Search NASA⌕ Search

Engineering topics

Hoffman, H. C.

Publications and source records attributed to Hoffman, H. C..

5 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1983

Method of damping nutation motion with minimum spin axis attitude disturbance

In a method of and apparatus for damping nutation of a spinning spacecraft, spin axis attitude disturbances are substantially reduced by controlling at least one nutation damping gas thruster to fire with nonuniform gas pulses. During the beginning of a nutation control sequence, the duration of successive gas pulses is gradually increased (up pulsed) from zero to a predetermined maximum duration. The duration of successive pulses is then maintained constant for a time period. Finally, at the end of the nutation control sequence, the duration of successive gas pulses is gradually reduced to zero (down pulsed). Up pulsing of the gas thruster is initiated in response to a predetermined maximum nutation angle measured by an accelerometer. Down pulsing of the thruster is initiated in response to a predetermined minimum nutation angle.

Hoffman, H. C.↗
NASA NTRS1981

SMM attitude control recovery

A description is given of the way in which the Modular Attitude Control System (MACS) onboard computer of the NASA Solar Maximum Mission (SMM) laboratory was reprogrammed, to restore attitude control for the SMM, after fuse failures permanently disabled all three of the MACS primary reaction wheels. Algorithms were developed which provided both a thermal- and power-safe, spin-stabilized mode and three-axis sun pointing, using the damaged primary wheels' backup skew wheel in a momentum-bias control scheme. Magnetic torquing was used in these algorithms for angular momentum vector magnitude and directional control.

Hoffman, H. C.↗
NASA NTRS1980

Active nutation controller

An apparatus is described for controlling nutation motion in a spinning body, comprised of an angular accelerometer with its input axis perpendicular to the spin axis of the body, a flywheel with an axis of rotation perpendicular to the axis of the accelerometer and to the spin axis of the body, and a motor for driving the flywheel to attenuate or build nutation. The motor is controlled by circuitry that monitors the output of the angular accelerometer and drives the motor clockwise or counterclockwise during predetermined nutation angles synchronized to the zero crossover points of the accelerometer signal centered about the nutation peaks. The motor drive is phased to damp nutation motion to zero for stabilization. To increase the noise immunity of the system, when the output of the accelerometer falls below a threshold level, the circuitry operates in an open loop, beat mode where data representing the last accelerometer signal that exceeded that threshold level is stored, and the motor drive is controlled by the stored data. In a second version, the motor is controlled to supply a predetermined amount of nutation motion to a body undergoing testing on a spin table for energy dissipation evaluation. In each version, the use of an angular accelerometer rather than a linear accelerometer or gyro to monitor nutation enables placement of the nutation control apparatus at any location relative to the spin axis of the body requiring only crude orientation and no calibration.

Hoffman, H. C.↗
NASA NTRS1979

Improved notation controller

Nutation controller equipped with angular accelerometer stabilizes spinning bodies without precise positioning or calibration.

Donohue, J.↗