nuclear power plants.

Hoffman, A. R.↗
NASA NTRS1980

Airborne particulate soiling of terrestrial photovoltaic modules and cover materials

Results are presented for the first phase of a photovoltaic-module soiling study that was carried out with NASA participation to investigate the problem of the electrical performance degradation of flat-plate photovoltaic modules exposed at outdoor sites that is due to the accumulation of airborne particulates on sensitive optical surfaces. The results were obtained in both field and laboratory soiling experiments, as well as in materials field experiments using candidate encapsulants and top covers. It is concluded that: (1) the electrical performance degradation shows a significant time and site dependence, ranging from 2% to 60% power loss; (2) the rate of particulate accumulation appears to be largely material independent when natural removal processes do not dominate; (3) the effectiveness of natural removal processes, especially rain, is strongly material dependent; (4) top-cover materials of glass and plexiglass retain fewer particles than silicone rubber; and (5) high module voltages relative to ground do not appear to affect the rate of dirt accumulation on modules.

Hoffman, A. R.↗
NASA NTRS1979

Environmental requirements for flat plate photovoltaic modules for terrestrial applications

The environmental test requirements that have been developed for flat plate modules purchased through Department of Energy funding are described. Concurrent with the selection of the initial qualification tests from space program experience - temperature cycling and humidity - surveys of existing photovoltaic systems in the field revealed that arrays were experiencing the following failure modes: interconnect breakage, delamination, and electrical termination corrosion. These coupled with application-dependent considerations led to the development of additional qualification tests, such as cyclic pressure loading, warped mounting surface, and hail. Rationale for the selection of tests, their levels and durations is described. Comparisons between field-observed degradation and test-induced degradation show a positive correlation with some of the observed field effects. Also, the tests are proving useful for detecting design, process, and workmanship deficiencies. The status of study efforts for the development of environmental requirements for field-related problems is reviewed.

Hoffman, A. R.↗
NASA NTRS1979

Testing flat plate photovoltaic modules for terrestrial environment

New qualification tests have been developed for flat plate photovoltaic modules. Temperature cycling, cyclic pressure load, and humidity exposure are especially useful for detecting design and fabrication deficiencies. There is positive correlation between many of the observed field effects, such as power loss, and qualification test induced degradation. The status of research efforts for the development of test methodology for field-related problems is reviewed.

Hoffman, A. R.↗