Search NASA⌕ Search

Engineering topics

Hong, M

Publications and source records attributed to Hong, M.

Effective passivation of In{sub 0.2}Ga{sub 0.8}As by HfO{sub 2} surpassing Al{sub 2}O{sub 3} via in-situ atomic layer deposition

High {kappa} gate dielectrics of HfO{sub 2} and Al{sub 2}O{sub 3} were deposited on molecular beam epitaxy-grown In{sub 0.2}Ga{sub 0.8}As pristine surface using in-situ atomic-layer-deposition (ALD) without any surface treatment or passivation layer. The ALD-HfO{sub 2}/p-In{sub 0.2}Ga{sub 0.8}As interface showed notable reduction in the interfacial density of states (D{sub it}), deduced from quasi-static capacitance-voltage and conductance-voltage (G-V) at room temperature and 100 Degree-Sign C. More significantly, the midgap peak commonly observed in the D{sub it}(E) of ALD-oxides/In{sub 0.2}Ga{sub 0.8}As is now greatly diminished. The midgap D{sub it} value decreases from {>=}15 Multiplication-Sign 10{sup 12} eV{sup -1} cm{sup -2} for ALD-Al{sub 2}O{sub 3} to {approx}2-4 Multiplication-Sign 10{sup 12} eV{sup -1} cm{sup -2} for ALD-HfO{sub 2}. Further, thermal stability at 850 Degree-Sign C was achieved in the HfO{sub 2}/In{sub 0.2}Ga{sub 0.8}As, whereas C-V characteristics of Al{sub 2}O{sub 3}/p-In{sub 0.2}Ga{sub 0.8}As degraded after the high temperature annealing. From in-situ x-ray photoelectron spectra, the AsO{sub x}, which is not the oxidized state from the native oxide, but is an induced state from adsorption of trimethylaluminum and H{sub 2}O, was found at the ALD-Al{sub 2}O{sub 3}/In{sub 0.2}Ga{sub 0.8}As interface, while that was not detected at the ALD-HfO{sub 2}/In{sub 0.2}Ga{sub 0.8}As interface.

36 MATERIALS SCIENCE↗

Realization of high-quality HfO{sub 2} on In{sub 0.53}Ga{sub 0.47}As by in-situ atomic-layer-deposition

High {kappa} dielectric of HfAlO/HfO{sub 2} was an in-situ atomic-layer-deposited directly on molecular beam epitaxy grown In{sub 0.53}Ga{sub 0.47}As surface without using pre-treatments or interfacial passivation layers, where HfAlO (HfO{sub 2}:Al{sub 2}O{sub 3} {approx} 4:1) with high re-crystallization temperature was employed as the top oxide layer. The HfAlO ({approx}4.5 nm)/HfO{sub 2} (0.8 nm)/In{sub 0.53}Ga{sub 0.47}As metal oxide semiconductor capacitors have exhibited an oxide/In{sub 0.53}Ga{sub 0.47}As interface free of arsenic-related defective bonding, thermodynamic stability at 800 deg. C, and low leakage current densities of <10{sup -7} A/cm{sup 2} at {+-}1 MV/cm. The interfacial trap density (D{sub it}) spectra in absence of mid-gap peaks were obtained by temperature-dependent capacitance and conductance with D{sub it}'s of 2-3 x 10{sup 12} eV{sup -1} cm{sup -2} below and 6-12 x 10{sup 11} eV{sup -1} cm{sup -2} above the mid-gap of In{sub 0.53}Ga{sub 0.47}As, respectively. An equivalent oxide thickness of less than 1 nm has been achieved by reducing the HfAlO thickness to {approx}2.7 nm with the same initial HfO{sub 2} thickness of {approx}0.8 nm.

36 MATERIALS SCIENCE↗

Low interfacial trap density and sub-nm equivalent oxide thickness in In{sub 0.53}Ga{sub 0.47}As (001) metal-oxide-semiconductor devices using molecular beam deposited HfO{sub 2}/Al{sub 2}O{sub 3} as gate dielectrics

We investigated the passivation of In{sub 0.53}Ga{sub 0.47}As (001) surface by molecular beam epitaxy techniques. After growth of strained In{sub 0.53}Ga{sub 0.47}As on InP (001) substrate, HfO{sub 2}/Al{sub 2}O{sub 3} high-{kappa} oxide stacks have been deposited in-situ after surface reconstruction engineering. Excellent capacitance-voltage characteristics have been demonstrated along with low gate leakage currents. The interfacial density of states (D{sub it}) of the Al{sub 2}O{sub 3}/In{sub 0.53}Ga{sub 0.47}As interface have been revealed by conductance measurement, indicating a downward D{sub it} profile from the energy close to the valence band (medium 10{sup 12} cm{sup -2}eV{sup -1}) towards that close to the conduction band (10{sup 11} cm{sup -2}eV{sup -1}). The low D{sub it}'s are in good agreement with the high Fermi-level movement efficiency of greater than 80%. Moreover, excellent scalability of the HfO{sub 2} has been demonstrated as evidenced by the good dependence of capacitance oxide thickness on the HfO{sub 2} thickness (dielectric constant of HfO{sub 2}{approx}20) and the remained low D{sub it}'s due to the thin Al{sub 2}O{sub 3} passivation layer. The sample with HfO{sub 2} (3.4 nm)/Al{sub 2}O{sub 3} (1.2 nm) as the gate dielectrics has exhibited an equivalent oxide thickness of {approx}0.93 nm.

36 MATERIALS SCIENCE↗

Direct determination of flat-band voltage for metal/high {kappa} oxide/semiconductor heterointerfaces by electric-field-induced second-harmonic generation

We have employed electric-field-induced second-harmonic (EFISH) generation to determine the flat-band voltage (V{sub FB}) of Cr/ALD-Al{sub 2}O{sub 3}/MBE-HfO{sub 2}/n-Si (001) MOS structure. Due to the phase sensitivity of EFISH signal to the electric field in the space charge region, the V{sub FB} of -1.20{+-}0.07 V was determined by analyzing the relative phase change in the EFISH signal as a function of the applied gate voltage. The obtained value is in good agreement with that estimated by the capacitance-voltage measurement. This study demonstrated an all-optical technique to directly determine the flat-band voltage for the high {kappa} oxide/Si heterointerfaces.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Magnetization reversal processes of epitaxial Fe{sub 3}Si films on GaAs(001)

We report magneto-optical Kerr microscopy study of the magnetic reversal behavior of Fe{sub 3}Si/GaAs(100) epitaxial thin films grown by molecular beam epitaxy. Results are described in the context of superconducting quantum interference device and Kerr effect vector magnetometry to study the magnetic switching behavior. By tuning the Fe concentration of the samples from 75% to 83%, we found that the ratio of uniaxial to cubic anisotropy constants {gamma} (=|K{sub u}/K{sub 1}|) would tremendously vary from 0.06 to 0.3. When the field was applied along the easy axis of Fe{sub 3}Si samples, a step feature was observed in the M-H loops. This feature has been resolved in the domain image by Kerr microscopy, in which we observed a two-switching behavior at the field where the step feature occurred. These can be qualitatively understood by considering the ratio {gamma}.

36 MATERIALS SCIENCE↗

High-resolution core-level photoemission study of CF{sub 4}-treated Gd{sub 2}O{sub 3}(Ga{sub 2}O{sub 3}) gate dielectric on Ge probed by synchrotron radiation

High-resolution core-level photoemission analysis using synchrotron radiation was used to investigate the superior electrical performance of aGa{sub 2}O{sub 3}(Gd{sub 2}O{sub 3}) gate dielectric on Ge(001) after CF{sub 4} treatment. Prior to the treatment, a thin germanate-like oxide layer that formed at the interface prevented Ge from diffusing to the surface. The Ge surface retained a small amount of buckled dimers from the as-grown sample. The buckled dimers were quickly removed by CF{sub 4} plasma treatment followed by an annealing process, resulting in a more uniform interface than that of the as-grown sample. The detailed interfacial electronic structure for the untreated and treated samples are presented.

36 MATERIALS SCIENCE↗

Achieving 1 nm capacitive effective thickness in atomic layer deposited HfO{sub 2} on In{sub 0.53}Ga{sub 0.47}As

A capacitive effective thickness (CET) value of 1.0 nm has been achieved in atomic layer deposited (ALD) high {kappa} dielectrics HfO{sub 2} on In{sub 0.53}Ga{sub 0.47}As/InP. The key is a short air exposure under 10 min between removal of the freshly grown semiconductor epilayers and loading to the ALD reactor. This has led to minimal formation of the interfacial layer thickness, as confirmed using x-ray photoelectron spectroscopy and high-resolution transmission electron microscopy. The measured electrical characteristics of metal-oxide-semiconductor diodes of Au/Ti/HfO{sub 2}(4.5 nm)/In{sub 0.53}Ga{sub 0.47}As showed a low leakage current density of 3.8x10{sup -4} A/cm{sup 2} at V{sub FB}+1 V, which is about eight orders of magnitudes lower than that of SiO{sub 2} with the same CET. The capacitance-voltage curves show an overall {kappa} value of 17-18, a nearly zero flatband shift, and an interfacial density of states D{sub it} of 2x10{sup 12} cm{sup -2} eV{sup -1}.

36 MATERIALS SCIENCE↗

Structural Basis for Dimerization in DNA Recognition by Ga14

Gal4 is a Zn2Cys6 binuclear cluster containing transcription factor that binds DNA as a homodimer and can activate transcription by interacting with the mutant Gal11P protein. Although structures have been reported of the Gal4 dimerization domain and the binuclear cluster domain bound to DNA as a dimer, the structure of the 'complete' Gal4 dimer bound to DNA has not previously been described. Here we report the structure of a complete Gal4 dimer bound to DNA and additional biochemical studies to address the molecular basis for Gal4 dimerization in DNA binding. We find that Gal4 dimerization on DNA is mediated by an intertwined helical bundle that deviates significantly from the solution NMR structure of the free dimerization domain. Associated biochemical studies show that the dimerization domain of Gal4 is important for DNA binding and protein thermostability. We also map the interaction surface of the Gal4 dimerization domain with Gal11P.

59 BASIC BIOLOGICAL SCIENCES↗