Search NASA⌕ Search

Engineering topics

Homsy, Sally

Publications and source records attributed to Homsy, Sally.

At least 37 records · Page 2

Systems Analysis for Carbon Dioxide Removal

Presentation at the 2023 Annual Carbon Management Review Meeting covering Strategic Systems Analysis and Engineering work on Carbon Dioxide Removal technologies.

Fout, Timothy↗

Techno Economic Analysis Development for Enhanced Weathering and Marine Carbon Dioxide Removal

Enhanced weathering and marine carbon dioxide removal (CDR) are emerging technologies that can aid in the direct removal of CO2 from the atmosphere. This poster presents on NETL’s active (ongoing) work on the techno-economic analysis (TEA) of enhanced weathering and marine CDR. Financial assumptions will be common with already released Direct Air Capture Case Studies

Leptinsky, Sarah↗

Retrofitting NGCC and PC Power Plants with Carbon Capture Technology

This is a poster that was presented at the 2023 Carbon Management Research Project Review Meeting. The poster highlights primary takeaways from two reports that were recently released by NETL on retrofitting natural gas combined cycle (NGCC) and pulverized coal (PC) power plants with solvent-based carbon capture technology. The poster highlights the performance and cost of retrofitting these plants at 90 and 95% carbon capture, including consideration of cases that attempt to makeup for steam turbine derates caused by extracting steam for use in the capture process. Additionally, the poster highlights NETL's recently released carbon capture retrofit databases (CCRD) for both NGCC and PC plants. The CCRDs are public-facing tools that allow the end-user to approximate the incremental cost of CO2 capture for a user defined plant with retrofitted capture technology.

Hackett, Gregory↗

Environmental Impact of Capture Technology A Review of DOE-Sponsored FEED Studies

The slides were presented at the USEA and FECM organized “Workshop on Measurement, Monitoring and Controlling Potential Environmental Impacts from the Installation of Point Source Capture”. The slides discuss insight regarding the environmental impact of capture system implementation gained from reviewing public FEED reports completed under FOA 2058. The slides were edited to add language requested by DOE and will published on the workshop website.

Homsy, Sally↗

Cost and Performance of Retrofitting NGCC Units for Carbon Capture – Revision 3

This study presents updated cost and performance information on retrofitting natural gas combined cycle (NGCC) power plants with post-combustion carbon capture based on an advanced solvent process, based on NETL's Fossil Energy Baseline, Revision 4A. Cases considered include those using a state-of-the-art F-frame turbine, and H-frame turbines. Cases include both greenfield and retrofit analysis at 90% and 95% carbon capture.

03 NATURAL GAS↗

Cost and Performance Projections for Coal- and Natural Gas-Fired Power Plants

This report provides quantitative estimates of future cost and performance improvements for fossil-fueled power plants equipped with carbon capture developed through the adaption/modification of relevant Aspen Plus ® case study models from published NETL techno-economic analyses. The cost and performance estimates in this report are meant to represent prospective improvements that may be realized for low-carbon-emitting PC and NGCC power plants through robust commercial deployment (e.g., learning by doing) of high TRL technologies as well as additional investments in targeted RD&D activities. The methodology used to develop the estimates in this report is intended to allow direct comparison of the technology improvements with the SOA baseline published in NETL’s Fossil Energy Baseline (Rev 4a) Report.

20 FOSSIL-FUELED POWER PLANTS↗

Eliminating the Derate of Carbon Capture Retrofits (Rev. 2)

This study presents updated cost and performance information on retrofitting pulverized coal (PC) power plants with post-combustion carbon capture based on an advanced solvent process, based on NETL's Fossil Energy Baseline, Revision 4A. Cases considered include those using a fully integrated capture system, a case that provides capture system steam via a natural gas boiler, and a case that provides combined heat and power via a natural gas simple cycle system. Comparison cases include both new build and retrofit analysis at 90% and 95% carbon capture.

20 FOSSIL-FUELED POWER PLANTS↗

Analysis of Carbon Capture Retrofits for Cement Plants

The objective of this study is to provide an estimate of the cost to capture CO 2 in retrofit applications at cement plants. The cement plant configurations considered in this study include natural gas and solid fuel (coal and coke) cases, and both wet- and dry kiln-fed plant designs, however the base cement plants in this study were not evaluated other than characterization of their kiln off-gas stream and high-level quantification of heat integration potential at the existing plant. In each case, the base cement plant produces 1.5 M tonnes per year of finished cement, assuming 91.4 percent clinker content. This analysis includes a 10 percent retrofit cost increase for process integration and low grade heat recovery, when compared to the analogous non-heat integration case. Heat integration is considered as a potential offset to capture system heating demands (i.e., as a percentage reduction). Recovery and reuse of excess heat from the base cement plant can provide economic benefits—primarily by reducing the need to purchase supplemental natural gas for CO 2 solvent regeneration—but any process improvement must be great enough to overcome the cost increases (i.e., capital and O&M) necessary to realize those benefits. With heat integration potential of 10 percent and 30 percent, that benefit wasn’t significant enough to offset the increase in capital and operating costs, and a cost of capture increase was observed based on the assumptions in this report. Benefits of heat integration potential may be realized when natural gas prices are higher, as demonstrated in the sensitivity to natural gas price where crossover points exist between heat integration cases and their respective non-heat integration cases. Four of the base cases were further evaluated to explore the cost implications of deeper levels of gas pre-treatment to remove oxides of nitrogen (NOx) and oxides of sulfur (SOx) from the kiln off-gas stream prior to CO 2 capture, purification, and compression. The results of these additional case analyses showed a 7.4–18.8 percent increase in cost of capture over the respective base case (i.e., analogous cases without SOx/NOx removal).

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Cost of Capturing CO 2 from Industrial Sources

The objective of this study is to provide an estimate of the cost to capture carbon dioxide (CO 2 ) from select industrial processes (ammonia, ethylene oxide, ethanol, natural gas processing, coal-to-liquids, gas-to-liquids, refinery hydrogen, cement, iron/steel, and pulp/paper). Each of the ten processes were chosen for analysis due to either the high purity of the CO 2 emission source (99–100 mole percent CO 2 ) or the large quantity of CO 2 potentially available. For each industrial process considered, available plant information, such as existing average plant size, projected new development plant size, or existing plant operations data was used to develop a reference plant for this study.

20 FOSSIL-FUELED POWER PLANTS↗

Cost and Performance Baseline for Fossil Energy Plants Volume 3: Low Rank Coal and Natural Gas to Electricity

This report presents an independent assessment of the cost and performance of select fossil energy power systems—pulverized coal (PC), circulating fluidized bed (CFB), and natural gas combined cycle (NGCC) plants—using a systematic, transparent technical and economic approach. This is Volume 3 of a five-volume series, which comprise the following reports: Volume 1: Bituminous Coal and Natural Gas to Electricity; Volume 2: Coal to Synthetic Natural Gas and Ammonia (Various Coal Ranks); Volume 3: Low Rank Coal and Natural Gas to Electricity; Volume 4: Bituminous Coal to Liquid Fuels; and Volume 5: Natural Gas Electricity Generating Units for Flexible Operation. The cost and performance of fossil fuel-based generation technologies represented in this report (and the series at large) are important inputs to assessments and determinations of technology combinations to be utilized to meet the projected demands of future power markets. In addition to informing technology comparisons, the reference plant configurations found in this report provide perspective for regulators and policy makers. From a research and development perspective, this report is used to assess goals and metrics and to provide a consistent basis for comparing developing technologies.

20 FOSSIL-FUELED POWER PLANTS↗

NETL's Cost of Capturing CO2 from Industrial Sources and Industrial Carbon Capture Retrofit Database

This presentation was given on behalf of NETL's Strategic Systems Analysis and Engineering Directorate, Energy Process Analysis Team at a United States Energy Association webinar on January 24, 2023. The presentation summarizes techno economic analysis results of nine industrial CO2 capture cases, and also gave an overview and brief demonstration of the industrial sources Carbon Capture Retrofit Database, which is a publicly available tool that estimates capture costs for a subset of the industrial sources appearing in the companion systems analysis report.

Hughes, Sydney↗

Cost and Performance Baseline for Fossil Energy Plants Volume 1: Bituminous Coal and Natural Gas to Electricity

This revised report presents an independent assessment of the cost and performance of select fossil energy power systems—integrated gasification combined cycle (IGCC), pulverized coal (PC), and natural gas combined cycle (NGCC) plants—using a systematic, transparent technical and economic approach. The cost and performance of fossil fuel-based generation technologies represented in this report (and the series at large) are important inputs to assessments and determinations of technology combinations to be utilized to meet the projected demands of future power markets. In addition to informing technology comparisons, the reference plant configurations found in this report provide perspective for regulators and policy makers. From a research and development perspective, this report is used to assess goals and metrics and to provide a consistent basis for comparing developing technologies.

01 COAL, LIGNITE, AND PEAT↗

Direct Air Capture Case Studies

Presentation given by the National Energy Technology Laboratory's Tim Fout at the Carbon Intel Forum, September 2022 on the recent NETL Direct Air Capture Case Study reports.

Fout, Timothy↗

User Guide for the Public Industrial CO2 Capture Retrofit Database Models

OBSOLETE CCRD – SUPERSEDED<p>The National Energy Technology Laboratory (NETL) user manual accompanies the carbon capture retrofit database (CCRD) model that allows users to evaluate the cost of carbon capture on industrial sources (ammonia, cement, ethanol, hydrogen, and natural gas processing). The model was created by the National Energy Technology Laboratory (NETL) based on the technical report titled &quot;Cost of Capturing CO2 from Industrial Sources&quot; (NETL/DOE-2022/3319). Revised 12/21/22.</p>

Hughes, Sydney↗

Industrial CO2 Capture Retrofit Database (IND CCRD)

OBSOLETE CCRD - SUPERSEDED<p>This carbon capture retrofit database (CCRD) model allows users to evaluate the cost of carbon capture on industrial sources (ammonia, cement, ethanol, hydrogen, and natural gas processing). The model was created by the National Energy Technology Laboratory (NETL) based on the technical report titled Cost of Capturing CO2 from Industrial Sources (NETL/DOE-2022/3319). Revised 12/21/22.</p>

Hughes, Sydney↗

Direct Air Capture Case Studies: Solvent System

This case study provides cost and performance estimates for a solvent-based direct air capture (DAC) system at varying scales. The performance of the DAC system is largely based upon vendor performance while the costs of the system were developed as independently as possible. This study is representative of an example DAC system configuration and is not an optimized design.

42 ENGINEERING↗