Engineering topics

Holland, C.

Publications and source records attributed to Holland, C..

8 records

DOE OSTI2024

Prediction of performance and turbulence in ITER burning plasmas via nonlinear gyrokinetic profile prediction

Burning plasma performance, transport, and the effect of hydrogen isotope (H, D, D-T fuel mix) on confinement has been predicted for ITER baseline scenario (IBS) conditions using nonlinear gyrokinetic profile predictions. Accelerated by surrogate modeling (Rodriguez-Fernandez et al 2022 Nucl. Fusion 62 076036), high fidelity, nonlinear gyrokinetic simulations performed with the CGYRO code (Candy et al 2016 J. Comput. Phys. 324 73), were used to predict profiles of T i , T e , and n e while including the effects of alpha heating, auxiliary power (NBI + ECH), collisional energy exchange, and radiation losses inside of $r/a$ = 0.9. Predicted profiles and resulting energy confinement are found to produce fusion power and gain that are approximately consistent with mission goals ($P_\textrm{fusion} = 500$ MW at Q = 10) for the baseline scenario and exhibit energy confinement that is within 1σ of the H-mode energy confinement scaling. The power of the surrogate modeling technique is demonstrated through the prediction of alternative ITER scenarios with reduced computational cost. These scenarios include conditions with maximized fusion gain and an investigation of potential resonant magnetic perturbation (RMP) effects on performance with a minimal number of gyrokinetic profile iterations required (3–6). These predictions highlight the stiff ITG nature of the core turbulence predicted in the ITER baseline and demonstrate that $Q \gt$ 17 conditions may be accessible by reducing auxiliary input power while operating in IBS conditions. Prediction of full kinetic profiles allowed for the projection of hydrogen isotope effects around ITER baseline conditions. The gyrokinetic fuel ion species was varied from H, D, and 50/50 D-T and kinetic profiles were predicted. Results indicate that a weak or negligible isotope effect will be observed to arise from core turbulence in IBS conditions. The resulting energy confinement, turbulence, and density peaking, and the implications for ITER operations will be discussed.

gyrokinetics↗

DOE OSTI2024

Successful prediction of tokamak transport in the L-mode regime

A long standing shortfall in the predicted L-mode edge energy transport by reduced quasi-linear models of gyrokinetic turbulent transport has been resolved. The improved model TGLF-SAT2 has higher fidelity to gyrokinetic simulations of the electron-scale contribution to the electron energy transport and the ion-scale flux surface shape dependence of energy transport. The success of TGLF-SAT2 in predicting the L-mode and Ohmic edge profiles is critical to whole pulse simulation and opens the door to prediction of the H-mode power threshold.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2024

Gyrokinetic simulation of pedestal degradation correlated with enhanced magnetic turbulence in a DIII-D ELMy H-mode discharge

Gyrokinetic simulation of a dedicated pedestal density ramping-up discharge on DIII-D can reproduce the enhancement of magnetic turbulence in the pedestal, which is identified to be caused by micro-tearing modes (MTMs). Here, an increase of MTM amplitude results in higher electron thermal diffusivity, consistent with experimentally observed lower electron temperature gradient and degraded pedestal height. Gyrokinetic simulation identifies the major cause of MTM enhancement to be the increase of collisionality, which has a significant impact on the MTM intensity and is beyond the description of any (quasi-)linear theory.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2023

Experimental Validation of a Kinetic Ballooning Mode in High-Performance High-Bootstrap Current Fraction Fusion Plasmas

We report the observation of a set of coherent high frequency electromagnetic fluctuations that leads to a turbulence induced self-regulating phenomenon in the DIII-D high bootstrap current fraction plasma. The fluctuations have frequency of 130~220kHz, the poloidal wave length and phase velocity are 16~30 m -1 and ~30 km/s, respectively in the outboard midplane with the estimated toroidal mode number n~5- 9. The fluctuations are located in the internal transport barrier (ITB) region at large radius and are experimentally validated to be kinetic ballooning modes (KBM). Furthermore, quasilinear estimation predicts the KBM to be able to drive experimental particle flux and non-negligible thermal flux, suggesting its significant role in regulating the ITB saturation.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2022

Examination of stiff ion temperature gradient mode physics in simulations of DIII-D H-mode transport

A systematic evaluation of gyrokinetic and gyrofluid model predictions of ion temperature gradient (ITG) stability and transport using parameters from DIII-D high confinement mode (H-mode) plasmas has been performed. The nonlinear CGYRO code is used to make the gyrokinetic predictions, and the quasilinear TGLF model for the corresponding gyrofluid predictions. The assessments are made at three radii (normalized toroidal flux ρtor = 0.4, 0.55, and 0.7) in three different plasma scenarios with varying levels of neutral beam heating and torque. For each of the nine cases (3 radii × 3 scenarios) considered, ITG turbulence is found to be the dominant long-wavelength instability and transport mechanism. The inclusions of both transverse magnetic fluctuations and dynamic fast beam ions are stabilizing for all cases considered, with strongest effects seen at ρor = 0.4 where the fast ion population and normalized plasma pressure β = 2μ0nT/B2 are highest. The further inclusion of parallel magnetic fluctuations does not have a meaningful impact on the ITG turbulence in these scenarios, but does destabilize (in combination with fast ions) new high-frequency instabilities at ρtor = 0.4 in the high power scenarios. In each case the linear and nonlinear ITG critical gradients are predicted to be lower than the measured ITG scale lengths and their associated uncertainties. Inclusion of equilibrium flow shear in the transport predictions generally leads to an upshift in effective critical gradient rather than a qualitative change in the predicted stiffness, with stronger responses typically seen in the gyrokinetic predictions than in the gyrofluid results. However, in most cases these upshifted gradients still remain below the measured values and their uncertainties. Although the predicted critical gradients are below the measured gradients, both models predicted flux-matching gradients consistent with measured values in six of the nine cases considered, with no clear systematic over- or underprediction. Thus, while the experimental ion temperature profiles do not appear to be closely pinned to the ITG critical gradient, both gyrokinetic and gyrofluid models are able to accurately match the measured gradients reasonably well in most cases.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2022

The role of toroidal rotation in the very high energy confinement quality observed in super H-mode experiments on DIII-D

In this paper, we report the key role that toroidal rotation and the related ExB shear physics played in the very high energy confinement quality (H98y2>1.5) of super H-mode experiments on DIII-D. Experiments show that the energy confinement quality decreases when toroidal rotation decreases due to the decreased externally controlled torque per particle. Meanwhile, the total pedestal pressure in the experiments remains very high during the rotation and confinement quality change. TGYRO transport modeling suggests the contribution from rotation in the ExB shear is responsible for the confinement quality in excess of standard H-mode (H98y2~1). CGYRO gyrokinetic simulations reveal the governing physics in the core plasma of super H-modes: significant up-shift of nonlinear the ITG critical gradient is observed when applying ExB shear physics in the modeling based on experimental data. The effects of other physical parameters and contribution from pedestal height, which may play minor roles in this study, are also discussed.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2022

Interpreting radial correlation Doppler reflectometry using gyrokinetic simulations

A linear response, local model for the DBS amplitude applied to gyrokinetic simulations shows that radial correlation Doppler reflectometry measurements (RCDR, Schirmer et al 2007 Plasma Phys. Control. Fusion 49 1019) are not sensitive to the average turbulence radial correlation length, but to a correlation length that depends on the binormal wavenumber $k_{\perp}$ selected by the Doppler backscattering (DBS) signal. Nonlinear gyrokinetic simulations show that the turbulence naturally exhibits a nonseparable power law spectrum in wavenumber space, leading to a power law dependence of the radial correlation length with binormal wavenumber $l_r \sim C k_{\perp}^{-\alpha} (\alpha \approx 1)$ which agrees with the inverse proportionality relationship between the measured $l_r$ and $k_{\perp} $ observed in experiments (Fernández-Marina et al 2014 Nucl. Fusion 54 072001). This new insight indicates that RCDR characterizes the eddy aspect ratio in the perpendicular plane to the magnetic field. It also motivates future use of a nonseparable turbulent spectrum to quantitatively interpret RCDR and potentially other turbulence diagnostics. The radial correlation length is only measurable when the radial resolution at the cutoff location $W_\text n$ satisfies $W_\text n \ll l_r$, while the measurement becomes dominated by $W_\text n$ for $W_\text n \gg l_r$. This suggests that $l_r$ is likely to be inaccessible for electron-scale DBS measurements (${k_{\perp}}{\rho_{\text s}} \gt 1$). The effect of $W_\text n$ on ion-scale radial correlation lengths could be nonnegligible.

radial correlation Doppler reflectometry↗

NASA NTRS1985

Thermionic noise measurements for on-line dispenser cathode diagnostics for linear beam microwave tubes

A test stand has been set up to measure the current fluctuation noise properties of B- and M-type dispenser cathodes in a typical TWT gun structure. Noise techniques were used to determine the work function distribution on the cathode surfaces. Significant differences between the B and M types and significant changes in the work function distribution during activation and life are found. In turn, knowledge of the expected work function can be used to accurately determine the cathode-operating temperatures in a TWT structure. Noise measurements also demonstrate more sensitivity to space charge effects than the Miram method. Full automation of the measurements and computations is now required to speed up data acquisition and reduction. The complete set of equations for the space charge limited diode were programmed so that given four of the five measurable variables (J, J sub O, T, D, and V) the fifth could be computed. Using this program, we estimated that an rms fluctuation in the diode spacing d in the frequency range of 145 Hz about 20 kHz of only about 10 to the -5 power A would account for the observed noise in a space charge limited diode with 1 mm spacing.

Holland, C.↗