Search NASA⌕ Search

Engineering topics

Hoglund, Linda

Publications and source records attributed to Hoglund, Linda.

11 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2017

Extended Cut-Off Wavelength nBn Detector Utilizing InAsSb/InSb Digital Alloy Absorber

We investigated a novel approach to extend a cut -off wavelength of Sb-based nBn detectors. We incorporated a series of single InSb monolayer into InAsSb bulk that allowed to realize a digital alloy absorber with an extended cut-off wavelength of λ = 4.6 μm at T = 200 K. The cut-off wavelength extension to 4.6μm is technologically important for realization of detectors covering CO2 absorption line at 4.26μm

InAsSb/InSb photodiodes↗
NASA NTRS2014

Minority Carrier Lifetime Studies of Narrow Bandgap Antimonide Superlattices

In this study optical modulation response and photoluminescence spectroscopy were used to study mid-wave Ga-free InAs/InAsSb superlattices. The minority carrier lifetimes in the different samples varied from 480 ns to 4700 ns, partly due to different background doping concentrations. It was shown that the photoluminescence intensity can be used as a fast non-destructive tool to predict the material quality. It was also demonstrated that it is crucial to use a low excitation power in the photoluminescence measurements in order to get a good correlation between the photoluminescence intensity and the minority carrier lifetime.

minority carrier lifetime↗
NASA NTRS2012

Minority Carrier Lifetime and Photoluminescence Studies of Antimony-Based Superlattices

In this paper, we have used the OMR technique to study the minority carrier lifetimes in three InAs/GaSb-photoluminescence (PL) structures with different number of periods in the absorber: 300, 400 and 600 periods respectively. The feasibility of using a visible 643 nm laser source with short penetration depth for lifetime measurements was studied by comparing the achieved results to measurements performed on the same samples with a 1550 nm IR laser source, which penetrates much deeper into the sample. Despite the differences in excitation wavelengths and penetration depths, the results from both measurements were very similar. This indicates that the diffusion length is long enough to facilitate a homogeneous distribution of excess carriers in the material.

photodetector↗
NASA NTRS2012

Complementary Barrier Infrared Detector (CBIRD) with Double Tunnel Junction Contact and Quantum Dot Barrier Infrared Detector (QD-BIRD)

The InAs/GaSb type-II superlattice based complementary barrier infrared detector (CBIRD) has already demonstrated very good performance in long-wavelength infrared (LWIR) detection. In this work, we describe results on a modified CBIRD device that incorporates a double tunnel junction contact designed for robust device and focal plane array processing. The new device also exhibited reduced turn-on voltage. We also report results on the quantum dot barrier infrared detector (QD-BIRD). By incorporating self-assembled InSb quantum dots into the InAsSb absorber of the standard nBn detector structure, the QD-BIRD extend the detector cutoff wavelength from approximately 4.2 micrometers to 6 micrometers, allowing the coverage of the mid-wavelength infrared (MWIR) transmission window. The device has been observed to show infrared response at 225 K.

antimonide↗
NASA NTRS2011

Photoluminescence Study of Long Wavelength Superlattice Infrared Detectors

In this paper, the relation between the photoluminescence (PL) intensity and the PL peak wavelength was studied. A linear decrease of the PL intensity with increasing cut-off wavelength of long wavelength infrared CBIRDs was observed at 77 K and the trend remained unchanged in the temperature range 10 - 77 K. This relation between the PL intensity and the peak wavelength can be favorably used for comparison of the optical quality of samples with different PL peak wavelengths. A strong increase of the width of the PL spectrum in the studied temperature interval was observed, which was attributed to thermal broadening.

superlattice↗
NASA NTRS2011

Superlattice Barrier Infrared Detector Development at the Jet Propulsion Laboratory

We report recent efforts in achieving state-of-the-art performance in type-II superlattice based infrared photodetectors using the barrier infrared detector architecture. We used photoluminescence measurements for evaluating detector material and studied the influence of the material quality on the intensity of the photoluminescence. We performed direct noise measurements of the superlattice detectors and demonstrated that while intrinsic 1/f noise is absent in superlattice heterodiode, side-wall leakage current can become a source of strong frequency-dependent noise. We developed an effective dry etching process for these complex antimonide-based superlattices that enabled us to fabricate single pixel devices as well as large format focal plane arrays. We describe the demonstration of a 1024x1024 pixel long-wavelength infrared focal plane array based the complementary barrier infrared detector (CBIRD) design. An 11.5 micron cutoff focal plane without anti-reflection coating has yielded noise equivalent differential temperature of 53 mK at operating temperature of 80 K, with 300 K background and cold-stop. Imaging results from a recent 10 ?m cutoff focal plane array are also presented.

superlattice↗
NASA NTRS2010

Optical Studies on Antimonide Superlattice Infrared Detector Material

In this study the material quality and optical properties of type II InAs/GaSb superlattices are investigated using transmission and photoluminescence (PL) spectroscopy. The influence of the material quality on the intensity of the luminescence and on the electrical properties of the detectors is studied and a good correlation between the photodetector current-voltage (IV) characteristics and the PL intensity is observed. Studies of the temperature dependence of the PL reveal that Shockley-Read-Hall processes are limiting the minority carrier lifetime in both the mid-IR wavelength and the long-IR wavelength detector material studied. These results demonstrate that PL spectroscopy is a valuable tool for optimization of infrared detectors.

heterostructure↗